2002-2008 Cupra Born SUV Checking and refilling levels -> 12-volt battery User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Checking and refilling levels -> 12-volt battery for Your Cupra Born SUV First Generation (2002-2008)

12-volt battery
The battery must not be opened! Never try to  
change the ꢁuid level of the battery. Otherwise  
explosive gas is released from the battery that  
could cause an explosion.  
NOTICE  
NOTICE  
●
If the water from the windscreen washer  
does not contain enough anti-freeze, it may  
freeze on the windscreen and rear window,  
reducing forward and rear visibility.  
Do not mix cleaning products recommen-  
ded by CUPRA with other products. This  
could lead to ꢁocculation and may block the  
windscreen washer jets.  
Battery warning indications  
●
When topping up service ꢁuids, make ab-  
●
In winter, ensure the windscreen washer  
contains enough anti-freeze.  
Wear protective goggles.  
solutely certain that you ꢀll the ꢁuids into  
the correct reservoirs. Using the wrong ꢁuids  
could cause serious malfunctions.  
●
In cold conditions, you should not use the  
Battery acid is extremely corrosive. Wear  
protective gloves and eye protection.  
Rinse any splashes of electrolyte with  
plenty of water.  
windscreen wiper system unless you have  
warmed the windscreen with the ventilation  
system. The antifreeze could freeze on the  
windscreen and reduce visibility.  
●
Lack of window washer ꢁuid causes the  
view through the windscreen to be obscured.  
Fires, sparks, open ꢁames and smoking  
are prohibited.  
12-volt battery  
NOTICE  
The battery should only be charged in a  
well-ventilated zone. Risk of explosion!  
Never mix an unsuitable antifreeze or other  
similar additives with the windscreen washer  
water. A greasy layer may be formed on the  
windscreen which will impair visibility.  
Introduction  
Keep children away from acid and the bat-  
tery.  
The 12 volt battery is located in the front com-  
partment, under the bonnet. It is part of the  
electrical system and, in the event of a fail-  
ure of the high-voltage battery, it ensures that  
power is supplied to vehicle systems of rele-  
vance to safety. The 12 volt battery is checked  
and, if necessary, replaced as part of mainte-  
nance work.  
●
Use clean water with a window cleaner rec-  
Always follow the instruction manual.  
ommended by CUPRA.  
●
If necessary, add a suitable antifreeze to  
the water in the reservoir.  
WARNING  
Working on the 12-volt battery and electrical  
system can cause severe burns, ꢀre and elec-  
tric shock. Always read and observe the fol-  
lowing warnings and safety precautions be-  
fore working on the battery:  
All work on batteries requires specialist knowl-  
edge. Please refer to a specialised CUPRA  
Service, SEAT Oꢀicial Service or a workshop  
specialising in batteries: risk of burns or ex-  
ploding battery!  
●
Before working on the 12-volt battery,  
switch oꢂ the ignition and all electrical con-  
sumers and disconnect the negative cable  
from this battery.  
291  
Checking and reꢀlling levels  
NOTICE  
Charging, replacing, disconnecting  
and connecting the 12-volt battery  
●
Always keep children away from the 12-volt  
battery electrolyte and the battery itself.  
If the vehicle is not to be used for a long pe-  
riod of time, protect the 12-volt battery from  
frost.  
●
Always wear eye protection and protective  
If you suspect that the 12-volt battery is dam-  
aged or defective, have it checked by a quali-  
ꢂed specialist workshop.  
gloves.  
●
The battery electrolyte is very corrosive It  
●
The battery may freeze and, as a result,  
suꢂer irreparable damage.  
can cause skin burns and blindness. When  
handling the 12-volt battery, protect your  
hands, arms and face in particular from acid  
splashes  
Charging the 12-volt battery  
Note  
Contact a specialist workshop for charging the  
12-volt battery, as the battery model ꢂtted in  
the vehicle in the factory uses a technology  
●
Do not smoke while working and never  
After switching on the drive system with a  
deeply discharged or newly replaced 12-volt  
battery, or after a jump start, some system  
settings (time, date, personalised comfort  
settings and programs) may be incorrectly  
set or deleted. Check and correct these set-  
tings when the battery is suꢂiciently charged.  
work in the vicinity of naked ꢁames or sparks.  
●
Avoid sparks caused by electrostatic dis-  
that requires limited voltage charging ›››  
.
charges, just like when handling electric ca-  
bles and devices.  
