Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

Practical information -> Charging the traction battery (Electric) for Your Fiat Scudo Van Third Generation (2022-2025)

Practical information  
Accelerated charging, mode 3  
Superfast charging, mode 4  
Charging cable, mode 3 (AC)  
7
Accelerated charging unit (depending on  
version)  
(accelerated charging - single-phase or three-  
phase alternating current (AC))  
Fast public charger  
(superfast charging - direct current (DC))  
In mode 3 with an accelerated charging unit:  
32 A maximum charging current.  
Charging cable, mode 4 (DC)  
(integrated into the fast public charger)  
Identification labels C on the charging  
connector (vehicle side) and on the socket  
(charger side).  
In mode 3 with an accelerated charging unit  
(Wallbox): 32 A maximum charging current.  
Accelerated charging unit  
Do not disassemble or modify the  
charging unit - Risk of electrocution and/or  
fire!  
Identification label K on the charging  
connector (vehicle side).  
Only use fast public chargers where the cable  
length does not exceed 30 metres.  
Refer to the charging unit manufacturer's user  
manual for the operating instructions.  
Charging the traction  
battery (Electric)  
To recharge, connect the vehicle to a domestic  
electricity supply (domestic or accelerated  
charging) or to a fast public charger (superfast  
charging).  
183  
Practical information  
For a full charge, follow the desired charging  
procedure without pausing it, until it ends  
automatically. Charging can be either immediate  
or deferred (except fast public charger, mode 4).  
You can stop domestic or accelerated charging  
at any time by unlocking the vehicle and  
removing the nozzle. For superfast charging,  
refer to the fast public charger.  
sure the traction battery has a sufficient  
charge level.  
issued by the International Commission on Non-  
Ionizing Radiation Protection (ICNIRP - 1998  
Guidelines).  
Low load / Parking  
Wearers of pacemakers or equivalent  
devices  
If the outside temperature is negative,  
it is recommended not to park your vehicle  
outside for several hours at a low load (less  
than 20%).  
Ask your doctor about what precautions  
you should take, or ask the manufacturer  
of your implanted electro-medical device about  
whether its operation is guaranteed in an  
environment which complies with the ICNIRP  
recommendations.  
For more information on the charging displays  
on the Instrument panel and the Touch screen,  
refer to the corresponding section.  
Vehicle immobilised for 1 to 12  
months  
Discharge the traction battery down to 2 or  
3 bars on the charge level indicator on the  
instrument panel.  
For more information on Remote  
functions, refer to the corresponding  
section.  
If in doubt  
Domestic or accelerated charging: do  
not remain inside or near the vehicle, or near  
the charging cable or charging unit, even for  
a short time.  
Do not connect the charging cable.  
Always park the vehicle in a place with  
temperatures between -10°C and 30°C  
(parking in a place with extreme temperatures  
can damage the traction battery).  
Disconnect the cable from the (+) terminal  
of the accessory battery in the engine  
compartment.  
Connect a 12 V battery charger to the (+)  
and (-) terminals of the accessory battery  
about every 3 months in order to recharge the  
accessory battery and maintain an operating  
voltage.  
As a safety measure, the engine will not  
start if the charging cable is plugged into  
the connector on the vehicle. A warning is  
displayed on the instrument panel.  
For domestic or accelerated charging  
Before charging  
Depending on the context:  
Cooling the traction battery  
The cooling fan in the engine  
compartment comes on during charging to  
cool the on-board charger and the traction  
battery.  
► Have a professional check that the  
electrical system to be used complies with  
applicable standards and is compatible with  
the vehicle.  
► Have a professional electrician install  
a dedicated domestic power socket or  
accelerated charging unit (Wallbox)  
compatible with the vehicle.  
Low load / Driving  
Driving when the charge level of the  
traction battery is too low can lead to the  
vehicle breaking down and can lead to  
accidents or serious injuries. ALWAYS make  
Precautions  
Our electric vehicles have been developed in  
accordance with the recommendations on the  
maximum limits for electromagnetic fields, as  
You should preferably use the charging cable  
available as an accessory.  
184  
Practical information  
For more information, contact a Fiat  
Dealership or a qualified workshop.  
