2009-2015 Honda Jazz 4 Door Driver and Passenger Safety -> 5. Fasten and Position the Seat Belts User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driver and Passenger Safety -> 5. Fasten and Position the Seat Belts for Your Honda Jazz 4 Door Second Generation (2009-2015)

07/09/12 09:13:33 32SAA650_021  
Protecting Adults  
5.Fasten and Position the Seat  
Belts  
If necessary, pull up on the belt again  
to remove any slack, then check that  
the belt rests across the centre of  
your chest and over your shoulder.  
Using a Lap/Shoulder Belt  
Insert the latch plate into the buckle,  
then tug on the belt to make sure the  
belt is securely latched. Check that  
the belt is not twisted, because a  
twisted belt can cause serious  
injuries in a crash.  
This spreads the forces of a crash  
over the strongest bones in your  
upper body.  
In the rear centre seating position,  
be sure the detachable anchor is  
latched securely (see page 131 ).  
Improperly positioning the  
seat belts can cause serious  
injury or death in a crash.  
Position the lap part of the belt as  
low as possible across your hips,  
then pull up on the shoulder part of  
the belt so the lap part fits snugly.  
This lets your strong pelvic bones  
take the force of a crash and reduces  
the chance of internal injuries.  
Make sure all seat belts are  
properly positioned before  
driving.  
18  
Driver and Passenger Safety  
Downloaded from engine  
07/09/12 09:13:41 32SAA650_022  
Protecting Adults  
Never place the shoulder portion of a  
lap/shoulder belt under your arm or  
behind your back. This could cause  
very serious injuries in a crash.  
Using the Lap Belt  
(For some types)  
RELEASE BUTTON  
If the seat belt touches or crosses  
your neck, or if it crosses your arm  
instead of your shoulder, you need to  
adjust the seat belt anchor height.  
Insert the latch plate into the buckle  
marked CENTER.  
To adjust the height of a front seat  
belt anchor, squeeze the two release  
buttons and slide the anchor up or  
down as needed (it has four  
positions).  
If the belt is too short, hold the latch  
plate at a right angle and pull on the  
plate to extend the belt. Then insert  
the latch plate into the buckle, and  
tug on the belt to make sure the belt  
is securely latched.  
CONTINUED  
19  
Driver and Passenger Safety  
Downloaded from engine  

Related Topics

Popular Owner Manuals