To do so, CUPRA recommends going to a spe-  
cialised CUPRA dealer or any SEAT dealership.  
●
●
Never short the battery terminals.  
Replacing the 12-volt battery  
Never use damaged 12-volt batteries. They  
could explode. If the 12-volt battery is dam-  
aged, replace it immediately.  
The 12-volt vehicle battery has been designed  
to suit its location and has special safety fea-  
tures. If a 12 volt battery needs to be replaced,  
the replacement battery must be installed by  
a qualiꢂed technician. CUPRA recommends  
that you visit a CUPRA dealer. Component in-  
formation regarding size, maintenance, power  
and safety characteristics to be met can be ob-  
tained from a qualiꢂed technician, who should  
have the necessary documentation and tech-  
nical equipment. CUPRA recommends visiting  
a specialised CUPRA dealer or any SEAT deal-  
ership.  
Check the electrolyte level  
●
Never use a frozen 12 volt battery. When  
the battery is discharged, it may freeze at  
temperatures close to 0°C (+32 °F). If the 12-  
volt battery is frozen, replace it immediately.  
The 12-volt battery is located in the front com-  
partment, under the bonnet.  
The electrolyte level of the 12-volt battery can-  
not be checked, as the battery sight glass is  
covered by the vehicle's main fuse box.  
NOTICE  
Always have the battery electrolyte level  
checked by a qualiꢂed specialist workshop.  
Do not expose the 12-volt battery to direct  
sunlight for a prolonged period of time.  
●
Ultraviolet rays can damage the battery  
casing.  
The degassing hole of the 12 volt battery must  
always be on side of the negative pole. The  
degassing hole on the side of the positive pole  
must always be sealed.  
292  
12-volt battery
Only use maintenance-free 12 volt batteries  
that comply with the TL 825 06 and VW 7 50 73  
standards. These standards must be dated Oc-  
tober 2014 or later.  
After connecting the 12 volt battery and  
switching on the ignition, several control lamps  
may light up. These lamps go out after a short  
distance at a speed of approx. 15 to 20 km/h  
(10 to 12 mph). If the warning lights do not go  
out, visit a specialist workshop and have the  
vehicle checked.  
is left parked with the ignition or the side- or  
parking light switched on for a long period of  
time.  
Factors causing the 12-volt battery to dis-  
charge  
The 12 volt battery must always be replaced  
by a qualiꢂed technician, as the vehicle's elec-  
tronic system must also be adjusted as part  
of the replacement. In addition, the battery  
parameters relating to operational safety can  
only be determined with the original battery.  
Only a qualiꢂed technician has both the right  
technology to make the adjustment and the  
correct replacement batteries.  
●
Use of electric consumers while the drive  
If the 12-volt battery has been disconnected  
for a long period of time, it is likely that the  
next service is not correctly indicated or cal-  
culated ››› page 21 . In this case it will be  
necessary to take into account the maximum  
maintenance intervals allowed ››› page 311.  
system is disconnected.  
WARNING  
Attaching the 12-volt battery incorrectly or  
using unsuitable batteries may result in short  
circuits, ꢀre and serious injury.  
The use of unsuitable batteries will invalidate  
the approval.  
Vehicles with a “Keyless Access” system  
●
Use only maintenance-free 12 volt batter-  
››› page 92: If the ignition cannot be switched  
on after connecting the 12 volt battery, lock  
and unlock the vehicle from the outside. Then  
try to switch on the ignition again. If the ignition  
does not work, seek professional assistance.  
ies with an anti-spill system with the same  
properties, speciꢀcations and dimensions as  
the factory-ꢀtted battery.  
Disconnecting the 12-volt battery  
If the 12 volt battery is to be disconnected from  
the vehicle's electrical system, please note the  
following:  
WARNING  
Automatic disconnection of consumers  
●
●
Switch oꢀ all electrical consumers.  
Charging the 12-volt battery creates a highly  
explosive mixture of detonating gases.  
In the event of excessive demand on the  
12 volt battery, the on-board network smart  
management system automatically takes cer-  
tain measures to prevent the battery from dis-  
charging:  
Before disconnecting the battery, unlock the  
vehicle, otherwise the alarm will be triggered.  
●
Only charge the 12-volt battery in a well-  
ventilated place.  
