2024-2026 Cupra Terramar SUV Opening and closing -> Window controls User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Opening and closing -> Window controls for Your Cupra Terramar SUV First Generation (2024-2026)

Opening and closing
117
Window controls
1
2
3
4
5
Window controls
Opening and closing the windows
Fig.87 Detail of the driver's door: window
controls.
●
Open the window: press button
●
Close the window: pull button
Buttons on the driver’s door
Left-hand front door window
Right-hand front door window
Left-hand rear door window
Right-hand rear door window
Safety control for deactivating the window
control buttons on the rear doors
Both front and rear windows can be operated
from the controls on the driver's door. The
other doors have a separate control for each
window.
Always close the windows completely when the
vehicle is parked or out of sight ››› .
You can use the electric windows for approx.
10 minutes after switching o the ignition if
neither the driver’s door nor the front passen-
ger door have been opened and the ignition
key has not been removed (depending on the
equipment).
Safety switch
The safety control ›››Fig.87
5
on the driv-
er's door can be used to disable the electric
window buttons on the rear doors.
Safety control not pressed: the buttons on the
rear doors are activated.
Safety control pressed: the buttons on the rear
doors are deactivated.
The safety control symbol
lights up in yellow
if the buttons on the rear doors are switched
o.
Comfort opening and closing
The windows can be opened and closed from
the outside using the vehicle key:
Convenience opening:
●
Press and hold the button on the remote
control key until all the windows and the sun-
roof have reached the desired position.
●
OR: First unlock the vehicle using the but-
ton on the remote control key and then keep
the key in the driver's door lock until all the
windows and the sunroof have reached the re-
quired position.
Convenience closing:
●
Press and hold button on the remote con-
trol key until all the windows and the sunroof
are closed ››› .
●
OR: Keep the key in the driver's door in the
"lock" position until all the windows and the
sunroof are closed.
●
OR: using the Keyless Access system (only
locking): Press and hold the locking sensor sur-
face ›››Fig.89 (arrow) on the door handle
for several seconds to close the windows and
the sunroof. If you stop touching the sensing
surface, the locking function is interrupted.
Comfort locking closes the windows rst and
then the panoramic sunroof.
In the infotainment system dierent settings
can be adjusted using the function button >
Vehicle > Exterior > Windows > Convenience
opening.
118
Opening and closing
One-touch opening and closing
Automatic raising and lowering fully opens and
closes the windows. It is not necessary to press
and hold the appropriate window button for
this purpose.
For the automatic raising function: pull the
button for the corresponding window upwards
until it reaches the second position.
For the automatic lowering function: push the
button for the corresponding window down-
wards until it reaches the second position.
Stop automatic movement: push or pull on the
button of the corresponding window.
Resetting the automatic raising/lowering
function
If the 12-volt battery is disconnected or dis-
charged when the windows are not completely
closed, the electric window automatic raising
and lowering function deactivates and has to
be reset:
●
Switch the ignition on.
●
Close all doors and windows.
●
Pull the corresponding window button up-
wards and hold it in this position for a few sec-
onds.
●
Release the button, pull it up again and hold
it in this position. This resets the automatic
raising and lowering function.
The function can be reset for a single window
or for several windows at the same time.
WARNING
Observe the safety warnings ››› in Intro-
duction on page110.
●
Improper use of the power windows can
cause injury.
●
Never close windows carelessly or in an un-
controlled manner, as this could cause seri-
ous injuries to you or third parties. Therefore,
make sure that no one is in the way of the
moving windows.
●
If the ignition is switched on, electrical
equipment such as the power windows could
activate, which can cause injury.
●
The vehicle doors can be locked with the
remote control key, making it diicult to get
help in an emergency.
●
Therefore always take the key with you
when you leave the vehicle.
●
The power windows are only deactivated
when the ignition is switched o and one of
the front doors is opened.
●
If necessary, deactivate the rear power
windows with the safety control. Make sure
that they have actually been deactivated.
●
For safety reasons, you should only unlock
and lock the vehicle with the remote control
key when you are approximately 2 metres
away from the vehicle. When pressing the
lock button, always monitor the movement
of the windows to avoid accidents. Releasing
the button immediately interrupts the clos-
ing process.
Note
If the window is not able to close because
it is sti or because of an obstruction,
the window will automatically open again
›››page118. In this case, check why the
window could not be closed before trying
again.
Window anti-trap function
The roll-back function reduces the risk of in-
jury when the power windows close.
If a window encounters resistance or an obsta-
cle when closing, it will reopen immediately
›››
.
●
Check why the window does not close.
●
Try closing the window again.
●
If the closing process is interrupted again,
the anti-trap function stops working for a few
seconds.
●
If the window still cannot be closed, it will
stop in the corresponding position. Pulling
the button again within a few seconds closes
the window without the anti-trap function
››› .

Related Topics

Popular Owner Manuals