Steering wheel controls
Exceeding the programmed
speed
Switching the function off
Operating fault
-
Place the dial in position 0 or switch The programmed speed is cleared and
off the ignition to switch the system
off. The last programmed speed
remains in the memory.
the dashes flash for a few seconds.
Contact a CITROËN dealer to have the
system checked.
Pressing the accelerator pedal in order
to exceed the programmed speed
will have no effect unless you press
the pedal firmly beyond the point of
resistance.
The limiter is deactivated temporarily
and the programmed speed flashes.
To return to the limiter function, reduce
your speed to below the programmed
speed.
Good practice
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance
and responsibility on the part of the driver.
Always pay attention to the profile of the
road, take care on sharp acceleration and
stay in complete control of your vehicle.
Flashing of the speed
The speed flashes:
-
following forcing of the accelerator
point of resistance,
-
when the limiter cannot prevent an
increase in the vehicle speed due
to the profile of the road or on a
steep descent,
To avoid any jamming under the
pedals:
-
ensure that the mat and its fixings
positioned correctly,
-
in the event of sharp acceleration.
-
never place one mat on top of
another.
English 
