PUSH-STARTING
ENGINE OVERHEAT
CAUTION
4. Shift the gear lever (MT models) into the N (Neu-
tral) position [AT or CVT models, move the se-
lector lever to the P (Park) position].
WARNING
Three-way catalyst equipped models should
not be started by pushing the vehicle as the
three-way catalyst may be damaged.
•
Never continue driving if the engine of your
vehicle overheats. Doing so could cause a ve-
hicle fire.
•
DO NOT STOP THE ENGINE.
Automatic transmission (AT) or continuously
5. Open all windows.
•
Never open the bonnet if steam is coming
out.
•
variable transmission (CVT) models cannot be
started by pushing the vehicle. This may cause
transmission damage.
6. Switch off the air conditioner system (where fit-
ted).
Never remove engine coolant reservoir cap
•
7. Set the heater or air conditioner temperature
control to maximum “HOT” and fan speed con-
trol to maximum speed.
when the engine is hot. If the engine coolant
reservoir cap is removed while the engine is
hot, pressurised hot water will spurt out and
possibly cause burning, scalding or serious
injury.
Never try to start the vehicle by towing it; when
•
the engine starts, the forward surge could
cause the vehicle to collide with the tow ve-
hicle.
8. Exit the vehicle.
9. Visually inspect and listen for steam or coolant
escaping from the radiator before opening the
bonnet. Wait until no steam or coolant can be
seen before proceeding.
If steam or coolant is coming out of the en-
gine, stand clear of the vehicle to prevent get-
ting injured.
•
The engine cooling fan will start whenever the
coolant temperature exceeds preset degrees.
•
10. Open the bonnet. For details, see “Bonnet
release” in the “3. Pre-driving checks and
adjustments” section.
Be careful not to allow your hands, hair, jewel-
lery or clothing to come into contact with, or
get caught in, the cooling fan or drive belts.
•
11. Visually check if the cooling fan is running.
12. Visually check the radiator and radiator hoses
for leakage.
If the engine of your vehicle is overheating (indi-
cated by the engine coolant temperature gauge) or
if you feel a lack of engine power, detect unusual
noise, etc., proceed as follows:
WARNING
If coolant is leaking, the cooling fan belt is
missing or loose or the cooling fan is not run-
ning, stop the engine.
1. Move and park the vehicle safely off the road and
away from traffic.
2. Turn on the hazard warning flasher lights.
3. Apply the handbrake.
13. After the engine cools down, check the coolant
level in the engine coolant reservoir with the
engine running.
6-12 In case of emergency
Downloaded from manuals search engine