
GUID-557C2382-A9EE-422E-8BDD-91D9CE65F6A2
The driver’s switch, which is the main switch, can
control all windows.
Locking passengers’ windows:
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
JVI0036X
Front and rear type
When the lock button
*
1
is pushed in, the passen-
gers’ windows cannot be operated.
To cancel the passengers’ windows lock, push the lock
button
*
1
again.
Passenger’s window switch
GUID-E10410C2-8231-46F0-9562-4D6AA1FDAE09
SIC2311
The passenger’s switch can control its corresponding
window.
When the passengers’ windows lock button on the
driver’s switch is pushed in, the passenger’s switch
cannot be operated.
Automatic function
GUID-726BC8CC-D87A-4552-ACE7-27F0800FF810
JVI0037X
Front and rear type
Automatic function is available for the switch that has
an
mark on its surface.
The automatic function enables a window to fully open
or close (if equipped) without holding the switch down
or up.
To fully open the window, push the power window
switch down to the second detent and release the
switch. To fully close the window (if equipped), pull the
power window switch up to the second detent and
release the switch. The switch does not have to be
held during window operation.
To stop the window open/close operation during the
automatic function, push down or pull up the switch in
opposite directions.
Window timer (if equipped):
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
The window timer allows the window switch to be
operated for 15 minutes even if the ignition switch is
turned off and the key is removed. The window timer
will be cancelled when the corresponding door is
opened or the preset time has expired.
Auto-reverse function (if equipped):
GUID-9E14C2E6-2E9C-4731-980B-C45B899B977B
WARNING:
There is a small distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the windows.
The auto-reverse function enables a window to
automatically reverse when something is caught in
the window as it is closing by the automatic function.
When the control unit detects an obstacle, the window
will be lowered immediately.
Depending on the environment or driving conditions,
the auto-reverse function may activate if an impact or
load similar to something being caught in the window
occurs.
When power window switch does not oper-
ate
GUID-A5CDA1AC-E8AF-473E-B390-068E5322A935
So me power window functions (automati c close
function, auto-reverse function) will not operate as
described after the battery cable is disconnected and
the electrical supply is i nterrupted. Perform the
following procedure to initialize the power window
functions.
1. Turn the ignition switch to the "ON" position.
2. If the driver’s window is closed, open it completely
by operating the driver’s window switch.
Instruments and controls 2-41