Driving -> DS PARK PILOT for Your DS 7 Crossback 4 Door First Generation (2017-2022)

150  
Driving  
06  
– activating the direction indicator lamps on the  
opposite side to that of the manoeuvre.  
– unfastening the driver's seat belt.  
– switching off the ignition.  
The manoeuvre symbol is displayed in red,  
accompanied by the message “Manoeuvre  
completed” on the touch screen.  
When the function is deactivated, this  
indicator lamp goes off, accompanied by  
an audible signal.  
Malfunctions  
When the function is not activated, the  
temporary flashing of this indicator lamp  
and an audible signal indicate a system  
malfunction.  
If the malfunction occurs while the system is in  
use, the indicator lamp goes off.  
Interruption by the system:  
– vehicle exceeding the speed limit of 5 mph  
(7 km/h) during parking space entry manoeuvres,  
or 3 mph (5 km/h) during parking space exit  
manoeuvres.  
– activation of anti-slip regulation on a slippery  
road.  
– opening of a door or the boot.  
– engine stall.  
– system malfunction.  
– after 10 manoeuvres to enter or exit a parallel  
parking space and after 7 manoeuvres to enter a  
parking bay.  
Interrupting the manoeuvre automatically  
deactivates the function.  
The manoeuvre symbol is displayed in red,  
accompanied by the "Manoeuvre cancelled"  
message on the touch screen.  
A message prompts the driver to take back  
control of the vehicle.  
When entering a parking space, the driver may be  
required to complete the manoeuvre.  
If the parking sensor malfunction  
occurs during use, indicated by one  
of these warning lamps coming on, it causes the  
function to deactivate.  
In the event of a malfunction, have the system  
checked by a dealer or a qualified workshop.  
In the event of a power steering  
malfunction, this warning lamp is  
displayed on the instrument panel, accompanied  
by a warning message.  
Operating limits  
– The system may suggest an inappropriate  
parking space (parking prohibited, work in  
progress with damaged road surface, location  
alongside a ditch, etc.).  
– The system may indicate that a space has  
been found but will not offer it because of a fixed  
obstacle on the opposite side of the manoeuvre,  
which would not allow the vehicle to follow a  
trajectory required for parking.  
– The system may indicate that a space has been  
found but the manoeuvre will not be triggered,  
because the width of the lane is insufficient.  
– The system is not designed for performing the  
parking manoeuvre on a sharp bend.  
– The system does not detect spaces that  
are much larger than the vehicle itself or that  
are delimited by obstacles that are too low  
(pavements, studs, etc.) or too thin (trees, posts,  
wire fences, etc.).  
– If the boot is heavily loaded, the tilt of the  
vehicle towards the rear may interfere with the  
distance measurements.  
You must stop as soon as it is safe to do so.  
Contact a dealer or a qualified workshop.  
DS PARK PILOT  
Refer to the General recommendations on the use  
of driving and manoeuvring aids.  
This system provides active parking assistance  
for vehicles fitted with the EAT8 automatic  
gearbox: it detects a free "parallel" or "bay"  
parking space and then operates the vehicle,  
parking it with no need for driver intervention. It  
also allows you to drive out of a "parallel parking"  
space automatically.  
The function is deactivated after a few  
seconds; this warning lamp goes off and  
the function returns to the initial display.  
End of the parking space entry or exit  
manoeuvre  
The vehicle stops as soon as the manoeuvre is  
completed.  
The system controls the steering, direction,  
acceleration and braking. The system measures  
151  
Driving  
06  
the available parking spaces and calculates  
the distances to obstacles using 12 ultrasonic  
sensors built into the front and rear bumpers of  
the vehicle.  
To help the driver monitor the successful  
completion of the manoeuvre, the system  
automatically displays the Reversing camera or  
360 Vision and activates the parking sensors.  
Choice of the type of  
manoeuvre and search for  
►ꢀ Press the button on the gear selector or, on  
the touch screen, select Driving / Vehicle > DS  
PARK PILOT.  
space  
Depending on whether the vehicle has been  
Activating the system deactivates Blind  
Spot Detection.  
driven or not since the ignition was switched on,  
the function proposes the entry to or exit from a  
parking space on the touch screen.  
►ꢀ Select the type and side of the manoeuvre to  
activate the parking space search.  
Illumination of this lamp confirms  
Sequence  
Once the system is activated, the following steps  
will be performed successively:  
– Select the type of manoeuvre via the touch  
screen.  
– Search for an available space.  
