2002-2008 Cupra Born SUV Miscellaneous situations -> Jump start User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Miscellaneous situations -> Jump start for Your Cupra Born SUV First Generation (2002-2008)

Jumpstart
NOTICE  
●
Insert a new blade of the same length and  
NOTICE  
type in the rear wiper arm in the opposite di-  
rection to the arrow  
into place.  
●
To prevent damage to the bonnet and the  
wiper arms, only fold them when in the serv-  
ice position.  
To avoid considerable damage to the vehi-  
cle electrical system, note the following care-  
fully:  
B
1
until button  
hooks  
●
Fold the wiper arm and rest it on the window.  
●
Before driving, always lower the wiper  
arms.  
●
If the jump leads are connected incor-  
rectly, a short circuit may occur.  
WARNING  
●
Use only jump leads with fully insulated  
clamps.  
Worn or dirty windscreen wiper blades re-  
duce visibility and increase the risk of acci-  
dent and serious injury.  
Jump start  
●
Do not allow the vehicles to come into con-  
tact with each other, otherwise current may  
start to ꢀow as soon as the positive poles are  
connected.  
Introduction  
●
Always replace damaged or worn wind-  
screen wiper blades or blades that no longer  
clean the windscreen properly.  
Due to technical reasons, tow starting the vehi-  
cle is not allowed.  
NOTICE  
If the drive system cannot be switched on be-  
cause the 12 volt battery is discharged, the 12-  
volt battery of another vehicle can be used for  
this purpose.  
NOTICE  
Tow starting can cause damage.  
●
Damaged or dirty windscreen wipers could  
scratch the glass.  
●
If products containing solvents, rough  
Suitable jump leads are required for the jump  
start.  
sponges or sharp objects are used to clean  
the blades, the graphite layer will be dam-  
aged.  
The cross section of jump leads for vehicles  
with electric drive systems must be a minimum  
of 25 mm2.  
●
Never use fuel, nail varnish remover, paint  
thinner or similar products to clean the win-  
dows.  
●
In icy conditions, always check that the  
wiper blades are not frozen to the glass be-  
fore using the wipers. In cold weather, it may  
help to leave the vehicle parked with the wip-  
ers in service position ››› page 269.  
271  
Miscellaneous situations  
Jump start: description  
Never connect the black jump lead to the neg-  
ative pole – of the 12-volt battery. Connecting  
it to the negative pole may cause an incorrect  
assessment of the status of the battery in the  
vehicle's electronic system.  
Jump start socket (ground termi-  
nal)  
1. Switch oꢀ the ignition of both vehicles  
›››  
.
2. Connect one end of the red jump lead to  
+
the positive  
terminal of the vehicle with  
A
the ꢁat 12-volt battery  
.
3. Connect the other end of the red jump  
+
lead to the positive terminal  
in the vehi-  
B
cle providing assistance  
.
Fig. 181 In the front compartment: jump  
start socket (ground terminal).  
4. Connect one end of the black jump lead  
C
to a suitable ground terminal, to a solid  
piece of metal in the engine block, or to  
the motor block itself.  
The jump start socket (ground terminal) is  
used for connecting the black jump lead  
››› Fig. 181.  
Only use this socket (ground terminal) when  
jump starting.  
5. Connect one end of the black jump lead  
Fig. 182 Jump lead connection diagram.  
D
to a suitable ground terminal in the ve-  
hicle with the ꢁat 12 volt battery.  
The discharged battery must be properly con-  
nected to the on-board network.  
6. Position the leads in such a way that they  
cannot come into contact with any rotat-  
ing part in the front compartment.  
Make sure the battery clamps have suꢀicient  
metal-to-metal contact with the battery termi-  
nals.  
Starting  
7. Start the engine of the vehicle supplying  
the current and leave it running at idle, or  
switch on the ignition of the electric vehi-  
cle.  
Jump lead terminal connections  
The jump leads should only be connected in  
the order 1 > 2 > 3 > 4 ››› Fig. 182.  
8. Connect the drive system of the electric  
vehicle with the ꢁat 12 volt battery.  
272  

Related Topics

Popular Owner Manuals