2002-2008 Cupra Born SUV Visibility -> Mirrors User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Visibility -> Mirrors for Your Cupra Born SUV First Generation (2002-2008)

Mirrors
Abnormal operation of the rain and light  
sensor  
Fault in the rain and light sensor  
WARNING  
The control lamp switches on yellow.  
The rain sensor may not detect enough rain  
to switch on the wipers.  
The possible causes of anomalies and errone-  
ous interpretations in the sensitive surface area  
The wiper does not switch on automatically in  
the event of rain, although the rain and light  
sensor is activated.  
●
If necessary, switch on the wipers manually  
when water on the windscreen obstructs visi-  
bility.  
››› Fig. 109 of the rain sensor are, among oth-  
ers:  
●
●
Turn oꢁ the ignition and turn it on again.  
If the fault continues, consult a specialised  
workshop.  
●
Damaged wipers: a ꢀlm of water on the  
damaged blades may lengthen the activation  
time, reduce the washing intervals or result in a  
fast and continuous wipe.  
Note  
●
To remove wax and coatings, we recom-  
mend a window cleaner containing alcohol.  
●
Insects: the impact of insects may cause the  
Mirrors  
●
Do not put stickers on the windscreen in  
wiper to activate.  
front of the rain sensor. This may cause sen-  
sor disruption or faults.  
●
Salt on the road: in winter, salt spread on  
General safety instructions  
the roads may cause an excessively long wipe  
when the windscreen is almost dry.  
The exterior and interior mirrors allow the  
driver to observe vehicles driving behind and  
adapt his or her driving behaviour accordingly.  
●
Dirt: dry dust, wax, coating on glass (Lotus  
Troubleshooting  
eꢁect) or traces of detergent (car wash) may  
reduce the eꢁectiveness of the rain sensor or  
make it react more slowly, later or not at all.  
Regularly clean the sensitive surface of the rain  
sensor ››› Fig. 109 (arrow) and check for pos-  
sible damage to the wiper blades.  
For safe driving, it is important for the driver to  
adjust the exterior mirrors and interior mirror  
correctly before setting oꢁ.  
Washer ꢀuid level too low  
The control lamp switches on yellow. Reꢀll the  
washer ꢂuid reservoir at the next opportunity  
››› page 290.  
When looking through the exterior mirrors and  
the interior mirror, it is not possible to see the  
entire area behind and to the sides of the vehi-  
cle. These areas outside the ꢀeld of view are  
known as the blind spot. Other road users and  
objects may be in the blind spot.  
●
Windscreen crack: the impact of a stone will  
Defective wiper  
trigger a single wipe cycle with the rain sen-  
sor on. Next the rain sensor detects the reduc-  
tion in the sensitive surface area and adapts  
accordingly. The behaviour of the sensor will  
vary with the size of the damage caused by the  
stone.  
The control lamp switches on yellow.  
The wiper does not work.  
●
●
Turn oꢁ the ignition and turn it on again.  
If the fault continues, consult a specialised  
workshop.  
123  
Visibility  
●
If possible, use the interior mirror to pre-  
WARNING  
NOTICE  
cisely calculate the distance to vehicles driv-  
ing behind you, or to other objects.  
Adjusting the exterior mirrors and interior  
mirror while driving can distract the driver.  
This could cause accidents and lead to seri-  
ous injuries  
Electrolyte ꢀuid may leak if the automatic  
anti-dazzle mirror is broken. This liquid at-  
tacks plastic surfaces. Therefore, it should  
be cleaned as fast as possible with a damp  
sponge or similar.  
●
Always make sure you have suꢂicient visi-  
bility to the rear.  
●
Only adjust the exterior mirrors and inte-  
rior mirror when the vehicle is stationary.  
WARNING  
●
When parking, changing lanes, overtaking  
The automatic anti-dazzle mirrors contain an  
electrolyte ꢀuid which could leak if the mir-  
ror is broken.  
Interior mirror  
or turning, always keep a close eye on your  
surroundings, as other road users or objects  
may also be in the blind spot.  
Rear view mirror with automatic anti-dazzle  
function  
●
If it gets out, the electrolyte ꢀuid can  
●
Always make sure that the mirrors are ad-  
irritate the skin, eyes and respiratory or-  
gans, particularly in the case of people with  
asthma or similar diseases. Immediately in-  
hale enough fresh air and get out of the vehi-  
cle, or open all windows and doors if this is  
not possible.  
When the ignition is switched on, the sensors  
