Get Practical information -> Charging the traction battery (Rechargeable hybrid) Guide for DS 9 4 Door First Generation (2020-2024)

148

Practical information

Manual reset procedure

The control unit can be reset by simultaneously disconnecting the charging connector and the wall socket.

Then, reconnect the wall socket first. For more information, refer to the handbook.

Lounge mode

Charging the traction

Wearers of pacemakers or equivalent

devices should consult a doctor to enquire

about any applicable precautionary measures, or

contact the manufacturer of their implanted

electronic medical device to check that it is

guaranteed to operate in an environment

compliant with the ICNIRP guidelines.

When the vehicle is connected, it is

battery (Rechargeable

hybrid)

possible to switch on the ignition and use

certain functions such as the audio and

telematics system and the air conditioning

system for several hours.

For a full charge, follow the charging

procedure without interrupting it, until it stops

automatically. Charging may be performed either

immediately (by default) or deferred.

Deferred charging is set via the touch

screen or the MyDS App application.

When the vehicle is connected, the following

information is displayed on the instrument panel:

– Status of the battery (%).

If in doubt, during charging, do not remain inside

or near the vehicle, near the charging cable or the

charging unit, even for a short time.

Vehicle in storage for more than 1 month

Discharge the traction battery down to 2

or 3 bars on the charge level indicator on the

instrument panel.

Before charging

Do not connect the charging cable.

Always park the vehicle in a place with

temperatures between -10°C and 30°C

(parking in a place with extreme temperatures

can damage the traction battery).

Refer to the Accessory battery (Rechargeable

hybrid) section for the battery disconnection

procedure.

Depending on the context:

►ꢀ Have a professional check that the

electrical system to be used complies with

applicable standards and is compatible with

the vehicle.

– Remaining range (miles or km).

– Estimated charging time (calculation may take

a few seconds).

►ꢀ Have a professional electrician install

a dedicated domestic power socket or

accelerated charging unit (Wallbox)

compatible with the vehicle.

– Charging speed (kW/h).

After the instrument panel has been put into

standby mode, this information can be displayed

again by unlocking the vehicle or opening a door.

Use the charging cable supplied with the

vehicle.

Precautions

Rechargeable hybrid vehicles have

It is also possible to monitor the charging

progress using the MyDS App application.

For more information on Remote functions,

refer to the corresponding section.

For more information, contact a dealer or a

qualified workshop.

been developed in accordance with the

recommendations for maximum electromagnetic

field limits established by the ICNIRP

(International Commission on Non-Ionizing

Radiation Protection - 1998 Guidelines).

During charging

As a safety measure, the engine will not

start if the charging cable is plugged into

149

Practical information

the connector on the vehicle. A warning is

displayed on the instrument panel.

While charging is in progress, unlocking the

vehicle will cause the charging to stop.

If no action is taken on one of the openings

(door or boot) or on the charging nozzle, the

vehicle will lock again after 30 seconds and

charging will resume automatically.

Never work under the bonnet:

Domestic charging (mode 2)

Accelerated charging (mode 3)

►ꢀ Follow the accelerated charging unit (Wallbox)

user instructions.

– Some areas remain very hot, even an hour

after charging ends - risk of burns!

►ꢀ Remove the protective cover from the

charging nozzle.

– The fan may start at any time - risk of cuts or

strangulation!

►ꢀ Insert the nozzle into the vehicle's charging

connector.

The start of charging is confirmed by the flashing

of the green light guides in the flap.

If this is not the case, charging has not

started; restart the procedure ensuring that all

connections are properly established.

The red indicator lamp in the flap comes on to

indicate that the nozzle is locked.

►ꢀ First, connect the charging cable from the

control unit to the domestic socket.

When the connection is made, all of the indicator

lamps on the control unit light up, then only the

POWER indicator lamp remains on in green.

►ꢀ Remove the protective cover from the

charging nozzle.

After charging

Check that the charging flap is closed.

