Get PRACTICAL INFORMATION -> CHANGING A BULB Guide for Peugeot 308 4 Door First Genration (2007-2013)

PRACTICAL INFORMATION

1

Model with xenon lights and

directional headlamps

CHANGING A BULB

In certain climatic conditions (low

temperature, humidity), the presꢀ

ence of condensation on the inꢀ

side of the headlamp and light

glass is normal; it disappears a few

minutes after the lights are switched

on.

i

Procedure for replacing a faulty bulb

with a new bulb without the use of

tools.

Front lights

Model with halogen lights

!

 Handle the bulbs using a dry

cloth.

The headlamps are ﬁtted with poly-

carbonate lenses, coated with a

protective varnish:

 do not clean them with a dry

or abrasive cloth or using a

detergent or solvent product,

1. Direction indicators

(PY 21 W SV silver).

2. Dipped/main beam headlamps

(D1S ꢀ 35 W).

3. Additional main beam headlamps

(H1 ꢀ 55 W).

4. Daytime*/side lights (P21/5 W).

5. Fog lamps (H8 ꢀ 35 W).

 use a sponge and soapy water,

 when using a high pressure

washer on stubborn dirt, do

not spend too long on the

headlamps, lights and their

surrounds to avoid damaging

their varnish and their seals.

1. Direction indicators

(PY 21 W amber).

2. Dipped headlamps (H7 ꢀ 55 W).

3. Main beam headlamps

(H1 ꢀ 55 W).

4. Daytime*/side lights (P21/5 W).

5. Fog lamps (H8 ꢀ 35 W).

!

Risk of electrocution

Xenon bulbs (D1S - 35 W) must be

replaced by a PEUGEOT dealer.

* According to country.

168

PRACTICAL INFORMATION

1

Changing direction indicator bulbs

Changing main beam headlamp

bulbs

 Remove the protective plastic cover

by pulling on the tab.

 Disconnect the bulb connector.

 Compress the springs to release the

bulb.

 Remove the bulb and change it

To reﬁt, carry out these operations in re-

verse order.

Changing dipped headlamp bulbs

 Remove the protective plastic cover

by pulling on the tab.

 Disconnect the bulb connector.

 Compress the springs to release the

bulb.

 Extract the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

 Turn the bulb holder a quarter of a

turn and extract it.

 Pull the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

i

Amber or silver coloured bulbs,

Changing daytime/side light bulbs

 Remove the protective plastic cover

by pulling on the tab.

 Disconnect the bulb connector.

such as the direction indicators,

must be replaced with bulbs of

identical speciﬁcations and colour.

 Turn the bulb holder a quarter of a

turn and extract it.

 Pull the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

!

When reﬁtting, close the plastic

cover carefully to guarantee the

sealing of the headlamp.

169

PRACTICAL INFORMATION

1

Changing integrated direction

indicator side repeaters

Changing fog lamp bulbs

 Turn the wheel fully towards the

inside for easy access to the ﬂap.

 Open the access ﬂap, located in the

wheelarch.

 Disconnect the bulb holder connector.

 Turn the bulb holder a quarter of a

turn and extract it.

 Pull the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

 Insert a screwdriver towards the

centre of the repeater between the

repeater and the base of the mirror.

 Tilt the screwdriver to extract the

repeater and remove it.

 Disconnect the repeater connector.

To reