STARTING AND DRIVING -> Saving Fuel for Your Fiat Panda SUV Fourth Generation (2024-2026)

An electric brake (or electric winch)  
should be supplied directly by the  
conventional battery through a cable  
with a cross section of no less than 2.5  
Roof rack/ski rack  
WARNING  
Remove the roof rack or the ski  
rack from the roof after use. These  
accessories lower aerodynamic  
penetration and adversely affect  
consumption levels. When transporting  
particularly large objects, use a trailer if  
possible.  
133) The ABS with which the car is  
equipped will not control the braking  
system of the trailer. Particular caution is  
required on slippery roads.  
134) Never modify the braking system  
of the vehicle to control the trailer brake.  
The trailer braking system must be fully  
independent of the vehicle’s hydraulic  
system.  
2
mm .  
In addition to the electrical branches,  
the car electrical system can only be  
connected to the supply cable for an  
electric brake and to the cable for  
an internal light for the trailer, not  
exceeding 15 W. For connections,  
use the preset control unit with a  
conventional battery cable with section  
Electric devices  
Use electrical devices only for the  
amount of time needed. The heated  
rear window, additional headlights,  
windscreen/rear window wipers and  
heater fan need a considerable amount  
of energy, therefore increasing fuel  
consumption (by up to 25% in the  
urban cycle).  
SAVING FUEL  
2
not less than 2.5 mm .  
Here are some suggestions which  
may help you save fuel and lower the  
amount of harmful emissions released  
into the atmosphere.  
On Panda Cross and Panda 4x4  
versions, in the event of prolonged  
vehicle use at maximum tow capacity  
on slopes, replacing engine oil more  
frequently (every 10,000 km) is  
advisable.  
GENERAL INFORMATION  
Vehicle maintenance  
Climate control module  
The use of the climate control system  
leads to higher fuel consumption. If the  
temperature outside permits, try to use  
ventilation only.  
Have checks and adjustments carried  
out in accordance with the “Scheduled  
Servicing Plan”.  
WARNING The use of auxiliary loads  
other than external lights (electric  
brake, winch, etc.) must take place  
with engine running.  
Tyres  
Devices for aerodynamic control  
The use of non-certified spoilers may  
adversely affect air drag and fuel  
consumption.  
Check the tyre pressures at least once  
every four weeks: if the pressure is too  
low, consumption levels increase as  
resistance to rolling is higher.  
WARNING To install a tow hook  
contact a Fiat Dealership.  
DRIVING STYLE  
Start  
Unnecessary loads  
Do not travel with an overloaded  
boot. The weight of the vehicle and  
its arrangement greatly affect fuel  
consumption and stability.  
Do not warm the engine with the  
car at a standstill or at idle or high  
speed: under these conditions the  
engine warms up much more slowly,  
119  
increasing consumption and emissions.  
It is therefore advisable to move off  
immediately, slowly, avoiding high  
speeds: in this way the engine will  
warm up more quickly.  
CONDITIONS OF USE  
Cold starting  
Short journeys and frequent cold  
starts do not allow the engine to reach  
optimum operating temperature.  
Consequently, both consumption (from  
+15 to +30% on the urban cycle) and  
emissions will increase.  
Unnecessary actions  
Avoid accelerating when stopped at  
traffic lights or before switching off the  
engine. This action and also double  
declutching is absolutely pointless  
on modern cars and also increases  
consumption and pollution.  
Traffic and road conditions  
Rather high consumption levels are  
linked to situations with heavy traffic,  
for instance when travelling in queues  
with frequent use of the lower gears or  
in cities with many traffic lights.  
Winding mountain roads and rough  
road surfaces also adversely affect  
consumption.  
Gear selection  
As soon as the conditions of the traffic  
and road permit, use a higher gear.  
Using a low gear for faster acceleration  
will increase fuel consumption.  
In the same way improper use of a high  
gear increases consumption, emissions  
and engine wear.  
Stops in traffic  
During prolonged hold-ups (e.g. level  
crossings) the engine should be  
switched off.  
Top speed  
Fuel consumption increases  
considerably with speed. Maintain a  
constant speed, avoiding unnecessary  
braking and acceleration, which cost in  
terms of both fuel consumption and  
emissions.  
Acceleration  
Accelerating violently will greatly  
affect consumption and emissions:  
acceleration should be gradual.  
120