2000-2006 Nissan X Trail SUV Instruments and controls -> METERS AND GAUGES User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> METERS AND GAUGES for Your Nissan X Trail SUV First Generation (2000-2006)

23. Multi box
24. Heater/air conditioner control
25. Glove box
26. Upper glove box
* If so equipped
1. Tachometer
2. Turn signal indicator/Hazard indicator
3. Speedometer
4. Fuel gauge
5. Engine coolant temperature gauge
6. Warning/Indicator lights
7. Odometer (Total/Twin trip)
8. Reset knob for trip odometer
9. A/T shift position indicator (if so equipped)
SIC2394
METERS AND GAUGES
Instruments and controls 2-3
墌 04.6.10/T30-J/V5.0 墍
SPEEDOMETER AND ODOMETER
Speedometer
The speedometer indicates vehicle speed.
Odometer/Twin trip odometer
The odometer
쎻
1
/twin trip odometer
쎻
2
are
displayed when the ignition key is in the ON
position.
The odometer records the total distance the
vehicle has been driven.
The twin trip odometer records the distance of
individual trips.
Changing the display :
Push the reset knob
쎻
3
to change the trip
odometer display as follows:
TRIP A → TRIP B → CLOCK
→ TEM-
PERATURE (Outside air — °C) → TRIP A
Resetting the trip odometer :
Push the reset knob for more than 1 second to
reset the trip odometer to zero.
Outside air temperature display
쐌 When the outside air temperature is 3°C or
lower, the display blinks to give a warning.
쐌 If the outside air temperature becomes 3°C
or lower when the display is in one of the
other modes, the display switches to the
outside air temperature display mode and
blinks. If the outside air temperature becomes
above 3°C, it returns to the display mode
previously set.
쐌 Even while the display is blinking, the display
mode can be switched to the one previously
set by pushing the reset knob.
Clock display
Refer to “Clock” later in this section for further
details on the clock adjustment.
TACHOMETER
The tachometer indicates engine speed in revo-
lutions per minute (rpm).
Do not rev engine into red zone
쎻
1
.
CAUTION
When engine speed approaches the red
zone, shift to a higher gear. Operating
the engine in the red zone may cause
serious engine damage.
SIC2395 SIC2271A
2-4 Instruments and controls
墌 04.6.10/T30-J/V5.0 墍
ENGINE COOLANT TEMPERATURE
GAUGE
The gauge indicates the engine coolant tem-
perature.
The engine coolant temperature will vary with the
outside air temperature and driving conditions.
CAUTION
If the gauge indicates engine coolant
temperature over the normal range
쎻
1
,
stop the vehicle as soon as safely pos-
sible. If the engine is overheated, con-
tinued operation of the vehicle may se-
riously damage the engine. See “If your
vehicle overheats” in the “6. In case of
emergency” section for immediate ac-
tion required.
FUEL GAUGE
The gauge indicates the approximate fuel level in
the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or down hill.
The gauge needle is designed to move to the E
(Empty) position when the ignition key is turned
to the OFF position.
Refill the fuel tank before the gauge regis-
ters Empty.
SIC2354B SIC2438
Instruments and controls 2-5
墌 04.6.10/T30-J/V5.0 墍
The low fuel warning light
쎻
1
comes on
when the fuel tank is getting low. Refuel as
soon as it is convenient, preferably before
the gauge reaches E. There will be a small
reserve of fuel in the tank when the fuel
gauge needle reaches E.
The
indicates that the fuel filler lid is
located on the driver’s side of the vehicle.
CAUTION
쐌 If the vehicle runs out of fuel, the
malfunction indicator lamp
(MIL) may come on. Refuel as soon
as possible. After a few driving trips,
the
lamp should turn off. If the
lamp remains on after a few driving
trips, have the vehicle inspected by a
NISSAN dealer.
쐌 For additional information, see the
“Malfunction indicator lamp (MIL)”
later in this section.
2-6 Instruments and controls
墌 04.6.10/T30-J/V5.0 墍

Related Topics

Popular Owner Manuals