2-38 Instruments and controls
If the windshield wiper operation is interrupted
by snow etc., the wiper may stop moving to
protect its motor. If this occurs, turn the wiper
switch to OFF and remove the snow etc. on and
around the wiper arms. In approximately 20
seconds, turn the switch ON again to operate
the wiper.
Washer operation
SIC4018
Type A
SIC3909
Type B
The rain-sensing auto wiper system can automatically
turn on the wipers and adjust the wiper speed
depending on the rainfall and the vehicle speed by
using the rain sensor located on the upper part of the
windshield.
To set the rain-sensing auto wiper system, push the
lever down to the “AUTO” position
*
1
. The wiper will
sweep once while the ignition switch is in the “ON”
position.
The rain sensor sensitivity level can be adjusted by
turning the knob toward the front
*
2
(High) or toward
the rear
*
3
(Low).
. High — High sensitive operation
. Low — Low sensitive operation
To turn the rain-sensing auto wiper system off, push up
the lever to the “OFF” position, or pull down the lever
to the “
” (LO) or “ ” (HI) position.
CAUTION:
Do not touch the rain sensor and around it when
the wiper switch is in the “AUTO” position and
the ignition switch is in the “ON” position. The
wipers may operate unexpectedly and cause to
an injury or a wiper damage.
. The rain-sensing auto wipers are intended
for use during rain. If the switch is left in the
“AUTO” position, the wipers may operate
unexpectedly when dirt, fingerprints, oil film
or insects are stuck on or around the sensor.
The wipers may also operate when exhaust
gas or moisture affect the rain sensor.
. When the windshield glass is coated with
water repellent, the speed of the rain-sen-
sing auto wipers may be higher even though
the amount of the rainfall is small.
. Be sure to turn off the rain-sensing auto
wiper system when you use a car wash.
. The rain-sensing auto wipers may not oper-
ate if rain does not hit the rain sensor even if
it is raining.
REAR WINDOW WIPER AND WASHER
SWITCH (if equipped)