●
First disconnect the negative cable and then  
●
Never charge a 12-volt battery that is fro-  
the positive cable ›››  
.
zen or has thawed. When the battery is dis-  
charged, it may freeze at temperatures close  
to 0°C (+32°F).  
●
If necessary, the power of the most powerful  
Connecting the 12-volt battery  
consumers is limited or, in an emergency, they  
are switched oꢀ completely.  
●
Switch oꢀ all electrical consumers before re-  
●
If the 12-volt battery has frozen, have it re-  
connecting the 12 volt battery.  
placed without fail.  
On-board network management cannot al-  
ways prevent the 12 volt battery from discharg-  
ing. This is the case if, for example, the vehicle  
●
First reconnect the positive cable and then  
the negative one ›››  
.
293  
Checking and reꢀlling levels  
Troubleshooting  
●
●
Contact a specialised workshop.  
●
A short circuit may occur if the wires are  
incorrectly connected to the poles. First con-  
nect the positive cable and then the negative  
one.  
Request a check of the electrical system.  
12 volt battery  
12 volt battery  
The control lamp lights up in RED. The follow-  
ing messages may be displayed:  
The indicator lamp lights up YELLOW. The fol-  
NOTICE  
Error: 12 V battery not charging.  
Stop vehicle safely!  
lowing message is displayed:  
●
Never connect or disconnect the 12-volt  
Error: 12 V battery diagnosis.  
Please visit workshop.  
battery while the drive system is switched on.  
Also, never use a 12-volt battery that does  
not meet the vehicle's battery speciꢀcations.  
The electrical system or certain electronic  
components could be damaged and electri-  
cal malfunctions could occur.  
Error: 12V power supply. Stop  
safely! Manual!  
There is a fault in the 12-volt battery monitor-  
ing system.  
Stop driving! Stop the vehicle at the next  
opportunity and in a safe place. The 12-volt  
battery will not be charged while driving or  
there is a fault in the on-board 12-volt network.  
●
●
Contact a specialised workshop.  
Request a check of the electrical system.  
●
Never connect accessories that supply  
power, such as solar panels or battery charg-  
ers, to the 12-volt socket or cigarette lighter,  
to charge the 12-volt battery. This could  
damage the vehicle's electrical system.  
●
Switch oꢀ any electrical consumers that are  
12 volt battery  
not required.  
The indicator lamp lights up YELLOW. The fol-  
lowing message is displayed:  
●
●
Contact a specialised workshop.  
Request a check of the electrical system.  
12 V battery charge low. Charge  
while driving.  
For the sake of the environment  
12 volt battery  
●
The battery may contain toxic substances,  
The 12-volt battery charges deꢂciently.  
The indicator lamp lights up YELLOW. The fol-  
lowing message is displayed:  
such as sulphuric acid and lead. Dispose of  
the 12 volt battery in accordance with the  
applicable regulations.  
●
Make a short trip to recharge the battery.  
OR:  
Error: 12 V battery. Restart impos-  
sible. Go to the workshop.  
●
Electrolyte can contaminate the environ-  
The diagnosis of the 12 volt battery was cancel-  
led because the vehicle has been restarted, for  
example.  
ment. If any operating ꢁuid leaks out, collect  
it and dispose of it properly.  
There is a fault in the connection between the  
on-board network and the 12-volt battery.  
●
If after parking for a prolonged period of  
If the drive system is switched oꢀ in this situa-  
tion, it cannot be switched on again. If neces-  
sary, use the jump leads ››› page 271 or seek  
assistance from qualiꢂed personnel.  
time (e.g. overnight), the warning lamp is still  
one, go to a specialised workshop and have  
the electrical system checked.  
294  
12-volt battery
12 volt battery  
The indicator lamp lights up YELLOW. The fol-  
lowing message is displayed:  
12 V power supply now limited.  
Drive with caution.  
The 12-volt power supply is limited, maybe be-  
cause the 12 volt battery is discharged or not  
working at full performance, for example due  
to very cold outside temperatures. The 12-volt  
battery can be charged while driving. Until the  
warning disappears, you should drive with care.  
12 volt battery  
The indicator lamp lights up YELLOW. The fol-  
lowing message is displayed:  
Error: 12 V supply. Please visit  
workshop.  
There is a fault in the 12V power supply.  
●
●
Go to a qualiꢂed establishment.  
Have the electrical system checked.  
295  

Related Topics

Popular Owner Manuals