Seats
3 - Seat back angle adjustment
Tilt the control to the front or the rear to
obtain the angle required.
5 - Head restraint height and angle
adjustment (manual)
To raise or lower the head restraint,
pull it forwards, then slide it.
6 - Rotating of seats (mechanical)
Place the seat back in the upright
position.
Place the seat in the highest
intermediate longitudinal position.
On the driver's side, push the steering
wheel, apply the handbrake. To
allow rotation of the seat, lower the
handbrake handle pulling on the end.
The setting is correct when the upper
edge of the head restraint is level with
the top of the head.
The electrical functions of the seats
are cancelled one minute after the
ignition has been switched off.
Pull the control upwards and rotate the
seat inwards.
To remove the head restraint, place it
in the high position, lift the tab using a
coin and pull upwards and forwards at
the same time.
To re-install, engage the head restraint
rods in the holes, making sure they are
aligned with the seat back.
For further information regarding
the disengaging of the handbrake,
refer to the "Driving safety" section
of chapter 4.
Never drive with the head
restraints removed; they must be
in place and correctly adjusted.
This rotating operation must
be carried out with the engine
switched off. The handbrake,
the lever of which is now in the lower
position, remains applied. Do not forget
to raise the lever and release the brake
before setting off.
Driving with a passenger seated facing
the rear is prohibited.
4 - Driver's seat lumbar adjustment
(mechanical)
Raise or lower the lever to obtain the
correct position.
English 
