SEAT BELTS NOT FASTENED/
UNFASTENED WARNING LAMPS
FUNCTIONING OF THE SYSTEM OF DETECTION
2
3
Driver's and front passenger's seats
When you switch on the ignition:
II
If the driver's seat belt is not fastened, the warning lamp 1 illuminates in
the instrument panel.
If the passenger's seat belt is not fastened, the warning lamp 3 lights up.
Above 20 km/h (12 mph), the warning lamp flashes for non-fastening/unfas-
tening, accompanied by a message and a sound signal for around 2 minutes.
Then the warning lamp(s) 1 and/or 3 remain on.
Rear passenger's seats
When you switch on the ignition, warning lamp 2 lights up to make the driver
and any passengers aware.
OPERATION
Once the doors are closed and the engine started, a message tells you the
fastening status of the rear belts for 30 seconds.
After this time, if one or more of the rear belts are not fastened:
The driver's and the front and rear
passengers' seats have sensors
that detect non-fastening/unfas-
tening of the seat belts.
The fastened/non-fastened status
of the seat belts for each type of
seat is indicated by the illumination
or flashing of the warning lamps 1
2 and 3
Warning lamp 2 comes on, if your speed is less than around 20 km/h
(12 mph).
Warning lamp 2 flashes, accompanied by a message and a sound signal
for about two minutes, if your speed is above around 20 km/h (12 mph).
Note:
The detection of non-fastening of rear seat belts is deactivated when
you switch off the ignition or if one of the vehicle's doors is opened.
A child seat installed on the front passenger's seat may not be
detected.
1
The driver, after he has closed the doors and started the engine, must
make sure that the passengers:
Have all fastened their seat belts
Are using the seat belts correctly
61
English 