– Prepare for the manoeuvre.  
– Perform the manoeuvre.  
activation.  
It is possible to change the type of manoeuvre  
at any time, including during the available space  
search phase.  
►ꢀ Drive at a distance of 0.50 to 1.50 m from the  
row of parked vehicles, not exceeding 19 mph  
(30 km/h), until the system finds an available  
space (indicated by OK on the display and an  
audible signal).  
– Finalise the manoeuvre.  
It is possible to deactivate the system at  
any time until the start of the manoeuvre,  
by pressing the red arrow in the upper left  
corner of the screen.  
To initiate parking assistance when approaching  
a parking area:  
►ꢀ Reduce the speed of the vehicle to a maximum  
of 19 mph (30 km/h).  
For "parallel" parking, the space must at  
least equal to the length of your vehicle  
plus 1 m.  
For "bay" parking, the space must at least  
equal to the width of your vehicle plus 0.70 m.  
DS PARK PILOT is not always able to react  
automatically and appropriately due to  
the performance limits inherent to the system.  
The manoeuvre remains the responsibility  
of the driver, who must not leave the driving  
position and must never try to lock the system  
control button.  
Preparing for the manoeuvre  
►ꢀ Move very slowly until the request to stop  
the vehicle and the "STOP" sign are displayed,  
accompanied by an audible signal.  
The driver's seat belt must remain fastened  
during the manoeuvre.  
152  
Driving  
06  
Once the vehicle has stopped, an instructions  
page is displayed on the screen.  
►ꢀ To prepare for the manoeuvre, you must fulfil  
all of these instructions.  
This symbol will be displayed automatically  
when the instruction has been applied.  
When all instructions have been validated, a  
new screen is displayed, indicating that you can  
undertake the manoeuvre.  
►ꢀ To undertake the manoeuvre, press this  
button.  
►ꢀ While holding down the button, gradually  
release the brake pedal.  
Manoeuvre in progress.  
Manoeuvre interrupted.  
Pausing/resuming the manoeuvre  
The manoeuvre can be interrupted temporarily  
at any time, either automatically by the system if  
an obstacle is detected, or by driver action. If the  
driver notices a hazard, they may also interrupt  
the manoeuvre permanently.  
To suspend the manoeuvre, the driver can:  
– Release the function control button.  
– Depress the brake pedal.  
– Resume control of the steering.  
– Change the gearbox status (except changing  
to P).  
The vehicle is immediately immobilised if the  
manoeuvre is suspended.  
This is confirmed by the display of this  
symbol, accompanied by the message  
"Manoeuvre suspended".  
Resuming the manoeuvre after resolving the  
conditions for suspending it:  
►ꢀ Release all controls (brake pedal, function  
control button, steering wheel, etc.).  
►ꢀ Press the function control button again.  
Permanent interruption after suspending the  
manoeuvre:  
Manoeuvre completed or abandoned  
(white arrows indicate that the driver must  
take back control of their vehicle).  
The direction of the manoeuvre is indicated by  
these symbols:  
Forward gear.  
Reverse gear.  
The central arrow is green whilst the vehicle is  
moving, or white to indicate the next manoeuvring  
direction.  
The button must be held down throughout  
the manoeuvre.  
The start of the manoeuvre is indicated by the  
display of a screen with the message "Manoeuvre  
under way", accompanied by an audible signal.  
Reversing camera or 360 Vision and the parking  
sensors are automatically activated to help you  
monitor the close surrounding area of your vehicle  
throughout the manoeuvre.  
Throughout the whole manoeuvre,  
indicated by the green "AUTO" symbol, the  
driver must hold the selector button down.  
During manoeuvring phases, the steering  
wheel performs rapid turns: do not hold  
the steering wheel or put your hands between  
the spokes of the steering wheel. Watch out  
for any objects that could interfere with the  
manoeuvre (loose clothing, scarf, tie, etc.).  
Risk of injury!  
Performing the manoeuvre  
►ꢀ Depress the brake pedal and engage a gear.  
As soon as the driver releases the brake pedal,  
the system automatically takes control of  
choosing the travel direction, forwards or reverse,  
acceleration, braking and the steering direction.  
The manoeuvring status is indicated by these  
symbols:  
Abandoning the manoeuvre  
The manoeuvre is abandoned in the following  
situations:  
– No action by the driver within 30 seconds of the  
manoeuvre being suspended.  
If the vehicle slows down significantly, the  
brake lamps may come on.  
– Intentional application of the parking brake.  
