Get Starting and Driving -> Speed Limiter Guide for Fiat 500 C 2 Door Second Generation (2021-2025)

132) We recommend that you remove the

key from the ignition if other people remain

in the vehicle. Exit from the vehicle only

after having removed the ignition key

or having rotated it to the STOP position.

During refuelling, make sure that the engine

is off and that the ignition key is in the

STOP position.

SPEED LIMITER

(for versions/markets, where provided)

ACTIVATING THE DEVICE

To turn the device on, turn the ring C

fig. 80 to the

position.

133) For cars with Dualogic transmission, if

the engine is automatically stopped on a

slope, the engine should be restarted

by moving the gear lever to + or – without

releasing the brake pedal. For cars with

Dualogic transmission, where the Hill

Holder function is present, in the case of

car stopped on a slope, the engine does

not cut off automatically, so as to make the

Hill Holder function - which is active only

when the engine is running - available.

F0S0519

WARNING

130) If the battery needs to be replaced,

always contact a Fiat Dealership. Replace

the battery with one of the same type

(HEAVY DUTY) and with the same

specifications.

F0S0624

WARNING

When the device is enabled, it is

indicated by the symbol being

shown on the display along with the

last speed set.

131) Before opening the bonnet, make

sure that the vehicle is switched off and the

key is in the STOP position. Please follow

the instructions on the decal near the front

crossmember. It is advisable to extract

the key when there are other people in the

car. The car should always be left after

the key has been removed or turned to the

STOP position. When refuelling, make

sure that the car is switched off with the

key in the STOP position.

46) If the climate comfort is to be favoured,

the Start&Stop system can be deactivated,

for a continuous operation of the climate

control system.

SPEED LIMIT

PROGRAMMING

The minimum speed that can be set is

30 km/h.

Turn on the speed limiter by turning the

ring C to the

position.

The speed limit can be programmed

without necessarily activating the

device.

103

To store a speed value higher than

that displayed

Deactivating the device

when the device cannot reduce the

vehicle speed due to the gradient of the

road (with acoustic warning);

Press button A (CANC/RES) fig. 80 .

Device deactivation is indicated by the

set being replaced by the word CANC.

Turn the ring B fig. 80 upwards (SET +

position). On releasing the ring B, the

speed increments by 1 km/h. Holding it

in the SET + position, the speed

continuously increments in steps of 5

km/h.

in the event of sharp acceleration.

DEACTIVATING THE

DEVICE

Reactivating the device

press and release button A

(CANC/RES) fig. 80 or,

To disable the device, turn the ring C

fig. 80 to the 0 position.

if the car speed is in the range 30 to

130 km/h, turn the ring B upwards or

downwards.

To store a speed value lower than

that displayed

Automatic off of the device

The device deactivates automatically in

the event of fault in the system. In this

case, contact a Fiat Dealership.

Turn the ring B downwards (SET-

position). On releasing the ring B, the

speed decrements by 1 km/h. Holding

it in the SET - position, the speed

continuously decrements in steps of 5

km/h.

EXCEEDING THE

PROGRAMMED SPEED

By fully depressing the accelerator

pedal, the programmed speed can be

exceeded even with the device active

(e.g. in the event of overtaking).

AUTOMATIC RESET OF

THE PROGRAMMED

SPEED

With the Speed Limiter enabled,

pressing button A (CANC/RES) fig. 80

at a higher speed than the set value,

the engine torque will be reduced

as required to reach that value, if it was

not reached within 20 seconds from

pressing the button.

DEVICE ACTIVATION/

DEACTIVATION

The device is disabled until the speed

drops below the set limit, after which

it reactivates automatically.

Activating the device

press and release button A

(CANC/RES) fig. 80 or,

FLASHING OF

PROGRAMMED SPEED

if the car speed is in the range 30 to

130 km/h, turn the ring B upwards or

downwards.

The programmed speed flashes in the

following cases:

when the accelerator pedal has

been fully depressed and the car has

exceeded the programmed speed;

The function is activated with the

current speed set as the speed limit.

Device activation is indicated by the

activating the system after setting a

limit below the effective vehicle speed

(with acoustic warning);

symbol

being shown on the display

along with the last speed limit set.

104

Starting and Driving -> Speed Limiter for Your Fiat 500 C 2 Door Second Generation (2021-2025)

Related Topics

Starting and Driving

Popular Owner Manuals

Latest Owner Manuals