2006-2014 Nissan Qashqai SUV Safety ? seats, seat belts and supplemental restraint system -> Three-point type seat belts User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Safety ? seats, seat belts and supplemental restraint system -> Three-point type seat belts for Your Nissan Qashqai SUV First Generation (2006-2014)

CAUTION  
INJURED PERSONS  
The seat belt retractor is designed to lock dur-  
ing a sudden impact. A slow pulling motion  
will permit the belt to move and allow you  
some freedom of movement in the seat.  
NISSAN recommends that injured persons use seat  
belts, depending on the injury. Check with your doc-  
tor for specific recommendations.  
THREE-POINT TYPE SEAT BELTS  
Every person who drives or rides in this vehicle  
should wear a seat belt at all times.  
Fastening the seat belts  
NPA966  
2nd row rear centre (7-seater)  
1. Adjust the seat.  
2nd row centre seat (7-seater)  
WARNING  
a. Unclip the seat belt buckles from the (magnetic)  
The seatback should not be reclined any more  
than needed for comfort. Seat belts are most  
effective when the passenger sits well back  
and upright in the seat. If the seat is reclined,  
the risk of sliding under the lap belt and being  
injured is increased.  
ceiling stowage point j1 .  
NPA827Z  
b. Slowly pull the seat belt out of the ceiling retrac-  
tor and pass the buckles through the comfort  
loop j2 .  
2nd row centre seat (5-seater)  
2nd row centre seat (5-seater)  
a. Unclip the seat belt buckles from the ceiling  
stowage point.  
c. Insert the end tongue into the buckle with the  
black button j3 until it clicks.  
b. Slowly pull the seat belt out of the ceiling retrac-  
tor and insert the end tongue into the buckle with  
the black button j1 until it clicks.  
d. Pull the second tongue and insert it into the  
buckle with the red button j4 until it clicks.  
c. Pull the tongue and insert it into the buckle j2  
until it clicks.  
SSS0292Z  
2. Slowly pull the seat belt out of the retractor and  
insert the tongue into the buckle until it clicks.  
Safety — seats, seat belts and supplemental restraint system 1-9  
Downloaded from manuals search engine  
Unfastening the seat belts  
WARNING  
Make sure, when releasing the centre seat belt  
from the 2nd row, that the seat belt tongues do  
not come into contact with any occupants on the  
3rd row.  
To unfasten the seat belt, press the button on the  
buckle. The seat belt will automatically retract.  
NPA972  
SSS0467Z  
3rd row rear (7-seater)  
2nd row centre seat (5-seater)  
Rear centre seat:  
3rd row outer seat (7-seater)  
3. Position the lap belt portion low on the hips as  
shown.  
a. Unclip the end tongue from stowage hook on the  
a. Press the red button on the inner buckle j2 . The  
seat belt will automatically retract to the outer  
buckle with the black button j1 .  
side trim j1 .  
4. Pull the shoulder belt portion towards the retrac-  
tor to take up extra slack. Make sure the shoul-  
der belt is routed over your shoulder and snug  
across your chest.  
b. Insert the end tongue into the buckle with the  
black button until it clicks j2 .  
b. To fully stow the seat belt, press the black but-  
ton on the outer buckle j1 . The seat belt will  
retract fully.  
c. Pull the second tongue and insert it into the  
buckle with the red button j3 until it clicks. The  
tongue holder can be slid to a preferred position  
on the webbing for easy access the next time the  
seat belt is used.  
WARNING  
c. Stow the seat belt buckles in the ceiling stowage  
point.  
The seat belt should rest on the middle of  
the shoulder. It must not rest against the  
neck.  
•
2nd row centre seat (7-seater)  
a. Press the red button on the inner buckle j4 . The  
seat belt will automatically retract to the outer  
buckle with the black button j3 .  
Make sure that the seat belt is not twisted  
in any way.  
•
b. While holding the seat belt, press the black but-  
ton on the outer buckle j3 . The seat belt will  
retract fully.  
c. Stow the seat belt buckles in the ceiling stowage  
point.  
1-10 Safety — seats, seat belts and supplemental restraint system  
Downloaded from manuals search engine  
3rd row outer seat (7-seater)  
the centre of the shoulder. Release the adjustment  
button to lock the shoulder belt anchor into position.  
SEAT BELT MAINTENANCE  
a. Press the red button on the inner buckle j3 . The  
seat belt will automatically retract to the outer  
buckle with the black button j2 .  
To clean the seat belt webbing, apply a mild  
•
soap solution or any solution recommended for  
cleaning upholstery or carpets. Then brush it,  
wipe with a cloth and allow it to dry in the shade.  
Do not allow the seat belts to retract until they  
are completely dry.  
WARNING  
After adjustment, release the adjustment but-  
•
–
If desired, the 3rd row seatback can be folded  
flat for further information see “Folding 3rd  
row (7-seater)” earlier in this section.  
ton and check by moving the shoulder belt  
assembly up and down to make sure the  
shoulder belt anchor is securely fixed in posi-  
tion.  
If dirt builds up in the shoulder belt guide of  
•
b. Press the black button to release the end tongue.  
When the seat belt has retracted fully, place the  
end tongue onto stowage hook j1 . Move the  
tongue holder downwards if required.  
the seat belt anchors, the seat belts may retract  
slowly. Wipe the shoulder belt guide with a clean,  
dry cloth.  
The seat belt should be away from your face  
and neck, but not falling off your shoulder.  
•
Periodically check to see whether the seat  
Checking the seat belt operation  
•
belt and the metal components such as buck-  
les, tongues, retractors, flexible wires and an-  
chors work properly. If loose parts, deteriora-  
tion, cuts or other damage to the webbing is  
found, the entire belt assembly should be re-  
placed.  
Your seat belt retractors are designed to lock the  
belt movement in two separate situations:  
When the belt is pulled quickly from the retrac-  
tor.  
•
When the vehicle slows down rapidly.  
•
To increase your confidence in the belts, check the  
operation as follows:  
NPA816Z  
Take place in the seat for which you wish to check  
the belt operation. Grasp the shoulder belt and pull  
quickly forward. The retractor should lock and re-  
strict further belt movement.  
Shoulder belt height adjustment (front  
seats only)  
The shoulder belt anchor height should be adjusted  
to the position best for you (see “Precautions on  
seat belt usage” earlier in this section).  
If the retractor does not lock during these checks or  
if you have any questions about the seat belt opera-  
tion, see a NISSAN dealer or qualified workshop.  
To adjust, depress the adjustment button as illus-  
trated and move the shoulder belt anchor to the  
appropriate position, so that the belt passes over  
Safety — seats, seat belts and supplemental restraint system 1-11  
Downloaded from manuals search engine  

Related Topics

Popular Owner Manuals