In these cases, the heat engine can
only be started using the ignition
device.
When the device is enabled, it is
indicated by the symbol being
shown on the display and the last
speed set.
for a continuous operation of the climate
control system.
NOTE In any case, it is possible to
keep the heat engine running by
deactivating the system.
SPEED LIMITER
If the electronic Cruise Control has
been activated previously, button (1)
fig. 127 must be pressed twice.
The first press switches off the function
activated previously; the second press
activates the Speed Limiter.
(where provided)
DESCRIPTION
IRREGULAR OPERATION
In the event of malfunction, the
Start&Stop system is deactivated.
For failure indications, see the "Warning
lights and messages" paragraph,
"Knowing the instrument panel"
chapter.
This device allows the speed of the car
to be limited to values which can be set
by the driver.
The maximum speed can be set both
with car stationary and in motion. The
minimum speed that can be set is
30 km/h.
SPEED LIMIT
PROGRAMMING
The speed limit can be programmed
without necessarily activating the
device.
When the device is active, the car
speed depends on the pressure
at the accelerator pedal, until the
programmed speed limit is reached
(see "Speed limit programming"
paragraph).
IMPORTANT
To store a speed value higher than
the displayed one, briefly press the
SET + button. Each time the button
is pressed, the speed increases by
about 1 km/h while keeping the button
pressed, the speed increases by
5 km/h intervals.
125) Before opening the bonnet, make
sure that the engine is off and that the
starter switch is in the STOP position.
Follow the indications on the plate
underneath the bonnet. We recommend
that you remove the key from the ignition if
other people remain in the vehicle. The
vehicle should always be left after the key
has been removed or turned to the STOP
position. During refuelling, make sure that
the engine is off (ignition device in the
STOP position).
ACTIVATING THE DEVICE
To activate the device press button (1)
fig. 127 on the steering wheel.
To store a lower speed value than the
displayed one, press the SET – button.
Each time the button is pressed, the
speed decreases by about 1 km/h
while keeping the button pressed, the
speed decreases by 5 km/h intervals.
DEVICE
WARNING
ACTIVATION/DEACTIVATION
Device Activation: press the SET + or
SET – buttons, at a speed between 30
and 130 km/h, to set the current car
38) If climate comfort is to be favoured,
the Start&Stop system can be deactivated,
127
P2000319
127
English 
