Miscellaneous situations
Before driving, always lower the wiper arms.
When the wiper lever is brieꢀy pulled upwards,
the wiper arms return to their initial position.
If the graphite layer is damaged, the noise of
the water as it is wiped across the windscreen
will be louder.
Changing the windscreen wiper blades
●
●
Lift and unfold the wiper arms.
Press and hold release button ››› Fig. 179
Check the condition of the wiper blades reg-
ularly. If the wipers scrape across the glass,
they should be changed if they are damaged,
1
and pull gently on the wiper blade in the
Note
direction of the arrow.
●
The wiper arms can be moved into the re-
●
Fit a new wiper blade of the same length
or cleaned if they are dirty ›››
.
placement position when the front bonnet is
fully closed.
and design on to the wiper arm and hook it
If this does not produce the desired results,
the setting angle of the windscreen wiper arms
might be incorrect. They should be checked by
a specialised workshop and corrected if neces-
sary.
into place.
●
You can also use the service position, for
●
Rest the wiper arms back onto the wind-
example, if you want to ꢀx a cover over the
windscreen in the winter to keep it clear of
ice.
screen.
Changing the rear window wiper blade
Damaged windscreen wiper blades should
be replaced immediately. These are available
from qualiꢂed workshops.
Changing the wiper rear wiper
blades
Raising and lowering windscreen wiper arms
●
Place the windscreen wipers in the service
position ››› page 269.
●
Grip the wiper arms only by the blade's fas-
tening point.
Cleaning windscreen wiper blades
Fig. 180 Changing the rear wiper blade
●
●
Raise the wiper arms.
●
dow.
Separate the wiper arm from the rear win-
Use a soft cloth to remove dust and dirt from
the windscreen wiper blades.
Fig. 179 Changing the windscreen wiper
blades
●
● Rotate the blade lightly ››› Fig. 180 (arrow
If the blades are very dirty, a sponge or damp
A
).
cloth may be used ›››
.
●
1
Hold down the release button
while gently
The windscreen wiper blades are supplied as
standard with a layer of graphite. This layer is
responsible for ensuring that the wipe is silent.
B
pulling the blade in the direction of arrow
.
270