Advertisement

Advertisement

Safety -> Braking assistance systems for Your Citroen Relay Van 2014-2024

Loading assistance  
return to the nominal floor height  
Operating fault  
Press the same number of times in reverse  
as the level of the position displayed.  
If a fault occurs with the system,  
this warning lamp comes on.  
deactivation  
Have the system checked by a  
CITROËN dealer or a qualified workshop.  
Make a long press on both controls  
simultaneously to deactivate the system.  
The LEDs remain on.  
reactivation  
Good practice  
A second long press on both controls  
simultaneously reactivates the system. The  
LEDs go off.  
Driving with the suspension set too high or  
too low risks damaging components under  
the body.  
The height may be adjusted automatically to  
take account of changes of temperature or  
loading.  
Above 3 mph (5 km/h), the system  
reactivates automatically.  
You must avoid using this control in the  
following circumstances:  
-
-
-
when working underneath the vehicle,  
when changing a wheel,  
Automatic correction of loading  
floor height  
when the vehicle is being transported by  
lorry, train, ferry, boat, ...  
Above 12 mph (20 km/h), the system  
automatically returns the rear height to its  
nominal value.  
To avoid damaging the vehicle or injuring  
anyone, check that there is nothing or no  
person that might be close to or come into  
contact with the vehicle, before raising or  
lowering the suspension.  
4
Driving safely  
PArKInG BrAKE  
HAzArd WArnInG LAMPS  
Press this button, the direction indicators  
flash.  
Pull on the parking brake lever, only  
with the vehicle stationary.  
Applying  
Pull the parking brake lever up to immobilise  
your vehicle.  
They can operate with the ignition off.  
In the exceptional case of use of the  
parking brake when the vehicle is  
moving, apply the brake by pulling gently  
to avoid locking the rear wheels (risk of  
skidding).  
The hazard warning lamps should only  
be used in dangerous situations, when  
stopping in an emergency or when  
driving in unusual conditions.  
Check that the parking brake is applied  
firmly before leaving the vehicle.  
If the parking brake is still on or has not  
been released properly, this is indicated  
by this warning lamp which comes on in  
the instrument panel.  
releasing  
Pull the lever up slightly and press the  
button to lower the parking brake lever.  
When parking on a slope, direct your wheels towards  
the pavement and pull the parking brake lever up.  
There is no advantage in engaging a gear after  
parking the vehicle, particularly if the vehicle is  
loaded.