Get Starting and Driving -> Electronic Cruise Control Guide for Fiat 500 C 2 Door Second Generation (2021-2025)

SETTING THE DESIRED

SPEED

DECREASING SPEED

ELECTRONIC

CRUISE CONTROL

To decrease the speed with the device

activated, turn the ring B downwards.

Proceed as follows:

(for versions/markets, where provided)

This device can be used at speeds

higher than 30 km/h

activate the device by turning the

ring C fig. 81 downwards.

RECALLING THE SPEED

For versions with Dualogic transmission

operating in D mode (Drive -

automatic), press and release button A

(CANC/RES) fig. 81 to recall the

previously set speed.

For versions with manual gearbox or

Dualogic transmission in sequential

mode, before recalling the previously

set speed you should accelerate until

getting close to it, then press and

release button A (CANC/RES).

when the vehicle has reached the

desired speed, turn the ring B upwards

(or downwards) and release it to

activate the device. When the

accelerator is released, the vehicle will

automatically maintain the selected

speed.

If needed (e.g. when overtaking), you

can increase speed simply by pressing

the accelerator; when you release the

pedal, the car goes back to the speed

stored previously.

When travelling downhill with the device

active, the vehicle speed may slightly

exceed the set one.

IMPORTANT Before turning the ring B

upwards or downwards, the vehicle

must travel at a constant speed on level

ground.

ACTIVATING THE DEVICE

134) 135) 136)

To turn the device on, turn the ring C

fig. 81 to the

position.

Device activation is indicated by the

symbol lighting up.

DEACTIVATING THE

DEVICE

Lightly pressing the brake pedal or

pressing button A (CANC/RES)

deactivates the electronic Cruise

Control without deleting the stored

speed.

F0S0624

Changing gear deactivates the Cruise

Control.

The device cannot be engaged in 1^stor

reverse gear: it is advisable to engage

it in 3^rdgear or higher.

IMPORTANT It is dangerous to leave

the device on when it is not in use.

There is a risk of inadvertently activating

it and losing control of the car due to

unexpected excessive speed.

SPEED INCREASE

DEACTIVATING THE

DEVICE

Once the electronic Cruise Control has

been activated, the speed can be

increased by turning the ring B

upwards.

The electronic Cruise Control is

disabled by turning the ring C fig. 81 to

the 0 position or putting the starter

switch at STOP

105

The frequency of the acoustic signal:

PARKING SENSORS

(for versions/markets, where provided)

increases as the distance between

car and obstacle decreases

WARNING

becomes continuous when the

distance between the car and

the obstacle is less than 30 cm and

stops immediately if the distance

increases

134) When travelling with the device active,

137)

never move the gear lever to neutral.

135) In case of a malfunction or failure of

the device, contact a Fiat Dealership.

47) 48)

136) The electronic Cruise Control can be

dangerous if the system cannot keep a

constant speed. In specific conditions

speed may be excessive, resulting in the

risk of losing control of the vehicle and

causing accidents. Do not use the device

in heavy traffic or on winding, icy, snowy or

slippery roads.

SENSORS

is constant if the distance between

the vehicle and the obstacle is

unchanged. If this situation concerns

the side sensors, the signal will stop

after approximately 3 seconds to avoid,

for example, indications in the event

of manoeuvres along a wall.

Parking sensors are located in the rear

bumper fig. 82 and detect and inform

the driver, through an intermittent

acoustic signal, of the presence of

obstacles at the rear of the car.

If several obstacles are detected by the

sensors, only the nearest one is

considered.

INDICATIONS ON

DISPLAY

(versions with colour display)

When the sensors are activated, the

screen shown in fig. 83 appears on the

display.

F0S0578

The system indicates a detected

obstacle by displaying an arc according

to the distance of the obstacle and its

position in relation to the car.

When the system detects an obstacle,

an arc appears in one or more positions

according to the distance of the

obstacle from the car.

ACOUSTIC SIGNAL

When reverse gear is engaged and

there is an obstacle behind the car an

acoustic warning is activated and

the warning varies as the distance of

the obstacle from the bumper varies.

106

Starting and Driving -> Electronic Cruise Control for Your Fiat 500 C 2 Door Second Generation (2021-2025)

Related Topics

Starting and Driving

Popular Owner Manuals

Latest Owner Manuals