2002-2008 Cupra Born SUV Visibility -> Sun protection User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Visibility -> Sun protection for Your Cupra Born SUV First Generation (2002-2008)

Visibility  
Activating the passenger side exterior mirror  
settings for reversing  
NOTICE  
Sun protection  
●
Before washing the vehicle in an automatic  
●
tion  
Turn the exterior mirror control knob to posi-  
Sun blind  
car wash, please make sure to fold the exte-  
rior mirrors in to prevent them from being  
damaged.  
1)  
.
●
Engage reverse gear with the ignition  
●
The electrically folding exterior mirrors  
switched on. The right-hand exterior rear-view  
must only be operated electrically, not by  
hand, and this could damage their electric  
drive.  
mirror will move to the saved position.  
The passenger side exterior mirror leaves the  
saved reversing position when the vehicle is  
travelling faster than approx. 15 km/h (9 mph),  
or if the control is turned from position to  
another position.  
For the sake of the environment  
Do not leave the exterior mirror heating on  
for longer than necessary. Otherwise it cau-  
ses unnecessary energy consumption.  
WARNING  
Fig. 111 Sun visor  
Fold and unfold the exterior mirror, taking  
care to avoid injuries.  
Note  
Options for adjusting driver and front pas-  
senger sun visors  
If the electrical adjustment should fail to op-  
erate, both of the mirrors can be adjusted  
by hand by lightly pressing the edge of the  
mirror glass.  
●
Only fold or unfold the exterior mirror  
when there is no-one in the way of the mir-  
ror.  
●
●
Lower the sun visor towards the windscreen.  
The sun visor can be pulled out of its mount-  
●
When moving the mirror, take care not to  
ing and turned towards the door ››› Fig. 111  
trap ꢀngers between the mirror and the mir-  
ror bracket.  
1
.
●
Swing the sun visor towards the door, longi-  
tudinally backwards.  
There is a vanity mirror on the sun visor, with  
2
a cover. When the cover is opened  
comes on.  
a light  
The lamp goes out when the vanity mirror  
cover is closed or the sun visor is pushed back  
up.  
1)  
Regulation in right-hand drive vehicles is symmetrical  
126  
Sunprotection  
Opening and closing the sunshade blind  
Closing the sunshade blind without the anti-  
trap function  
WARNING  
●
Automatic function: swipe your ꢀnger for-  
Folded sun blinds can reduce visibility.  
ward (open) or back (close) over the function  
button ››› Fig. 112. Pressing the function but-  
ton stops the automatic function.  
●
●
Try to close the blind again.  
●
Always store sun blinds and visors in their  
If it still cannot be closed, within 5 seconds  
housing when not in use.  
slide the function button backwards without  
●
Manual function: slide a ꢀnger across the  
releasing it ››› Fig. 112 until the blind closes  
fully. The blind closes without the interven-  
tion of the anti-trap function!  
Note  
function button forwards (open) or backwards  
(close) and hold until the blind reaches the de-  
sired position.  
The light above the sun visor automatically  
switches oꢁ after a few minutes in certain  
conditions. This prevents the battery from  
discharging.  
●
If it is still not possible to close the blind, visit  
a specialised workshop.  
Anti-trap function of the sunshade blind  
If the function button is released during clos-  
ing, the blind opens automatically.  
The anti-trap function can reduce the risk of  
injury when closing the sunshade blind ›››  
.
Glass roof sun blind  
If the blind encounters resistance or an obsta-  
cle when closing, it will reopen immediately.  
The button reacts diꢁerently than expected  
Moisture, dirt, grease, etc., can limit the opera-  
tion of the buttons. Make sure the buttons are  
always clean and dry.  
●
●
●
Check why the blind did not close.  
Try to close the blind again.  
If the blind still cannot be closed due to an  
obstacle or resistance, it will reopen immedi-  
ately. Once open, it can be closed for a short  
space of time without the anti-trap function.  
WARNING  
Closing the sun blind without the anti-trap  
function can cause serious injury.  
●
If it is still not possible to close the blind,  
close it without the anti-trap function.  
●
●
Always close the blind with care.  
Do not allow anyone to remain in the blind  
Fig. 112 On the interior roof lining:  
function button to operate the sun blind.  
travel area, particularly when closing without  
the anti-trap function.  
●
The anti-trap function does not prevent  
The electric sun blind operates while the igni-  
tion is switched on and can be opened and  
closed using the function button on the inte-  
rior roof trim.  
ꢀngers or other parts of the body from be-  
coming trapped against the roof frame and  
injuries occurring.  
127  

Related Topics

Popular Owner Manuals