EMERGENCY INFORMATION
Fitting the Spare Wheel
Regularly check the spare wheel tyre
pressure, it may be underpressure due to
unused for long periods of time. After
Note: Avoid placing wheels face down on the
ground - the surface may be scratched.
5
Fit the spare wheel and tighten the wheel bolts with
wheel bolt spanner until the wheel is seated firmly
against the hub.
replacement, at the first opportunity check
and adjust the tyre pressure.
6
7
Lower the car and remove the jack, then FULLY tighten
the wheel bolts in a diagonal sequence.
The wheel bolts must be tightened to the
Finally, return the tools to the tool kit, put the tool kit
into the boot, tighten the retaining bolts, put down the
luggage carpet and put the replaced wheel above the
carpet (wheel rim face up).
specified torque after changing
a
wheel
～
(120 130 Nm).
1
Before raising the car, use the special tool supplied
with the vehicle to remove each wheel bolt cap. Use
the wheel bolt spanner to slacken each bolt half a turn
anti-clockwise.
5
Note: DO NOT stand on the handle of the wheel bolt
spanner or use extension tube on the handle of the
spanner.
2
3
Turn the handle in a clockwise direction until the tyre
is clear of the ground.
Note: When replacing the wheel, please fully tighten
the bolts in the diagonal sequence twice.
Remove the wheel bolts and place them in the tool kit
to prevent them from being lost. Make sure the vehicle
is steady and there is no risk of slip or movement
before removing wheel bolts.
Note: Contact an MG Authorised Repairer to replace
with a new tyre urgently.
4
Remove the road wheel.
285
English 
