2004-2009 Nissan Micra 4 Door Instruments and controls -> Sunshade (if equipped) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Sunshade (if equipped) for Your Nissan Micra 4 Door Third Generation (2004-2009)

2-42 Instruments and controls
3. Pull up and hold the driver’s window switch to
close the driver’s window. Hold the switch for
approximately 3 seconds after the window has
been fully closed, and then release it.
4. Check if the power window functions operate
properly.
If you open or close the power window continuously, it
may cause the power window not to operate properly.
Perform the above procedure.
If the power window functions do not operate properly
after performing the above procedure, repeat the
steps. See a NISSAN dealer, if necessary, for checking
the power window system.
GUID-B81D46D9-9A1 8-4BD9-8320-40118EC72878
WARNING:
Never allow hands, fingers, or any part of your
body within operating range of the sunshade.
You could be injured.
CAUTION:
. Do not place any heavy objects on the roof
glass or surrounding area.
. Do not hang from the sunshade and/or the
sunshade opening or hang any objects from
it. It may cause damage or deformation to
the sunshade.
. Close the sunshade when you leave the
vehicle for extended periods of time to
prevent the inside of the vehicle from reach-
ing high temperatures.
JVI0020X
To open or close the sunshade, operate the knob
*
A
.
To open the sunshade, slide it toward the rear of the
vehicle
*
1
. To close, slide the sunshade toward the
front of the vehicle
*
2
.
GUID-C1828FF3-F90F-40D8-9E87-002BF7507265
If the battery cable is disconnected, the clock will reset
its time and the correct time will not be indicated.
Readjust the time.
For model with the vehicle information display, see
“Vehicle information display” (P.2-20)
For the clock adjustment in the audio unit (if equipped).
See “Audio system” (P.4-11).
ADJUSTING TIME
GUID-875C5465-043F-46E4-8C26-73F2C9976131
Meter display model (if equipped)
GUID-2422041C-6D77-4B63-B1AD-EA7A676BF0A4
SIC4406
Example
The digital clock
*
2
in the meter displays the time
when the ignition switch is in the “ON” position.
To display the clock, push the adjusting knob
*
1
. To
adjust the time, perform the following procedure.
1. Push the clock adjusting knob
*
1
for 1.5 or 3
seconds or more to enter time adjust mode.
The hours display will start to flash.
2. Push the clock adjusting knob
*
1
to adjust the
hour.
To advance the time, hold down the knob
*
1
.
3. Wait at least 3 or 5 seconds for the minute display
to flash.
SUNSHADE (if equipped) CLOCK

Related Topics

Popular Owner Manuals