Get STARTING AND DRIVING -> DAA (Driver Attention Assist) SYSTEM Guide for Fiat Tipo 4 Door Second Generation (2015-2026)

speed level stored by the Speed

Limiter, message will appear on the

instrument panel.

The system is disabled until the speed

drops below the set limit, after which it

activates again automatically.

SYSTEM ACTIVATION

If the driver has selected the

SETTINGS

The system settings can be changed

through the Uconnect™ or

Uconnect™ 7" HD system (see

"Settings" > "Safety & Driving Assist" >

"Intelligent Speed Assist").

confirmation capture option on the

Uconnect™ or Uconnect™ 7" HD

system settings (see "Settings" >

"Safety & Driving Assist" > "Intelligent

Speed Assist"), upon recognition of

a new speed limit, the "Traffic Sign

Recognition" system will suggest

the new limit via a message on the

instrument cluster display.

140

P2001037

DAA (Driver

Attention Assist)

SYSTEM

SYSTEM DEACTIVATION

The system is deactivated under the

following conditions:

(where provided)

when the Traffic Sign Recognition

system is deactivated;

when the Speed Limiter system is

deactivated;

when the Traffic Sign Recognition

system shows a new speed limit;

when the Traffic Sign Recognition

system shows the end of the speed

limit;

The driver can accept the new limit

pressing the button (1) fig. 140 within

the first 5 seconds of the new road sign

appearing to set the new system speed

limit to the speed suggested by the

sign.

This is an auxiliary driving assistance

system that detects when the driver is

tired.

Activation / deactivation

The system can be

activated/deactivated using the

"Settings" menu of the Uconnect™

or Uconnect 7" HD system and then

selecting "Safety/Driving Assistance"

and finally "Driver Attention Assist".

The AAD system settings are

reactivated each time the engine is

started.

Activation is indicated by the symbol

on the display (e.g. in the case of

a 30 km/h speed limit) and the green

circle around the road sign indicating

the speed limit.

when the Traffic Sign Recognition

system cannot display any speed limit.

EXCEEDING THE

PROGRAMMED SPEED

By fully depressing the accelerator

pedal, the programmed speed can be

exceeded even with the system active

(e.g. in the event of overtaking).

System intervention

The system intervenes if the camera in

the centre of the windscreen detects

that the driver is tired, based on

138

variations in car trajectory and getting

too close to the side of the road.

REAR CAMERA

(ParkView Rear

Backup Camera)

The (red)

symbol appears on

the instrument panel screen with a

dedicated message suggesting the

driver to stop and take a break. An

acoustic warning is also emitted.

If the driver accepts the suggestion

provided by the system and stops for

a pause, the message will disappear

(where provided)

DESCRIPTION

The rear view camera (1) fig. 141 is

located on the luggage compartment

tailgate.

142

07186J0002EM

from the display and the symbol

be displayed in the dedicated area of

the instrument panel display up to the

next engine shutdown/restart.

If the driver ignores the warning

provided by the system and does

not stop, the message will remain on

the instrument panel display until the

OK button located on the left hand

side controls of the steering wheel is

will

The images are shown on the display

together with a warning message.

With the "Camera Delay” option active,

when engaging the reverse gear, the

image from the camera will continue to

be displayed for up to 10 seconds after

reverse is disengaged, unless vehicle

speed is higher than 13 km/h, or:

- that the gearbox lever is in neutral;

- the ignition device is in position

STOP.

141

P2000016-000-000

pressed. The symbol

, will remain

133)

53)

displayed in the dedicated area of the

instrument panel display.

If the "Camera Delay" setting is active

on the Uconnect™ system, when the

gear lever is no longer in the reverse

position, a button for deactivating the

display of the image from the camera

appears on the Uconnect™ system

display along with the camera images.

NOTE The displayed image may look a

bit distorted.

Camera activation/deactivation

Every time reverse is engaged, the

display fig. 142 shows the area around

the car, as seen by the rear camera.

WARNING In the event of a system

fault, the amber

symbol appears on

the instrument panel display together

with a dedicated message.

139

STARTING AND DRIVING -> DAA (Driver Attention Assist) SYSTEM for Your Fiat Tipo 4 Door Second Generation (2015-2026)

Related Topics

STARTING AND DRIVING

Popular Owner Manuals

Latest Owner Manuals