Get Features of your vehicle -> MANUAL CLIMATE CONTROL SYSTEM (IF EQUIPPED) Guide for Hyundai I10 4 Door Second Generation (2013-2019)

Features of your vehicle

MANUAL CLIMATE CONTROL SYSTEM (IF EQUIPPED)

■ Left-hand drive

1. Mode selection knob

2. Fan speed control knob

3. Temperature control knob

4. Air conditioning button*

5. Air intake control button

(recirculated air position)

■ Right-hand drive

6. Air intake control button

(outside (fresh) air position)

7. Rear window defroster button*

* : if equipped

OBA043151L/OBA043151

4 71

Features of your vehicle

Heating and air conditioning

■ Left-hand drive

■ Right-hand drive

1. Start the engine.

2. Set the mode to the desired position.

To improve the effectiveness of heat-

ing and cooling :

- Heating:

- Cooling:

3. Set the temperature control to the

desired position.

4. Set the air intake control to the outside

(fresh) air or recirculated air position.

5. Set the fan speed control to the

desired speed.

6. If air conditioning is desired, turn the air

conditioning system (if equipped) on.

OBA043152L/OBA043152

4 72

Features of your vehicle

■ Front - Left-hand drive

Bi-Level (B, D, C, E)

Air flow is discharged towards the face

and floor.

Floor-Level (C, A, D)

Most of the air flow is directed to the

floor, with a small amount of the air

directed to the windshield and side win-

dow defrosters.

OBA043154L

■ Front - Right-hand drive

OBA043153

Mode selection

The mode selection knob controls the

direction of the air flow through the venti-

lation system.

Floor/Defrost-Level (A, C, D)

Air can be directed to the floor, dashboard

outlets, or windshield. Five symbols are

used to represent Face, Bi-Level, Floor,

Floor-Defrost and Defrost air position.

Most of the air flow is directed to the floor

and the windshield with a small amount

directed to the side window defrosters.

OBA043154

Instrument panel vents

The outlet vents can be opened or closed

by using the vent control lever.

Also, you can adjust the direction of air

delivered from these vents using the vent

control lever as shown.

Face-Level (B, C, E)

Defrost-Level (A, C, E)

Air flow is directed toward the upper body

and face. Additionally, each outlet can be

controlled to direct the air discharged

from the outlet.

Most of the air flow is directed to the

windshield with a small amount of air

directed to the side window defrosters.

4 73

Features of your vehicle

■ Rear

■ Left-hand drive

OBA043156L

■ Right-hand drive

OBA043227IN

OBA043155

The outlet vents can be opened or closed

separately using the thumbwheel.

Also, you can adjust the direction of air

delivery from these vents using the vent

control lever as shown.

Temperature control

The temperature control knob allows you

to control the temperature of the air flow-

ing from the ventilation system. To

change the air temperature in the pas-

senger compartment, turn the knob to

the right for warm air or left for cooler air.

OBA043156

Air intake control

This is used to select outside (fresh) air

position or recirculated air position.

To change the air intake control position,

push the control button.

4 74

Features of your vehicle

Recirculated air position

The indicator light on the

WARNING

button illuminates when the

recirculated air position is

selected.

With the recirculated air

position selected, air from

the passenger compart-

ment will be drawn through

the heating system and

heated or cooled according

to the function selected.

• Continuous operation of the cli-

mate control system in the recir-

culated air position may allow

humidity to increase inside the

vehicle which may fog the glass

and obscure visibility.

• Do not sleep in a vehicle with the

air conditioning or heating system

on. It may cause serious harm or

death due to a drop in the oxygen

level and/or body temperature.

OBA043157

Fan speed control

The ignition switch must be in the ON

position for fan operation.

The fan speed control knob allows you to

control the fan speed of the air flowing

from the ventilation system. To change

the fan speed, turn the knob to the right

for higher speed or left for lower speed.

Setting the fan speed control knob to the

“0” position turns off the fan.

Outside (fresh) air position

• Continuous operation of the cli-

mate control system in the recir-

culated air position can cause

drowsiness or sleepiness, and

loss of vehicle control. Set the air

intake control to the outside

(fresh) air position as much as

possible while driving.

With the outside (fresh) air

position selected, air enters

the vehicle from outside and

is heated or cooled accord-

ing to the function selected.

✽

NOTICE

Prolonged operation of the heater in the

recirculated air position (without air

conditioning selected) may cause fog-

ging of the windshield and side windows

and the air within the passenger com-

partment may become stale.

In addition, prolonged use of the air con-

ditioning with the recirculated air posi-

tion selected will result in excessively dry

air in the passenger compartment.

4 75

Features of your vehicle

Operation Tips

■ Left-hand drive

System operation

• To prevent dust or unpleasant fumes

from entering the vehicle through the

ventilation system, temporarily set the

air intake control to the recirculated air

position. Be sure to return the control

to the fresh air position when the irri-

tation has passed to keep fresh air in

the vehicle.This will help keep the driv-

er alert and comfortable.

Ventilation

1.Set the mode to the

2.Set the air intake control to the outside

(fresh) air position.

