2002-2008 Cupra Born SUV Miscellaneous situations -> Towing the vehicle User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Miscellaneous situations -> Towing the vehicle for Your Cupra Born SUV First Generation (2002-2008)

Towingthevehicle
If the system does not switch on, seek the as-  
sistance of specialist personnel.  
●
Keep sparks, ꢀames and lighted cigarettes  
Towing the vehicle  
away from batteries, danger of explosion.  
Failure to comply could result in an explo-  
sion.  
Introduction  
Removing the jump leads  
●
Observe the instructions provided by the  
It takes practice to tow a vehicle, especially  
when using a tow cable. Both drivers should be  
well informed of the special features of towing.  
Inexperienced drivers should refrain from tow-  
ing.  
9. Before you remove the jump leads, switch  
oꢀ the dipped beam headlights if they are  
switched on.  
manufacturer of the jump leads.  
●
Do not connect the negative cable from  
the other vehicle directly to the negative ter-  
minal of the ꢀat battery. The gas emitted  
from the battery could be ignited by sparks.  
Danger of explosion.  
10. Only disconnect the jump leads in the or-  
der 4 > 3 > 2 > 1 with the drive system  
switched on and the engine of the vehicle  
supplying the current running, or the elec-  
tric vehicle ignition switched on.  
During towing, make sure at all times that no  
inadmissible traction forces or jolts are gener-  
ated. On roads without a ꢁrm surface there  
is always the danger of overloading the attach-  
ment parts.  
●
Never attach the negative cable to fuel sys-  
tem components or the brake lines in the  
other vehicle.  
11. Close the battery cover if necessary.  
●
If the drive system cannot be switched on, sus-  
pend the process and try again after approx. 1  
minute. If the drive system still does not switch  
on, seek the assistance of qualiꢁed personnel.  
The non-insulated parts of the battery  
Observe the legal provisions regarding towing.  
clamps must not be allowed to touch. The  
jump lead attached to the positive battery  
terminal must not touch metal parts of the  
vehicle, this can cause a short circuit.  
Towing  
Towing means a vehicle pulling another vehicle  
that is not in a condition to run.  
●
Position the jump leads in such a way that  
WARNING  
they cannot come into contact with any ro-  
tating parts in the front compartment.  
The vehicle can be towed with a tow bar or  
cable.  
●
Please note the warnings when working in  
the front compartment ››› page 282.  
●
Do not lean on the batteries. This could re-  
●
The maximum permitted speed is 50 km/h  
sult in chemical burns.  
●
The battery providing assistance must have  
(30 mph).  
the same voltage as the ꢀat battery (12V)  
and approximately the same capacity (see  
imprint on battery). Failure to comply could  
result in an explosion.  
●
Take into account the instruction manual  
●
The maximum permitted distance is 50 km  
of the jump lead manufacturer and the in-  
struction manual of the other vehicle.  
(30 miles).  
●
Never use jump leads when one of the bat-  
Tow cable and tow bar  
NOTICE  
teries is frozen. Danger of explosion! Even  
after the battery has thawed, battery acid  
could leak and cause chemical burns. If a  
battery freezes, it should be replaced.  
It is safer for the vehicle to be towed using a  
tow bar, avoiding damage to the vehicle. The  
tow cable should only be used if a tow bar is  
not available.  
Immediately go to a specialist workshop and  
have the 12 volt battery checked.  
273  
Miscellaneous situations  
WARNING  
A tow rope should be slightly elastic to avoid  
damage to both vehicles. It is advisable to use  
a tow rope made of synthetic ꢁbre or similarly  
elastic material.  
NOTICE  
Never allow the vehicle to be towed if it has  
no power.  
If the vehicle is pushed by hand, the tail light  
units, the side spoilers of the rear window  
and large sheet metal surfaces may be dam-  
aged. In addition, the rear spoiler could be  
detached.  
●
When towing, never switch oꢁ the ignition  
with the ignition/start button. Otherwise, the  
electronic lock of the steering column could  
suddenly get blocked and it would be impos-  
sible to steer the vehicle. This could cause an  
accident, serious injury and loss of control of  
the vehicle.  
Tow with a tow truck  
The vehicle may only be transported on a on a  
tow truck if all four wheels are supported.  
●
If the vehicle is pushed by hand, the tail  
light units, the side spoilers of the rear win-  
dow, large sheet metal surfaces or the rear  
spoiler.  
Activating rolling ››› page 187  
If necessary, to release the parking brake so  
that the vehicle can be pushed or towed:  
●