– -20°C, charging is still possible, but  
charging times may be extended even further  
(the battery has to be heated first).  
When the connection is made, all of the indicator  
lamps on the control unit light up, then only the  
POWER indicator lamp remains on in green.  
► Remove the protective cover from the  
charging nozzle.  
► Insert the nozzle into the charging connector.  
The start of charging is confirmed by the flashing  
green CHARGE indicator lamps in the flap, then  
those on the control unit.  
If this is not the case, charging has not  
started; restart the procedure, ensuring that all  
connections are properly established.  
The red indicator lamp in the flap comes on to  
indicate that the nozzle is locked.  
7
During charging  
While charging is in progress, unlocking  
the vehicle will cause the charging to stop.  
If no action is taken on one of the openings  
(door or boot) or on the charging nozzle, the  
vehicle will lock again after 30 seconds and  
charging will resume automatically.  
Never work under the bonnet:  
– Some areas remain very hot, even an hour  
after charging ends - risk of burns!  
– The fan may start at any time - risk of cuts  
or strangulation!  
After charging  
Check that the charging flap is closed.  
Connection  
► Before charging, check that the drive selector  
is in mode P, otherwise charging is not possible.  
► Open the charging flap by pressing the  
push-button, and check that there are no foreign  
bodies on the charging connector.  
Domestic charging, mode 2  
When charging is complete and while the  
charging cable is still connected, opening  
the driver's door will display the charge level  
on the instrument panel for about 20 seconds.  
After charging  
Check that the charging flap is closed.  
Do not leave the cable connected to the  
domestic power socket - risk of short-circuit  
or electrocution in the event of contact with or  
immersion in water!  
Accelerated charging, mode 3  
For superfast charging  
Before charging  
Check that the fast public charging  
station and its charging cable are compatible  
with the vehicle.  
If the exterior temperature is below:  
– 0°C, charging times may be extended.  
► Follow the accelerated charging unit  
(Wallbox) user instructions.  
► Remove the protective cover from the  
charging nozzle.  
► Connect the charging cable from the control  
unit to the domestic socket.  
► Insert the nozzle into the charging connector.  
185  
Practical information  
The start of charging is confirmed when the  
charging indicator lamp in the flap flashes green.  
If this is not the case, charging has not started;  
restart the procedure, ensuring that the  
connection has been properly established.  
The red indicator lamp in the flap comes on to  
indicate that the nozzle is locked.  
► Lock the vehicle.  
Deferred charging  
Settings  
► Press this button in the flap within one  
minute to activate the system (confirmed by the  
charging indicator lamp coming on in blue).  
At a Fiat Dealership or qualified workshop,  
with Bluetooth® audio system  
Disconnection  
By default, the deferred charging start time is set  
to midnight (vehicle time).  
You can have the deferred charging start time  
modified.  
Superfast charging, mode 4  
Visit a Fiat Dealership or a qualified workshop.  
In the vehicle, with Connect Nav  
Before disconnecting the nozzle from the  
charging connector:  
► If the vehicle is unlocked, lock it and then  
unlock it.  
► If the vehicle is locked, unlock it.  
The red indicator lamp in the flap goes out to  
confirm that the charging nozzle is unlocked.  
► In modes 2 and 3, remove the charging  
nozzle within 30 seconds.  
► In the Energy touch screen menu,  
select the Charge page.  
► Set the charging start time.  
► Press OK.  
► Depending on version, remove the protective  
cover from the lower part of the connector.  
► Follow the instructions for use of the fast  
public charger and connect the cable from the  
fast public charger to the vehicle's connector.  
The start of charging is confirmed by the flashing  
green charging indicator lamp in the flap.  
If this is not the case, charging has not started;  
restart the procedure, ensuring that the  
connection is properly established.  
The setting is saved in the system.  
Activation  
Deferred charging is only possible with  
modes 2 and 3.  
The charging indicator lamp comes on in white.  
► After programming the deferred charging,  
connect your vehicle to the desired charging  
equipment.  
With selective door unlocking activated,  
press the unlocking button twice to  
disconnect the charging nozzle.  
The red indicator lamp in the flap comes on to  
indicate that the nozzle is locked.  
When charging is complete, the green  
charging indicator lamp in the flap goes  
out after about 2 minutes.  
186