Transport and practical equipment
Removing the net partition
Fitting the net partition
parts could be damaged. Roll down the net
partition by hand.
●
●
●
Fold the rear seat backrests forward.
Remove the net partition from the side
Pull the net casing out approximately 5 cm
in the opposite direction to the arrow
2
Fig. 134
.
›››
●
supports.
Remove the casing from the rails by pulling
●
Place the net casing in the rail slots in the
Roof carrier
in the opposite direction to the arrows
1
direction of the arrows Fig. 134
.
›››
1
Fig. 134
.
›››
●
●
Push the casing towards the left side of the
Introduction
Lift the rear seat backrests.
vehicle in the direction of arrow Fig. 134
›››
2
and as far as it will go.
The vehicle roof has been designed to opti-
mise aerodynamics. For this reason, cross
bars or conventional roof carrier systems
cannot be secured to the roof water drains.
WARNING
●
Check that the net is secure.
During a sudden driving or braking ma-
noeuvre, or in the event of an accident, ob-
jects could be flung though the interior and
cause serious or fatal injuries.
Pulling out and securing the net partition
As the roof water drains are integrated in the
roof to reduce air resistance, only CUPRA-
approved cross bars and roof carrier systems
can be used.
●
2
Pull up handle Fig. 135
to remove the
›››
4
net from the casing Fig. 135
.
›››
●
Always secure objects, even when the net
●
Hook in the net partition on the right or
partition is properly assembled.
3
left side Fig. 135
(magnified image).
›››
●
There should be nobody behind the as-
●
sembled partition when the vehicle is mov-
ing.
Hook in the net partition into the housing
Cases in which cross bars and the roof car-
rier system should be disassembled.
1
on the other side Fig. 135
by pulling
›››
the rod.
●
●
●
When they are not used.
WARNING
The net partition is properly assembled
when the T-shaped ends are firmly secured
in the corresponding housings Fig. 135
When the vehicle is washed in a car wash.
When the vehicle height exceeds the max-
imum height, for example, in some garages.
The rear seat backrests should only be lif-
ted again once the net partition has been
disassembled.
3
›››
1
and
.
WARNING
Retracting the net partition
CAUTION
●
Always secure the load properly using
●
Remove the rod from the housings in the
Incorrect handling of the net partition
could cause damage.
belts or retaining straps that are suitable
and in a good condition.
trims of the roof side members.
●
●
Do not “release” the net partition when
Roll up the net into the casing Fig. 135
lowering it with your hand.
›››
●
Bulky, heavy, long or flat loads have a
lowering it, as the net and other vehicle
4
negative effect on aerodynamics, the cen-
tre of gravity and driving performance.
»
147
English 