153  
Driving  
06  
– Gearbox mode P engaged by the driver.  
– Driver's seat belt unfastened.  
– Opening of a door or the boot.  
– Activation of the direction indicator lamps on  
the opposite side to that of the manoeuvre.  
– In certain cases, when a wheel of the vehicle  
hits a pavement or a low obstacle.  
– Triggering of anti-slip regulation on a slippery  
road.  
– The system may indicate that a space has been  
End of manoeuvre  
found but the manoeuvre will not be triggered  
because the width of the lane is insufficient.  
– The system is not designed to perform parking  
manoeuvres on a steep slope or on a sharp curve.  
– The system does not detect spaces that  
are much larger than the vehicle itself or that  
are delimited by obstacles that are too low  
(pavements, studs, etc.) or too thin (trees, posts,  
wire fences, etc.).  
– The system may be impaired by incorrect  
inflation of the vehicle’s tyres.  
– The tilting of the vehicle if the boot is heavily  
loaded can affect the distance measurements.  
The vehicle stops as soon as the manoeuvre is  
completed.  
This symbol is displayed, accompanied by  
the message "Manoeuvre completed" on  
the touch screen.  
When the function is deactivated, this  
indicator lamp on the instrument panel  
goes off and the original display is restored.  
– If entering a parking space, the driver may be  
required to complete the manoeuvre. The gearbox  
changes to P 4 seconds after completion of the  
manoeuvre.  
– When exiting a parking space, the gearbox  
changes to N when the manoeuvre is complete. A  
message and symbols prompt the driver to take  
back control of the vehicle.  
The gearbox automatically changes to mode  
P if no action is taken by the driver within 30  
secondss.  
– Engine stalling.  
– Sudden appearance in the field of the  
manoeuvre of an obstacle not detected by the  
system before the manoeuvre was started, with  
the obstacle remaining for more than 30 seconds.  
– After 10 manoeuvres to enter or exit a "parallel"  
parking space and after 7 manoeuvres to enter a  
"bay" parking space,  
– System malfunction during the manoeuvre.  
Abandoning the manoeuvre immediately  
triggers the vehicle’s brakes and automatically  
deactivates the function.  
This symbol is displayed, accompanied by  
the message "Manoeuvre abandoned" on  
the touch screen.  
A message prompts the driver to take back  
control of the vehicle.  
Do not use the function under the  
following exterior conditions:  
– Alongside a soft shoulder (ditch) or quay or  
on the edge of a drop.  
– When the road surface is slippery (ice).  
Do not use the function in the presence of  
one of the following malfunctions:  
– If a tyre is under-inflated.  
– If one of the bumpers is damaged.  
– If one of the cameras is faulty.  
– If the brake lamps are not working.  
Operating limits  
– The system may suggest an inappropriate  
parking space (parking prohibited, work in  
progress with damaged road surface, location  
alongside a ditch, etc.).  
The function is deactivated after a few  
seconds; this indicator lamp goes off on  
the instrument panel and the initial display is  
resumed.  
The system automatically engages gearbox mode  
P after 4 seconds.  
– The system may indicate that a space has  
been found but will not offer it because of a fixed  
obstacle on the opposite side of the manoeuvre,  
which does not allow the vehicle to follow the  
trajectory required for parking.  
154  
Driving  
06  
Do not use the function if the vehicle has  
been subject to one of the following  
Contact a dealer or a qualified workshop.  
In the event of a power steering  
modifications:  
malfunction, this warning lamp is  
displayed on the instrument panel, accompanied  
by a message.  
You must stop as soon as it is safe to do so.  
Contact a dealer or a qualified workshop.  
– When carrying an object extending beyond  
the dimensions of the vehicle (ladder on the  
roof bars, bicycle carrier on the tailgate, etc.).  
– With a non-approved towball in place.  
– With snow chains fitted.  
– When driving on a small-diameter or "space-  
saver" type spare wheel.  
– When the wheels fitted are a different size  
from the original ones.  
– After modifying one or both bumpers (added  
protection).  
– If the sensors have been repainted outside  
the dealer network.  
– With sensors not approved for the vehicle.  
Malfunctions  
When the function is not activated, the  
temporary flashing of this warning lamp  
and an audible signal indicate a DS PARK PILOT  
malfunction.  
If the malfunction occurs while the system is in  
use, the warning lamp goes off.  
If a parking sensor malfunction,  
indicated by one of these warning  
lamps coming on, occurs during DS PARK PILOT  
use, the function is deactivated.