Steering mounted controls
Good practice
When changing the programmed
reference speed by means of a
maintained press, pay attention as
the speed can increase or decrease
rapidly.
Do not use the cruise control on
slippery roads or in heavy traffic.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed.
In any event, the cruise control cannot
replace the need to observe the speed
limits, nor can it replace the need for
vigilance and responsibility on the part
of the driver.
You are advised to keep your feet near
the pedals.
Changing the
programmed speed
Switching the function off
-
Place the dial in position 0 or switch
off the ignition to switch everything
off.
There are two methods
of memorising a
speed higher than the
previous one:
Cancelling the programmed
reference speed
Without using the accelerator:
press the Set + button.
A brief press increases the speed by
1 mph (km/h).
A maintained press increases the
speed in steps of 5 mph (km/h).
When the vehicle becomes stationary,
after switching off the ignition, the
system no longer memorises a speed.
-
To avoid any jamming under the
pedals:
-
ensure that the mat and its fixings
on the floor are positioned correctly,
Using the accelerator:
-
-
never place one mat on top of
another
exceed the memorised speed until
the speed required is reached,
press the Set + or Set - button.
-
Operating fault
To memorise a speed lower than the
previous one:
press the Set - button.
A brief press decreases the speed by
1 mph (km/h).
The programmed speed is cleared and
the dashes flash for a few seconds.
Consult a CITROËN dealer to have the
system checked.
-
A maintained press decreases the
speed in steps of 5 mph (km/h).
English 
