STARTING AND DRIVING -> Parking Sensors for Your Fiat Panda SUV Fourth Generation (2024-2026)

the tow hook socket of the car. The  
sensors are automatically reactivated  
when the trailer's cable plug is  
removed.  
may affect parking sensor system  
performance;  
PARKING SENSORS  
129)  
42)  
the presence of a tow hook without  
trailer interferes with the correct  
operation of the parking sensors. If a  
fixed tow hook is installed, the sensors  
cannot be used. If the customer installs  
a removable tow hook, it should be  
disconnected from the crossmember  
whenever the trailer is not attached to  
prevent the activation of the sensors.  
SENSORS  
The sensors are located in the rear  
bumper fig. 123 and their function is to  
detect the presence of any obstacles  
near the rear part of the car and inform  
the driver, through an intermittent  
acoustic warning.  
GENERAL WARNINGS  
When parking, take the utmost care  
over obstacles that may be above or  
under the sensor.  
Objects close to the car are not  
detected under certain circumstances  
and could therefore cause damage to  
the car or be damaged.  
ACOUSTIC WARNING  
When reverse gear is engaged and  
there is an obstacle behind the car an  
acoustic warning is activated and the  
warning varies as the distance of the  
obstacle from the bumper varies.  
The frequency of the acoustic warning:  
increases as the distance between  
car and obstacle decreases  
The following conditions may influence  
the performance of the parking  
assistance system:  
the presence of ice, snow, mud or  
multiple layers of paint on the surface  
of the sensor may reduce its sensitivity  
and the system performance;  
mechanical interference (e.g.  
123  
F1D0045  
becomes continuous when the  
washing the vehicle, rain, strong  
wind, hail) may cause the sensor to  
detect a non-existent obstacle ("echo  
interference");  
the presence of ultrasonic systems  
(e.g. pneumatic brake systems of  
trucks or pneumatic drills) near the  
vehicle could alter the signals sent to  
the sensor;  
the variation in sensor position,  
caused by variation in ride (due to  
suspension or shock absorber wear),  
changing tyres, overloaded car, or  
tuning that lowers the car, for example,  
ACTIVATION/  
DEACTIVATION  
distance between the car and the  
obstacle is less than 30 cm and stops  
immediately if the distance increases  
is constant if the distance between  
the car and the obstacle is unchanged.  
The sensors are automatically activated  
when reverse gear is engaged. The  
acoustic warning becomes more  
frequent as the obstacle behind the car  
gets closer.  
Detection distances  
If several obstacles are detected by  
the sensors, only the nearest one is  
considered.  
OPERATION WITH A  
TRAILER  
The operation of the sensors is  
automatically deactivated when the  
trailer electric cable plug is inserted in  
115  
FAULT INDICATIONS  
Any malfunction of the parking sensors  
REFUELING PROCEDURE  
WARNING If the filler compartment is  
washed with a high-pressure jet, keep  
it at a distance of at least 20 cm.  
REFUELLING THE  
CAR  
is indicated by the warning light  
on  
130) 131) 132)  
the instrument panel when reverse gear  
is engaged. See the "Indicators and  
messages” chapter.  
Always stop the engine before  
refuelling.  
The refuelling procedure described  
below is illustrated on the label (B)  
fig. 124 located inside the fuel flap.  
The label also indicates the fuel type  
(UNLEADED FUEL=petrol).  
To refuel proceed as follows:  
open the flap (A) fig. 124 pulling it  
outwards;  
introduce the nozzle in the filler and  
refuel;  
once refuelling is complete, before  
removing the fuel nozzle, wait at least  
10 seconds to allow the fuel to flow into  
the tank;  
PETROL ENGINES  
Only use unleaded petrol, with an  
octane number (R.O.N.) not lower  
than 95. In order to prevent damage  
to the catalytic converter never  
introduce even the smallest amount of  
leaded petrol, even in the event of an  
emergency.  
WARNING  
129) Parking manoeuvres, however, are  
always the driver’s responsibility. While  
carrying out these manoeuvres, always  
make sure that no people (especially  
children) or animals are in the area  
concerned. The parking sensors are used  
to assist the driver, who must never allow  
his attention to lapse during potentially  
dangerous manoeuvres, even those  
executed at low speeds.  
WARNING An inefficient catalytic  
converter leads to harmful exhaust  
emissions, thus contributing to air  
pollution.  
then remove the nozzle from the filler  
and close flap (A).  
IMPORTANT  
WARNING Never introduce leaded  
petrol to the tank, even in small  
amounts in an emergency, as this  
would damage the catalytic converter  
beyond repair.  
42) For correct operation of the system,  
sensors must always be clean from mud,  
dirt, snow or ice. Be careful not to scratch  
or damage the sensors while cleaning  
them. Avoid using dry, rough or hard  
cloths. The sensors must be washed using  
clean water, with the addition of vehicle  
shampoo if necessary. When using special  
washing equipment such as high pressure  
jets or steam cleaning, clean the sensors  
very quickly keeping the jet more than 10  
cm away.  
REFUELLING CAPACITY  
To ensure that you fill the tank  
completely, top up twice after the first  
click of the fuel supply gun. Further  
top-ups could cause faults in the fuel  
feeding system.  
124  
F1D1018  
116