Do not leave the cable connected to the

domestic power socket - risk of short-circuit

or electrocution in the event of contact with or

immersion in water!

►ꢀ Insert the nozzle into the vehicle's charging

connector.

Disconnection

Charging procedure

The start of charging is confirmed by the flashing

of the green light guides in the flap and the

flashing of the CHARGE indicator lamp in green on

the control unit.

Connection

►ꢀ Before charging, check that the gear selector

is in mode P and the ignition is off, otherwise

charging is impossible.

If this is not the case, charging has not started;

restart the procedure, ensuring that all of the

connections are properly established.

The red indicator lamp in the flap comes on to

indicate that the nozzle is locked.

►ꢀ Press on the rear of the charging flap to open

it and check that there are no foreign bodies on

the vehicle's charging connector.

Before disconnecting the nozzle from the

charging connector:

►ꢀ If the vehicle is locked, unlock it.

The light guides in the flap come on white.

150

Practical information

►ꢀ If the vehicle is unlocked, lock it and then

unlock it.

►ꢀ In the Energy touch screen menu,

select the Charge page.

We recommend having them fitted by a dealer

or a qualified workshop.

►ꢀ Set the charging start time.

►ꢀ Press OK.

If not fitted by a dealer, they must still be

fitted in accordance with the Manufacturer's

instructions.

If selective unlocking of the doors is

activated, press the unlocking button on

the remote control twice to disconnect the

nozzle.

The setting is saved in the system.

With DS CONNECT RADIO or NAVIGATION

You can also programme the deferred

charging function at any time from a

smartphone via the MyDS App application.

For more information on Remote functions, refer

to the corresponding section.

Important: with a motorised boot and

its Hands-Free Tailgate Access function, if

a towing device is fitted outside the dealer

network, it is essential to visit a dealer or a

qualified workshop to recalibrate the detection

system. Risk of malfunction of the Hands-Free

Tailgate Access function.

The red indicator lamp in the flap goes out to

confirm that the nozzle is unlocked.

►ꢀ Within 30 seconds, remove the charging

nozzle.

Activation

Domestic charging (mode 2)

Certain driving or manoeuvring aid functions

are automatically deactivated while an

approved towing system is in use.

►ꢀ Connect the vehicle to the desired charging

equipment.

The end of charging is confirmed when the

green CHARGE indicator lamp on the control unit

comes on fixed and the green light guides in the

flap come on fixed.

►ꢀ Press this button in the flap within one

minute to activate deferred charging

(confirmed by the light guides coming on in blue).

For more information about driving with a

towing device fitted to a trailer and associated

with the Trailer stability assist, refer to the

corresponding section.

►ꢀ After disconnection, replace the protective

cover over the nozzle and close the charging flap.

►ꢀ Disconnect the control unit's charging cable

from the domestic socket.

Towing device

Load distribution

Comply with the maximum authorised

towable weight, as indicated on your

vehicle's registration certificate, on the

manufacturer's label and in the Technical data

section of this guide.

Accelerated charging (mode 3)

►ꢀ Distribute the load in the trailer so that

the heaviest items are as close as possible to

the axle, and the nose weight approaches the

maximum permitted without exceeding it.

Air density decreases with altitude, thus reducing

engine performance. The maximum towable

load must be reduced by 10% per 1,000 metres of

altitude.

The end of charging is confirmed by the

accelerated charging unit (Wallbox) and when the

green light guides in the flap come on fixed.

►ꢀ After disconnection, replace the nozzle on to

the charging unit and close the charging flap.

If using accessories attached to the

towing device (e.g. bicycle carriers, tow

boxes):

Deferred charging

– Comply with the maximum authorised nose

weight.

Settings

Use genuine towing devices and wiring

harnesses approved by the Manufacturer.

With NAVIGATION

Practical information -> Charging the traction battery (Rechargeable hybrid) for Your DS 9 4 Door First Generation (2020-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals