2017-2026 DS 7 4 Door Practical information -> Charging the traction battery (Rechargeable hybrid engine) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Practical information -> Charging the traction battery (Rechargeable hybrid engine) for Your DS 7 4 Door First Generation (2017-2026)

164  
07  
Practical information  
Vehicle immobilised for 1 to 12 months  
Discharge the traction battery down to 2  
or 3 bars on the charge level indicator on the  
instrument panel.  
►ꢀ Have a professional check that the  
electrical system to be used complies with  
applicable standards and is compatible with  
the vehicle.  
Charging the traction  
battery (Rechargeable  
hybrid)  
For a full charge, follow the charging  
procedure without interrupting it, until it stops  
automatically. Charging may be performed either  
immediately (by default) or deferred.  
Deferred charging is set via the touch  
screen or the MyDS App application.  
When the vehicle is connected, the following  
information is displayed on the instrument panel:  
– Status of the battery (%).  
Do not connect the charging cable.  
Always park the vehicle in a place with  
temperatures between -10°C and 30°C  
(parking in a place with extreme temperatures  
can damage the traction battery).  
Refer to the Accessory battery (Rechargeable  
hybrid) section for the battery disconnection  
procedure.  
►ꢀ Have a professional electrician install  
a dedicated domestic power socket or  
accelerated charging unit (Wallbox)  
compatible with the vehicle.  
Use the charging cable supplied with the  
vehicle.  
For more information, contact a dealer or a  
qualified workshop.  
(During charging)  
Precautions  
Rechargeable hybrid vehicles have  
– Remaining range (miles or km).  
As a safety measure, the engine will not  
start if the charging cable is plugged into  
the connector on the vehicle. A warning is  
displayed on the instrument panel.  
While charging is in progress, unlocking the  
vehicle will cause the charging to stop.  
If no action is taken on one of the openings  
(door or boot) or on the charging nozzle, the  
vehicle will lock again after 30 seconds and  
charging will resume automatically.  
Never work under the bonnet:  
– Estimated charging time (calculation may take  
a few seconds).  
been developed in accordance with the  
recommendations for maximum electromagnetic  
field limits established by the ICNIRP  
– Charging speed (kW/h).  
After the instrument panel has been put into  
standby mode, this information can be displayed  
again by unlocking the vehicle or opening a door.  
(International Commission on Non-Ionizing  
Radiation Protection - 1998 Guidelines).  
Wearers of pacemakers or equivalent  
It is also possible to monitor the charging  
progress using the MyDS App application.  
For more information on Remote functions,  
refer to the corresponding section.  
devices should consult a doctor to enquire  
about any applicable precautionary measures, or  
contact the manufacturer of their implanted  
electronic medical device to check that it is  
guaranteed to operate in an environment  
compliant with the ICNIRP guidelines.  
– Some areas remain very hot, even an hour  
after charging ends - risk of burns!  
– The fan may start at any time - risk of cuts or  
strangulation!  
Lounge mode  
When the vehicle is connected, it is  
possible to switch on the ignition and use  
certain functions such as the audio and  
telematics system and the air conditioning  
system for several hours.  
If in doubt, during charging, do not remain inside  
or near the vehicle, near the charging cable or the  
charging unit, even for a short time.  
After charging  
Before charging  
Check that the charging flap is closed.  
Depending on the context:  
165  
07  
Practical information  
Do not leave the cable connected to the  
domestic power socket - risk of short-circuit  
or electrocution in the event of contact with or  
immersion in water!  
When the connection is made, all of the indicator  
lamps on the control unit light up, then only the  
POWER indicator lamp remains on in green.  
►ꢀ Remove the protective cover from the  
charging nozzle.  
If this is not the case, charging has not  
started; restart the procedure ensuring that all  
connections are properly established.  
The red indicator lamp in the flap comes on to  
indicate that the nozzle is locked.  
►ꢀ Insert the nozzle into the vehicle's charging  
connector.  
Charging procedure  
Disconnection  
The start of charging is confirmed by the flashing  
of the green light guides in the flap and the  
flashing of the CHARGE indicator lamp in green on  
the control unit.  
Connection  
►ꢀ Before charging, check that the gear selector  
is in mode P and the ignition is off, otherwise  
charging is impossible.  
If this is not the case, charging has not started;  
restart the procedure, ensuring that all of the  
connections are properly established.  
The red indicator lamp in the flap comes on to  
indicate that the nozzle is locked.  
►ꢀ Press on the rear of the charging flap to open  
it and check that there are no foreign bodies on  
the vehicle's charging connector.  
Before disconnecting the nozzle from the  
charging connector:  
►ꢀ If the vehicle is locked, unlock it.  
►ꢀ If the vehicle is unlocked, lock it and then  
unlock it.  
The light guides in the flap come on white.  
Domestic charging (mode 2)  
Accelerated charging (mode 3)  
If selective unlocking of the doors is  
activated, press the unlocking button on  
the remote control twice to disconnect the  
nozzle.  
The red indicator lamp in the flap goes out to  
confirm that the nozzle is unlocked.  
►ꢀ Within 30 seconds, remove the charging  
nozzle.  
►ꢀ Follow the accelerated charging unit (Wallbox)  
user instructions.  
►ꢀ Remove the protective cover from the  
charging nozzle.  
Domestic charging (mode 2)  
The end of charging is confirmed when the  
green CHARGE indicator lamp on the control unit  
comes on fixed and the green light guides in the  
flap come on fixed.  
►ꢀ Insert the nozzle into the vehicle's charging  
connector.  
►ꢀ First, connect the charging cable from the  
control unit to the domestic socket.  
The start of charging is confirmed by the flashing  
of the green light guides in the flap.  

Related Topics

Popular Owner Manuals