Advertisement

Advertisement

Starting and Driving -> Manual Transmission for Your Fiat 500 C 2 Door Second Generation (2021-2025)

Press the brake pedal when carrying  
out this operation to prevent the car  
from moving accidentally.  
IMPORTANT Reverse can only be  
engaged when the vehicle is completely  
stationary. With the engine running,  
wait for at least 2 seconds with the  
clutch pedal fully depressed before  
engaging reverse to prevent damage to  
the gears and grating.  
MANUAL  
TRANSMISSION  
(for versions/markets, where provided)  
127)  
WARNING  
41)  
124) The car should be braked after a few  
clicks of the lever, if it is not, contact a  
Fiat Dealership to have it adjusted.  
To engage the gears, press the clutch  
pedal fully and put the gear lever into  
the required position (the diagram  
for gear engagement is shown on the  
lever knob fig. 75).  
IMPORTANT The clutch pedal should  
be used only for gear changes. Do  
not drive with your foot resting on the  
clutch pedal, however lightly. For  
versions/markets where provided, the  
electronic clutch control could cut  
in, interpreting the incorrect driving style  
as a fault.  
125) Never leave children in the  
unattended car. Always remove the ignition  
key when leaving the car and take it out  
with you.  
126) In the case of parking manoeuvres on  
roads on a gradient, the front wheels  
must be steered towards the pavement  
(when parking downhill), or in the opposite  
direction if the vehicle is parked uphill.  
Block the wheels with a wedge or a stone if  
the car is parked on a steep slope.  
WARNING  
127) Press the clutch pedal fully to change  
gears correctly. It is therefore essential  
that there is nothing under the pedals:  
make sure the mats are lying flat and do  
not get in the way of the pedals.  
F0S0597  
75  
For cars provided with 6-speed  
gearbox, to engage the 6th gear,  
operate the lever by pressing it towards  
the right in order to avoid engaging  
the 4th gear by mistake. The same  
applies to the shift from 6th to 5th gear.  
To engage reverse R from neutral, lift  
the sliding ring A fig. 75 under the knob  
and shift the lever to the right and  
back.  
WARNING  
41) Do not drive with your hand resting on  
the gear lever as the force exerted, even  
if slight, could lead over time to premature  
wear of the gearbox internal components.  
99