Get DRIVING -> Trip computer Guide for Citroen C6 4 Door Second Generation (2016-2023)

TRIP COMPUTER

II

The trip computer gives you access to:

•

OPERATION

Three types of instantaneous information:

For selection and display of the

various types of information, give

short presses on the end of the

windcsreen wiper stalk.

-

Range.

Instantaneous consumption.

Distance remaining to be travelled.

Press on the "TRIP" button on the

radio panel, for permanent display

of the trip computer information.

To reset the trip computer infor-

mation to zero, keep the end of

the control stalk pressed for a few

seconds when you see the relevant

information displayed.

•

Three types of information for two Journeys 1 and 2:

-

The distance travelled.

Average consumption.

Average speed.

The Journeys

Journeys 1 and 2 are independent of each other but identical in use.

For example you can allocate Journey 1 to daily calculations and

Journey 2 to monthly calculations.

Resetting a Journey to zero

When the desired Journey is displayed, give a long press on the end

of the wiper control stalk.

Information concerning your vehicle:

•

-

The oil temperature (for NaviDrive display only).

The coolant temperature.

The tyre pressures.

44

TRIP COMPUTER

NaviDrive colour display

Colour screen C

II

Range

This is the distance that can still be travelled on the

amount of fuel remaining in the tank. When the dis-

tance that can still be travelled is less than around

30 km (or 18 miles), only four dashes are displayed.

Instantaneous consumption

This is the result from the consumption recorded within

the last 2 seconds. This function will only display

above 30 km/h (18 mph).

Distance to be travelled

To enter it, see "Multifunction displays".

Distance travelled

This is the distance that has been travelled since the

last reset to zero of the Journey selected.

Average consumption

This is the relationship between the fuel consumed

and the distance travelled since the last reset to zero

of the trip computer.

Average speed

This is obtained, from the last reset to zero of the trip

computer, by dividing the distance travelled by the time

taken (with ignition switched on).

45

TRIP COMPUTER

OIL TEMPERATURE (NAVIDRIVE COLOUR DISPLAY)

II

This gauge informs you of the temperature of the oil in your

engine.

If the temperature is too high, the gauge indicates the maximum

level and the last, red bar ﬂashes.

Contact a CITROËN dealer or a qualiﬁed workshop.

COOLANT TEMPERATURE

NaviDrive colour display

Colour screen C

This gauge informs you of the temperature of the

coolant ﬂuid in your engine.

If the temperature is excessive, the gauge indicates

a maximum level, the "STOP" warning lamp comes

on in the instrument panel as well as on the Head-

Up display.

Stop as soon as it is safe to do so and contact a

CITROËN dealer or a qualiﬁed workshop.

46

TRIP COMPUTER

TYRE DEFLATION DETECTION

This function warns you of tyres that are deﬂated or punctured, by means of sensors that continuously monitor the

status of the vehicle's wheels, giving you this information on the screen (press the end of the wiper control stalk or on

the "TRIP" button for a permanent display).

II

NaviDrive colour display

Colour screen C

Display of tyres in good condition

Status from the sensors in the course

of initialisation

47

TRIP COMPUTER

Tyre deﬂation alert

The SERVICE warning lamp comes on and a vehicle outline is displayed.

II

The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be ﬂashing.

Check the tyre pressures as soon as possible.

NaviDrive colour display

Colour screen C

Tyre very deﬂated

Tyre deﬂated

Puncture

The "STOP" and tyre(s) punctured warning lamps light up, and a vehicle outline is displayed. The location of the

wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be ﬂashing.

NaviDrive colour display

Colour screen C

Stop immediately, avoiding any sudden actions with the steering wheel or the brakes.

Change the wheel with the affected tyre (whether punctured or very deﬂated), then have the tyre repaired and

all the pressures checked at the earliest opportunity.

The wheel with a damaged tyre (either in the boot or under repair) can no longer be detected (information

given by the vehicle outline or by a message) nor is the spare wheel able to be detected.

48

TRIP COMPUTER

Wheel not detected

The SERVICE warning lamp comes on and a vehicle outline is displayed.

II

The wheel(s) concerned can be identiﬁed from the vehicle outline, on which it (they) will be missing. If you have not

changed a wheel, such information indicates that the system is malfunctioning.

Contact a CITROËN dealer or a qualiﬁed workshop for the replacement of the faulty sensor(s).

NaviDrive colour display

Colour screen C

The deﬂation detection system is a driving aid, but which does not absolve the driver from the need to be vigilant and

responsible.

This system does not remove the need to check the tyres on a regular basis (see "Vehicle identiﬁcation"), to make

sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.

Do not forget to check the pressure in the spare wheel.

All repairs or replacement of tyres on wheels ﬁtted with sensors must be done by a CITROËN dealer

or a qualiﬁed workshop.

The system may suffer from temporary interference caused by radio transmissions on neighbouring

frequencies.

49

DRIVING -> Trip computer for Your Citroen C6 4 Door Second Generation (2016-2023)

Related Topics

DRIVING

Popular Owner Manuals

Latest Owner Manuals