2020-2026 Hyundai I10 4 Door Safety system -> Pre-tensioner seat belt User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Safety system -> Pre-tensioner seat belt for Your Hyundai I10 4 Door Third  Generation (2020-2026)

03  
Pre-tensioner seat belt  
(if equipped)  
OHI038142  
7o release your seat beltꢀ  
Press the release button (1) in the  
locking buckle.  
OLMB033039/H  
Your vehicle is equipped with driver’s  
and front passenger’s and rear left  
side and right side passenger’s pre-  
tensioner seat belts (Retractor Pre-  
tensioner and EFD (Emergency  
Fastening Device)).  
When it is released, the belt should  
automatically draw back into the  
retractor. If this does not happen,  
check the belt to be sure it is not  
twisted, then try again.  
The purpose of the pre-tensioner is to  
make sure the seat belts fit tightly  
against the occupant’s body in cer-  
tain frontal or side collision(s). The  
pre-tensioner seat belts may be acti-  
vated in crashes where the frontal or  
side collision(s) is severe enough,  
together with the air bags.  
Rear centre seat belt  
(if equipped)  
When the vehicle stops suddenly, or  
if the occupant tries to lean forward  
too quickly, the seat belt retractor will  
lock into position.  
OAC3039044TU  
WARNING  
When using the rear centre seat belt,  
the buckle with the “CENTER” mark  
must be used.  
Make sure that the seatback is  
locked in place when using the  
rear center seat belt.  
If not, the seatback may move  
when there is a sudden stop or col-  
lision, which could result in seri-  
ous injury.  
Information  
i
If you are not able to pull out the safety  
belt from the retractor, firmly pull the  
belt out and release it. After release,  
you will be able to pull the belt out  
smoothly.  
3-23  
Safety system  
In certain frontal collisions, the pre-  
tensioner will activate and pull the  
seat belt into tighter contact against  
the occupant’s body.  
WARNING  
‡ꢀ Always wear your seat belt and  
sit properly in your seat.  
- Retractor Pretensioner  
‡ꢀ Do not use the seat belt if it is  
loose or twisted. A loose or  
twisted seat belt will not protect  
you properly in an accident.  
The purpose of the retractor preten-  
sioner is to make sure that the  
shoulder belts fit in tightly against  
the occupant’s upper body in cer-  
tain frontal or side collision(s).  
‡ꢀ Do not place anything near the  
buckle. This may adversely affect  
the buckle and cause it to func-  
tion improperly.  
- EFD (Emergency Fastening  
Device)  
‡ꢀ Always replace your pre-tension-  
ers after activation or an acci-  
dent.  
The purpose of the EFD is to make  
sure that the pelvis belts fit in tightly  
against the occupant’s lower body  
in certain frontal or side collisions.  
(if equipped, Driver only)  
‡ꢀ NEVER inspect, service, repair  
or replace the pre-tensioners  
yourself. This must be done by a  
HYUNDAI authorised repairer.  
If the system senses excessive ten-  
sion on the driver or passenger’s seat  
belt when the pre-tensioner system  
activates, the load limiter inside the  
retractor pre-tensioner will release  
some of the pressure on the affected  
seat belt.  
‡ꢀ Do not hit the seat belt assem-  
blies.  
WARNING  
Do not touch the pre-tensioner  
seat belt assemblies for several  
minutes after they have been acti-  
vated. When the pre-tensioner seat  
belt mechanism deploys during a  
collision, the pre-tensioner can  
become hot and can burn you.  
CAUTION  
If equipped with rollover sensor  
The pre-tensioner will activate not  
only in a frontal collision but also  
in a side collision or rollover, if the  
vehicle is equipped with a side or  
curtain air bag.  
CAUTION  
Body work on the front area of the  
vehicle may damage the pre-ten-  
sioner seat belt system. Therefore,  
we recommend that the system be  
serviced by a HYUNDAI authorised  
repairer.  
CAUTION  
Without rollover sensor  
The pre-tensioner will activate not  
only in a frontal collision but also  
in a side collision, if the vehicle is  
equipped with a side or curtain air  
bag.  
3-24  
03  
Rear  
„
8KMB3311/H  
OAC3039042R  
The Pre-Tensioner Seat Belt System  
consists mainly of the following com-  
ponents. Their locations are shown in  
the illustration above:  
(5) Rear retractor pre-tensioner  
assembly (if equipped)  
NOTICE  
(1) SRS air bag warning light  
The sensor that activates the SRS  
air bag is connected with the pre–  
tensioner seat belts. The SRS air  
bag warning light on the instru-  
ment panel will illuminate for  
approximately 6 seconds after the  
ignition switch is placed to the ON  
position, and then it should turn  
off.  
(2) Front retractor pre-tensioner  
assembly (if equipped)  
(3) SRS control module  
(4) Emergency fastening  
device(EFD)  
(Driver only, if equipped)  
If the pre-tensioner is not working  
properly, the warning light will illu-  
minate even if the SRS air bag is  
not malfunctioning. If the warning  
light does not illuminate, stays illu-  
minated or illuminates when the  
vehicle is being driven, we recom-  
mend the pre-tensioner seat belts  
and/or SRS air bags be inspected  
by a HYUNDAI authorised repairer  
as soon as possible.  
3-25  

Related Topics

Popular Owner Manuals