Opening and closing
●
●
After a time.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Note
OR: if the vehicle is unlocked with the but-
●
If the vehicle battery has little or no
ton on the key.
charge, or the vehicle key battery is almost
or entirely out of charge, you will probably
not be able to lock or unlock the vehicle
with the Keyless Access system. The vehicle
can be unlocked or locked manually
Keyless Access permanent disconnection
function
●
●
OR: if the boot is opened.
OR: if the vehicle is unlocked manually with
You can deactivate the vehicle unlock with
Keyless Access permanently in the infotain-
ment system so that others cannot unlock or
start the vehicle.
the key.
page 107.
›››
●
Keyless Access temporary disconnection
function
To control the proper locking of the vehi-
cle, the release function is disabled for ap-
prox. 2 seconds.
You can deactivate the vehicle's Keyless
Access unlocking for one locking and un-
locking cycle.
Convenience functions
●
If the message Keyless access system
To close all the electric windows and the
sunroof using the comfort function, keep a
finger for a few seconds on the locking sen-
B
faulty is displayed on the screen of the
dash panel, abnormalities may occur in the
operation of the Keyless Access system.
Contact a specialised workshop. To do so,
CUPRA recommends going to a specialised
CUPRA dealer or any SEAT dealership.
●
Move the gear lever to position P since
otherwise the vehicle cannot be locked.
sor surface Fig. 82
handle until the windows and roof have
closed.
(arrow) of the door
›››
●
●
Close the door.
Push the central locking button on the
How the doors open when touching the
sensor surface on the door handle will de-
pend on the settings that have been activa-
ted in the infotainment system, using the
function button > Vehicle > Exterior >
Central locking.
●
Depending on the function set on the in-
remote control and touch the locking sensor
surface of the driver door handle
fotainment system for the mirrors, the ex-
terior mirrors will unfold and the surround
lighting will come on when unlocking the
vehicle using the sensor surface on the
driver and passenger door handles
B
Fig. 82
within the following 5 seconds.
›››
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver’s door lock.
page 128.
›››
●
CAUTION
If there is no valid key inside the vehicle
●
To check that the function has been deac-
or the system fails to detect one, a warning
will display on the dash panel screen. This
could happen if any other radio frequency
signal interferes with the key signal (e.g.
from a mobile device accessory) or if the
key is covered by another object (e.g. an
aluminium case).
The sensor surfaces on the door handles
could engage if hit with a water jet or high
pressure steam if there is a valid vehicle key
in the proximity. If at least one of the elec-
tric windows is open and the sensor surface
tivated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
B
Fig. 82
(arrow) on one of the handles
›››
»
is activated continuously, all windows will
close.
103