2. Store the subwoofer (where fitted) as it was origi-
nally installed.
normal wheel nuts. For details, see “Chang-
ing flat tyre (Models with spare wheel, where
fitted)” earlier in this section.
Wheel lock nuts (where fitted)
In order to prevent theft, the specially designed
wheel lock nut is installed to each wheel. The wheel
lock nut cannot be removed with the commonly used
tools.
3. Install the retainer and replace the floor cover.
NOTE
The wheel lock nut has an individual code.
•
A wheel lock key with other than the indi-
vidual code cannot remove the wheel lock
nut. If you lose the wheel lock key, contact
a NISSAN dealer for a duplicate with the
original wheel lock key code.
When removing tyres, use the lock key provided
with your vehicle.
Record the key number as shown on the
•
key code card on the “Security informa-
tion” page at the end of this manual and
keep it in a safe place, not in the vehicle.
NCE306
7–seater
When you ask for a service at a NISSAN
•
dealer or qualified workshop, make sure
to keep the lock key in the vehicle. Other-
wise, wheels cannot be removed and the
service cannot be performed.
1. Store the tools in the specified areas.
NCE143Z
2. Firmly pull down the third row seat and make
sure it locks into the locking latches on both sides
under the seat.
Removing the wheel lock nut:
REPAIRING FLAT TYRE (Models with
emergency tyre puncture repair kit,
where fitted)
1. Insert the wheel lock key j1 to the wheel lock
3. Place the seatback of the third row seat in the
upright position j1 . For details, see “Folding 3rd
row (7-seater)” in the “1. Safety — seats, seat
belts and supplemental restraint system” section.
nut.
2. To remove the wheel lock nut, turn the wheel
lock key anticlockwise using the wheel wrench.
The emergency tyre puncture repair kit is supplied
with the vehicle instead of a spare tyre. This repair
kit must be used for temporarily fixing a minor tyre
puncture. After using the repair kit, see a NISSAN
dealer or qualified workshop as soon as possible for
tyre inspection and repair/replacement.
CAUTION
4. Store the wheel with flat tyre vertically in the boot
j2 .
Do not use a power tool to remove the wheel
lock nuts.
•
5. Store the other items in following order:
When installing the wheel, tighten the wheel
lock nuts to the same tightening torque as the
Tonneau cover (where fitted) j3 → Floor cover
j4 → Centre floor board and the two side floor
boards j5 .
•
In case of emergency 6-7
Downloaded from manuals search engine