3.Set the temperature control to the

desired position.

position.

4.Set the fan speed control to the

desired speed.

• Air for the heating/cooling system is

drawn in through the grilles just ahead

of the windshield. Care should be

taken that these are not blocked by

leaves, snow, ice or other obstructions.

OBA043158L

Heating

1.Set the mode to the

2.Set the air intake control to the outside

(fresh) air position.

■ Right-hand drive

position.

• To prevent interior fog on the wind-

shield, set the air intake control to the

fresh air position and fan speed to the

desired position, turn on the air condi-

tioning system, and adjust the temper-

ature control to a desired temperature.

3.Set the temperature control to the

desired position.

4.Set the fan speed control to the

desired speed.

5.If dehumidified heating is desired, turn

the air conditioning system (if equipped)

on.

OBA043158

• If the windshield fogs up, set the mode

Air conditioning (if equipped)

to the

,

position.

Press the A/C button to turn the air con-

ditioning system on (indicator light will

illuminate). To turn the air conditioning

system off, press the button again.

4 76

Features of your vehicle

Air conditioning system operation tips

Air conditioning (if equipped)

✽

NOTICE

• If the vehicle has been parked in direct

sunlight during hot weather, open the

windows for a short time to let the hot

air inside the vehicle escape.

All HYUNDAI Air Conditioning Systems

are filled with environmentally friendly

R-134a refrigerant.

1.Start the engine. Push the air condi-

tioning button.

• While using the air conditioning sys-

tem, monitor the temperature gauge

closely while driving up hills or in

heavy traffic when outside tempera-

tures are high. Air conditioning sys-

tem operation may cause engine over-

heating. Continue to use the blower

fan but turn the air conditioning sys-

tem off if the temperature gauge indi-

cates engine overheating.

• To help reduce moisture inside of the

windows on rainy or humid days,

decrease the humidity inside the vehicle

by operating the air conditioning system.

• During air conditioning system opera-

tion, you may occasionally notice a slight

change in engine speed as the air con-

ditioning compressor cycles. This is a

normal system operation characteristic.

• Use the air conditioning system every

month only for a few minutes to ensure

maximum system performance.

• When using the air conditioning system,

you may notice clear water dripping (or

even puddling) on the ground under the

passenger side of the vehicle. This is a

normal system operation characteristic.

2.Set the mode to the

position.

3.Set the air intake control to the recircu-

lated air position. However, prolonged

operation of the recirculated air posi-

tion will excessively dry the air. In this

case, change the air position.

4.Adjust the fan speed control and tem-

perature control to maintain maximum

comfort.

When maximum cooling is desired, set

the temperature control to the extreme

left, set the air intake control to the

recirculated air position, then set the

fan speed control to the highest speed.

• While opening the windows in humid

weather air conditioning may create

water droplets inside the vehicle.

Since excessive water droplets may

cause damage to electrical equipment,

air conditioning should only be used

with the windows closed.

• Operating the air conditioning system

in the recirculated air position provides

maximum cooling, however, continual

operation in this mode may cause the

air inside the vehicle to become stale.

• During cooling operation, you may

occasionally notice a misty air flow

because of rapid cooling and humid air

intake. This is a normal system opera-

tion characteristics.

4 77

Features of your vehicle

Checking the amount of air con-

ditioner refrigerant and compres-

sor lubricant

When the amount of refrigerant is low,

the performance of the air conditioning is

reduced. Overfilling also has a negative

impact on the air conditioning system.

Therefore, if abnormal operation is

found, we recommend that the system be

inspected by an authorized HYUNDAI

dealer.

✽

NOTICE

Outside air

• Check the filter according to the

Maintenance Schedule in chapter 7.

If the vehicle is being driven in severe

conditions such as dusty, rough roads,

more frequent climate control air filter

inspections and changes are required.

• When the air flow rate suddenly

decreases, we recommend that the

system be checked by an authorized

HYUNDAI dealer.

Recirculated

air

Climate control

air filter

Heater core

OPB049140L

Evaporator

core

Blower

✽

NOTICE

Climate control air filter

It is important that the correct type and

amount of oil and refrigerant is used.

Otherwise, damage to the compressor and

abnormal system operation may occur.

The climate control air filter installed in

your vehicle filters the dust or other pol-

lutants that come into the vehicle from

the outside through the heating and air

conditioning system. If dust or other pol-

lutants accumulate in the filter over a

period of time, the air flow from the air

vents may decrease, resulting in mois-

ture accumulation inside of the wind-

shield even when the outside (fresh) air

position is selected. If this happens, we

recommend that the climate control air

filter be checked by an authorized

HYUNDAI dealer.

WARNING

Improper service may cause seri-

ous injury to the person performing

the service. For more detailed infor-

mation, we recommend that you

contact an authorized HYUNDAI

dealer. Improper service may cause

serious injury to the person per-

forming the service.

4 78

Features of your vehicle -> MANUAL CLIMATE CONTROL SYSTEM (IF EQUIPPED) for Your Hyundai I10 4 Door Second Generation (2013-2019)

Related Topics

Features of your vehicle

Popular Owner Manuals

Latest Owner Manuals