If the vehicle runs out of power during tow-  
ing, stop the process immediately and seek  
the assistance of specialised personnel.  
NOTICE  
●
Keep the brake pedal pressed down and se-  
Removing and attaching the cover and the  
towing eye may cause damage to the vehicle,  
for example, on the paintwork.  
lect the N position on the gear selector. Next,  
conꢁrm Activate rolling in the Infotainment  
System.  
NOTICE  
Towing the vehicle with a tow cable or a tow  
bar can cause damage to the vehicle.  
●
To avoid damaging the vehicle, remove and  
replace the cover and the towing eye care-  
fully.  
●
OR: open the vehicle settings in the infotain-  
ment system > Assistants > Park assist >  
Brakes and activate the function.  
●
If the vehicle is towed with a tow cable or  
tow bar, special care must be taken.  
●
If possible, have the vehicle transported on  
NOTICE  
a tow truck.  
WARNING  
Using a towing eye that is not suitable for the  
vehicle can damage it.  
During the towing of a vehicle, the driving  
behaviour and braking capacity change con-  
siderably.  
●
When towing, always use the vehicle’s tow-  
ing eye, which forms part of the on-board  
tools, or an appropriate eye for towing.  
Towing instructions  
During towing, the change of direction can be  
signalled on the towed vehicle even when the  
hazard warning lights are on. To do so, at the  
274  
Towingthevehicle
same time, the turn signal lever must be op-  
erated with ignition switched on. During this  
time the hazard warning lights remain discon-  
nected. When the turn signal lever is returned  
to the rest position, the hazard warning lights  
will be automatically reactivated.  
If the vehicle cannot be towed on its wheels for  
any of the reasons mentioned above, request  
assistance from specialised personnel and, if  
necessary, have the vehicle transported with-  
out the wheels touching the ground. Inform  
the people involved in the towing process, es-  
pecially the organising centre and the carrier,  
that it is an electric vehicle.  
Towed vehicle (behind)  
●
Make sure the ignition is switched on so that  
the steering wheel does not lock and so that, if  
necessary, you can use the turn signals and the  
windscreen wiper.  
●
The brake servo and the power steering only  
work with the drive system connected. Other-  
wise, you will have to depress the brake pedal  
considerably harder and more force will be  
needed to turn the steering wheel.  
Cases where the vehicle must never be  
towed  
Towing  
Do not allow the vehicle to be towed for a long  
distance on its wheels in the following situa-  
tions:  
●
●
Make sure the tow cable is always taut.  
Previous steps  
Select the N gear position.  
●
Secure the tow cable or tow bar using only  
●
A red warning light lights up on the instru-  
If the conditions for towing are not met,  
the vehicle can be towed or pushed on all  
four wheels in emergency situations. However,  
towing is only permitted at walking speed  
and a maximum of 100 m to the tow truck  
the attachment points provided for this pur-  
ment cluster screen and a message is dis-  
played:  
pose ››› . Depending on the equipment,  
these points may be a towing device or a tow-  
ing eye.  
Towing damages the electri-  
cal system. Manual!  
●
Make sure the tow cable is not twisted. Oth-  
›››  
.
erwise the towing eye could unscrew during  
towing.  
●
The power supply of the on-board 12-volt  
electrical system cannot be guaranteed.  
WARNING  
●
Switch on the ignition and the hazard warn-  
●
The 12-volt battery is discharged. The steer-  
ing lights of both vehicles. If necessary, take  
into account other diꢀerent provisions that  
may exist in this regard.  
ing remains locked and, if applicable, the park-  
ing brake cannot be released and the elec-  
tronic steering column lock cannot be released  
if they are engaged.  
If, in spite of displaying the message Tow-  
ing damages the electrical sys-  
tem. Manual!on the instrument cluster  
screen, if the vehicle is towed, vibrations can  
occur in the traction system and the rear  
wheels can be locked, especially if the road  
is wet or has ice. Wheel locking can lead to  
loss of control of the vehicle, accidents and  
serious injury.  
●
Take into account the instructions on towing  
provided in the instruction manual of the other  
vehicle.  
●
The indicator on the instrument panel dis-  
play is not working properly.  
●
(N).  
It is not possible to set the gears to neutral  
Towing vehicle (front)  
The vehicle is not suitable for towing other ve-  
hicles.  
●
There is no guarantee that the wheels will  
turn smoothly or that the steering will work af-  
ter an accident.  
275  

Related Topics

Popular Owner Manuals