In the event of a breakdown -> Tool kit for Your DS 3 Crossback 4 Door First Generation (2018-2022)

148  
08  
In the event of a breakdown  
►ꢀ Switch on the ignition (without starting the  
engine).  
►ꢀ Wait around 1 minute and switch off the  
ignition.  
►ꢀ Operate the starter motor to start the engine.  
If the engine does not start at the first attempt,  
do not keep trying, but restart the procedure.  
Assembling and placing the  
triangle  
Warning triangle  
As a safety precaution, before leaving your  
vehicle to set up and install the triangle, switch  
on the hazard warning lamps and put on your high  
visibility vest.  
Storage  
Tool kit  
Set of tools supplied with the vehicle.  
Its content depends on your vehicle's equipment:  
– Temporary puncture repair kit.  
– Spare wheel.  
For versions supplied with a triangle as original  
equipment, refer to the illustration above.  
For other versions, refer to the assembly  
instructions provided with the triangle.  
►ꢀ Put the triangle in place behind the vehicle, as  
required by local legislation.  
Access to the tools  
Depending on version, the tool kit is stored in a  
bag or in a storage box in the boot.  
Use the straps on the boot sill trim to stow the  
folded triangle or its storage box.  
Running out of fuel  
(Diesel)  
With Diesel engines, the fuel system must be  
primed if you run out of fuel.  
Before starting to prime the system, it is essential  
to put at least 5 litres of Diesel into the fuel tank.  
On the boot carpet  
For more information on Refuelling and on  
Misfuel prevention (Diesel), please refer  
to the corresponding section.  
149  
08  
In the event of a breakdown  
With spare wheel  
List of tools  
1. Chock to immobilise the vehicle (depending on  
equipment)  
2. Socket for the wheel security bolts (depending  
on equipment)  
Under the boot carpet  
►ꢀ Raise the boot carpet by pulling the strap to  
access the tools.  
These tools are specific to the vehicle and  
may vary according to the level of  
equipment.  
For adapting the wheelbrace to the special  
‘security’ bolts.  
Do not use them for any other purpose.  
3. Removable towing eye  
With temporary puncture repair kit  
For more information on Towing the vehicle and  
using the removable towing eye, refer to the  
corresponding section.  
The jack must only be used to change a  
wheel with a damaged or punctured tyre.  
Do not use any jack other than the one  
supplied with the vehicle.  
With temporary puncture repair kit  
If the vehicle does not have its original jack,  
contact a dealer or a qualified workshop  
to obtain the one that was intended by the  
manufacturer.  
The jack meets European standards, as  
defined in the Machinery Directive 2006/42/  
CE.  
The jack does not require any maintenance.  
4.12 V compressor with a cartridge of sealant and  
a speed limit sticker.  
For temporary repair of a tyre and to adjust the  
tyre pressure.  
150  
08  
In the event of a breakdown  
For more information about the Temporary  
puncture repair kit, refer to the corresponding  
section.  
Made up of a compressor and a sealant cartridge,  
it allows the temporary repair of a tyre so that you  
can drive to the nearest garage.  
It is designed to repair most punctures which  
could affect the tyre, located on the tyre tread.  
With spare wheel  
The vehicle's electric system allows the  
connection of the compressor for long  
enough to inflate a tyre after a puncture repair.  
For more information on the Tool kit, refer  
to the corresponding section.  
►ꢀ Connect the pipe from the compressor to the  
bottle of sealant.  
Repair procedure  
5.Wheelbrace.  
Do not remove any foreign bodies (e.g.  
nail, screw) which have penetrated into  
the tyre.  
For removing the wheel trim and the wheel bolts.  
6.Jack with integrated handle.  
To raise the vehicle.  
7.Wheel bolt cap remover (depending on  
equipment).  
For removing the wheel bolt head finishers on  
alloy wheels.  
For more information on the Spare wheel, refer to  
the corresponding section.  
►ꢀ Park the vehicle without obstructing traffic  
and apply the parking brake.  
►ꢀ Follow the safety instructions (hazard warning  
lamps, warning triangle, high visibility vest, etc.)  
according to the legislation in force in the country  
of driving.  
►ꢀ Turn the bottle of sealant over and secure it in  
the notch provided on the compressor.  
►ꢀ Remove the valve cap from the tyre to be  
repaired, and place it in a clean area.  
►ꢀ Switch off the ignition.  
►ꢀ Uncoil the pipe stowed under the compressor.  
Temporary puncture repair  
kit  
Scan the QR Code on page 3 to view  
explanatory videos.