in the mirror measure the light falling on it from  
behind and in front.  
justed correctly and that visibility to the rear  
is not reduced by ice, snow, fogging or other  
objects.  
The interior mirror automatically darkens  
based on the measured values.  
WARNING  
●
If the electrolytic ꢀuid comes into contact  
If the light falling onto the sensors is blocked or  
interrupted, e.g. by a sunshade blind or hang-  
ing objects, the automatic anti-dazzle interior  
mirror does not work or does not work prop-  
erly. Similarly, the use of portable navigation  
devices attached to the windscreen or close to  
the automatic anti-dazzle interior mirror can  
A failure to accurately estimate the distance  
to vehicles driving behind can lead to serious  
accidents and injuries.  
with your eyes or skin, immediately rinse the  
aꢂected area with plenty of water for at least  
15 minutes and seek medical advice.  
●
Curved (convex or aspherical) mirrors in-  
●
If the ꢀuid comes into contact with foot-  
crease the ꢁeld of view and objects in them  
appear smaller and further away.  
wear or clothing, rinse immediately with  
plenty of water for at least 15 minutes. Clean  
thoroughly before using the footwear or  
clothing in question again.  
●
Curved mirrors do not allow you to pre-  
aꢁect the operation of the sensors ›››  
The automatic anti-dazzle function is deacti-  
vated in certain situations, e.g. when reverse  
gear is engaged.  
.
cisely calculate the distance to vehicles driv-  
ing behind, so using them when changing  
lanes could cause serious accidents and inju-  
ries.  
●
If the electrolytic ꢀuid is swallowed, imme-  
diately rinse the mouth with plenty of water  
for at least 15 minutes. Do not induce vomit-  
ing unless advised by a doctor. Immediately  
seek medical attention.  
124  
Mirrors
●
/
Moving the control to the desired position  
adjusts the mirrors on the driver's side ( ,  
left) and on the passenger's side ( , right)  
in the desired direction.  
If necessary, correct the setting of the right  
WARNING  
1)  
hand mirror: turn the control to position  
.
Light from screens of portable navigation  
devices can cause malfunctions of the au-  
tomatic anti-dazzle interior mirror and may  
cause serious accidents and injuries.  
Fold the rearview mirrors when locking the  
vehicle  
The exterior mirror heating turns on. The  
heating only works when the ambient  
temperature is below +20°C (+68°F), and  
initially at full power. After approx. 2 mi-  
nutes, its heat depends on the ambient  
temperature.  
●
When the vehicle is locked or unlocked from  
the outside, the exterior mirrors can be fol-  
ded in or out automatically, depending on the  
equipment. For this purpose, the rotary control  
Abnormal operation of the automatic anti-  
dazzle function may result in it being impos-  
sible to use the interior mirror to precisely  
calculate the distance to vehicles driving be-  
hind, or to other objects.  
has to be in position  
,
,
, or  
.
Folding the mirrors ›››  
.
If the rotary control of the electric exterior mir-  
rors is in the folded position, the exterior mir-  
rors remain folded.  
Adjusting the exterior mirrors  
The exterior mirror cannot be adjusted  
and all functions are deactivated.  
Saving and activating the passenger side ex-  
terior mirror setting for reversing  
Activating exterior mirror functions  
The following exterior mirror functions can  
be activated and deactivated in the vehicle  
settings menu of the infotainment system  
››› page 35.  
●
Unlock the vehicle with the key to which you  
wish to assign the setting.  
●
●
Select reverse gear.  
Adjust the front passenger exterior mirror so  
that you can see, for example, the kerb edge  
well.  
Synchronized regulation of the exterior mir-  
rors  
●
●
●
Move the gearshift to the neutral position.  
Switch the ignition oꢁ.  
Fig. 110 Detail of the driver door: control  
for the exterior mirror.  
The synchronised mirror setting simultane-  
ously adjusts the right hand exterior mirror  
when the left mirror is adjusted  
The mirror's set position is saved and as-  
Turn the control to the corresponding posi-  
tion. The symbol lights up:  
signed to the key.  
1)  
●
●
Turn the control to position  
.
Adjust the left-hand exterior mirror. The  
right exterior mirror will be adjusted at the  
same time (synchronised).  
1)  
Regulation in right-hand drive vehicles is symmetrical  
125  

Related Topics

Popular Owner Manuals