42
Access
02
Before operating the sunroof or blind
control buttons, ensure that no object or
►ꢀ When holding a button (without going
beyond the point of resistance), the movement
of the sunroof or blind stops when this button is
released.
►ꢀ Press and hold the front part of button A, until
the sunroof and blind move slightly, then hold for
a further 1 second before releasing.
person might prevent the movement.
Be particularly aware of children when
operating the sunroof or blind.
►ꢀ Wait 2 seconds and then press and hold the
front part of button A. The blind and the sunroof
will open and close, one after the other. When
both are completely closed again, hold for a
further 2 seconds and release.
►ꢀ When the sunroof is closed: pressing once
without passing the point of resistance moves it
to a partially open position.
If something is trapped when operating
the sunroof or blind, you should reverse the
movement of the sunroof or blind by pressing
the control in question.
►ꢀ When the sunroof is partially open: pressing
once without passing the point of resistance
opens or closes it fully.
If there is an operating fault, restart the
whole procedure.
The driver must ensure that passengers use
the sunroof and blind correctly.
The sunroof and windows, then the blind,
can be closed by holding down the door
locking control. The manoeuvre stops as soon
as the locking control is released.
Anti-pinch system
If the sunroof or blind encounters an obstacle
when closing, the movement is automatically
reversed.
Closing of the blind is limited by the
position of the sunroof: the blind cannot
go further than the front of the movable glass.
During simultaneous movements of the
sunroof and blind, the blind automatically
stops or resumes movement depending on the
position of the sunroof.
The roof anti-pinch system is designed to be
effective at speeds of up to 75 mph (120 km/h).
Opening/Closing
►ꢀ To open the sunroof or the blind, use the part
of the button located towards the rear of the
vehicle.
►ꢀ To close the sunroof or the blind, use the part
of the button located towards the front of the
vehicle.
Reinitialisation
Following reconnection of the battery or in the
event of a fault or jerky movement of the sunroof
or blind, reinitialisation is required.
Operation of buttons
►ꢀ Pressing a button beyond its point of
resistance directly opens or closes the sunroof or
blind fully.
►ꢀ Check that nothing is interfering with the
sunroof or blind and that the seals are clean.
►ꢀ With the ignition on, fully close the sunroof
and blind.
►ꢀ Pressing the button again stops the current
movement.
English 
