Get Pre-driving checks and adjustments -> Door locks Guide for Nissan Juke SUV First Generation (2010-2019)

DOOR LOCKS

ing.

Mechanical key

WARNING:

— The Intelligent Key is water resistant;

however, wetting may damage the In-

telligent Key. If the Intelligent Key gets

wet, immediately wipe until it is com-

pletely dry.

Always look before opening any doors, to

avoid an accident with oncoming traffic.

Never leave children or adults who would

normally require the support of others alone

in the vehicle. They could unknowingly

activate switches or controls and inadver-

tently become involved in a serious accident.

— Do not bend, drop or strike it against

another object.

— If the outside temperature is below

−108C (148F), the battery of the Intelli-

gent Key may not function properly.

LOCKING WITH KEY

SPA2033

— Do not place the Intelligent Key for an

extended period in a place where tem-

peratures exceed 608C (1408F).

To remove the mechanical key, release the lock knob at

the back of the Intelligent Key.

To install the mechanical key, firmly insert it into the

Intelligent Key until the lock knob returns to the lock

position.

— Do not change or modify the Intelligent

Key.

— Do not use a magnet key holder.

Use the mechanical key to lock or unlock the doors.

(See “Door locks” (P.3-3).)

— Do not place the Intelligent Key near

equipment that produces

magnetic

field such as a TV, audio equipment

and personal computers.

SPA2602

To lock the door, insert the key to the door key cylinder

— Do not allow the Intelligent Key to come

into contact with water or salt water,

and turn the key to the front side of the vehicle

The driver’s side door will lock.

and do not wash it in

washing

To unlock the door, turn the key to the rear of the

machine. This could affect the system

function.

vehicle

. The driver’s side door will unlock.

If an Intelligent Key is lost or stolen, NISSAN

recommends erasing the ID code of that

Intelligent Key. This will prevent the Intelli-

gent Key from unauthorized use to unlock

the vehicle. For information regarding the

erasing procedure, please contact a NISSAN

dealer.

Pre-driving checks and adjustments 3-3

Type B:

When the Intelligent Key is left inside of the vehicle

and any door is open.

LOCKING WITH INSIDE LOCK KNOB

LOCKING WITH POWER DOOR LOCK

SWITCH

VEHICLE SPEED SENSING DOOR LOCK

MECHANISM (if equipped)

All doors will be locked automatically when the vehicle

speed reaches 24 km/h (15 MPH) (for Mexico) or 10

km/h (6 MPH) (except for Mexico). Once the lock has

been unlocked, while driving, the vehicle speed

sensing door lock mechanism will not lock the door

again unless one of the following is performed.

SPA2603

Opening any doors.

SPA2803

Placing the ignition switch in the “LOCK” position.

Driver’s armrest

CAUTION:

AUTO DOOR LOCK RELEASING ME-

CHANISM (if equipped)

All doors will be unlocked automatically when the

ignition switch is moved from “ON” to “OFF” position.

When locking the doors using the inside lock

knob, be sure not to leave the key in the vehicle.

CAUTION:

When locking the doors using the power door

lock switch, be sure not to leave the key in the

vehicle.

To lock the front doors, push the inside lock knob to

the lock position

, and then close the door while

pulling the door handle.

To activate or deactivate auto door lock

releasing mechanism

To activate or deactivate the auto door lock releasing

mechanism, perform the following procedures.

To lock the doors, push the power door lock switch to

To lock the rear doors, push the inside lock knob to the

the lock position

with the driver’s door open, then

lock position

and then close the door.

close the door while pulling the door handle. All doors

including the back door will lock.

To unlock, pull the inside lock knob to the unlock

position

1. Place the ignition switch in the “ON” position.

To unlock, push the power door lock switch to the

unlock position

2. Within 20 seconds, push and hold the power door

lock switch to the “UNLOCK” position for

seconds.

Lockout protection

The power door lock switch will not lock the doors

under the following conditions:

3. The hazard indicator light will flash as follows if the

switching operation is successful:

Type A:

Twice — activated

When the key is in the ignition switch and the

driver’s door is open.

Once — deactivated

When any door except for the driver’s door is

open.

3-4 Pre-driving checks and adjustments

REMOTE KEYLESS ENTRY SYSTEM

(if equipped)

The remote keyless entry system can operate all door

locks (including the back door) using the remote

controller. The remote controller can operate at a

distance of approximately 1 m (3.3 ft) away from the

vehicle. The operating distance depends upon the

conditions around the vehicle.

tures exceed 608C (1408F).

remote controller is lost or stolen, NISSAN

CHILD SAFETY REAR DOOR LOCK

recommends erasing the ID code of that remote

controller from the vehicle. This may prevent the

unauthorized use of the remote controller to unlock

the vehicle. For information regarding the erasing

procedure, contact a NISSAN dealer.

As many as 5 remote controllers can be used with one

vehicle. For information about the purchase and use of

additional remote controllers, contact a NISSAN deal-

er.

For information regarding the replacement of a battery,

see “Battery” (P.8-15).

USING REMOTE KEYLESS ENTRY SYSTEM

The remote controller will not function under the

following conditions:

SPA2801

When the distance between the remote controller

and vehicle is more than approximately 1 m (3.3

ft).

The child safety rear door locks help prevent rear doors

from being opened accidentally, especially when small

children are in the vehicle.

When the remote controller battery is discharged.

When the key is in the ignition switch.

When the levers are in the lock position

, the child

safety rear door locks engage and the rear doors can

only be opened by the outside door handles.

CAUTION:

To disengage, move the levers to the unlock position

When locking the doors using the remote

controller, be sure not to leave the key in the

vehicle.

JVP0222X

LOCK button

Do not allow the remote controller, which

contains electrical components, to come

into contact with water or salt water. This

could affect the system function.

UNLOCK button

Battery indicator light

Locking doors

1. Remove the ignition key.

2. Close all doors.

on the remote

Do not drop the remote controller.

Do not strike the remote controller sharply

against another object.

3. Push the “LOCK”

controller.

button

If the outside temperature is below −108C

(148F), the battery of the remote controller

may not function properly.

4. All doors will be locked.

5. Operate door handles to confirm that the doors

have been securely locked.

Do not place the remote controller for an

extended period in an area where tempera-

Pre-driving checks and adjustments 3-5

Pre-driving checks and adjustments -> Door locks for Your Nissan Juke SUV First Generation (2010-2019)

Related Topics

Popular Owner Manuals

Latest Owner Manuals