2006-2012 Kia Ceed SUV Driving your vehicle -> Starting the engine User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving your vehicle -> Starting the engine for Your Kia Ceed SUV First Generation (2006-2012)

ED English 4.qxp 10/4/2007 5:59 PM Page 5  
Driving your vehicle  
STARTING THE ENGINE  
WARNING  
Always wear appropriate shoes  
when operating your vehicle.  
Unsuitable shoes (high heels,  
ski boots,etc.) may interfere  
with your ability to use the  
brake and accelerator pedal,  
and the clutch (if equipped).  
3. Turn the ignition switch to START  
and hold it there until the engine  
starts (a maximum of 10 seconds),  
then release the key.  
CAUTION  
If the engine stalls while you are  
in motion, do not attempt to  
move the shift lever to the P  
(Park) position. If traffic and  
road conditions permit, you may  
put the shift lever in the N  
(Neutral) position while the  
vehicle is still moving and turn  
the ignition switch to the START  
position in an attempt to restart  
the engine.  
4. In extremely cold weather (below  
-18°C / 0°F) or after the vehicle  
has not been operated for several  
days, let the engine warm up with-  
out depressing the accelerator.  
Whether the engine is cold or warm,  
it should be started without  
depressing the accelerator.  
Starting the gasoline engine  
1. Make sure the parking brake is  
applied.  
2. Manual Transaxle - Depress the  
clutch pedal fully and shift the  
transaxle into Neutral. Keep the  
clutch pedal depressed while turn-  
ing the ignition switch to the start  
position.  
CAUTION  
Do not engage the starter for  
more than 10 seconds. If the  
engine stalls or fails to start,  
wait 5 to 10 seconds before re-  
engaging the starter. Improper  
use of the starter may damage  
it.  
Automatic Transaxle - Place the  
transaxle shift lever in P (Park).  
Depress the brake pedal fully.  
You can also start the engine  
when the shift lever is in the N  
(Neutral) position.  
4 5  
ED English 4.qxp 10/4/2007 5:59 PM Page 6  
Driving your vehicle  
Starting and stopping the  
engine for turbocharger  
intercooler  
Starting the diesel engine  
Glow indicator light  
To start the diesel engine when the  
engine is cold, it has to be pre-heat-  
ed before starting the engine and  
then has to be warmed up before  
starting to drive.  
1. Do not race or accelerate the  
engine immediately after starting.  
If the engine is cold, idle for sever-  
al seconds before sufficient lubri-  
cation is ensured in the tur-  
bocharger unit.  
1. Make sure the parking brake is  
applied.  
2. Manual Transaxle - Depress the  
clutch pedal fully and shift the  
Transaxle into the Neutral. Keep  
the clutch pedal depressed while  
cranking the engine.  
2. After high speed or extended driv-  
ing, requiring a heavy engine load,  
idle the engine about 1 minute  
before turning it off.  
W-60  
3. Turn the ignition switch ON posi-  
tion to pre-heat the engine. Then  
the glow indicator light will illumi-  
nate.  
This idle time will allow the tur-  
bocharger to cool prior to shutting  
the engine off.  
Automatic Transaxle - Place the  
Transaxle shift lever in P(park).  
Depress the brake pedal fully.  
4. If the glow indicator light goes out,  
turn the ignition switch to START  
and hold it there until the engine  
starts (a maximum of 10 sec-  
onds), then release the key.  
You can also start the engine when  
the shift lever is in the N(neutral)  
position.  
CAUTION  
Do not turn the engine off imme-  
diately after it has been subject-  
ed to a heavy load. Doing so  
may cause severe damage to  
the engine or turbocharger unit.  
NOTICE  
If the engine were not started within  
2 seconds after the preheating is com-  
pleted, turn the ignition key once  
more to the LOCK position during  
10 seconds, and then to the ON posi-  
tion, in order to preheat again.  
4 6  

Related Topics

Popular Owner Manuals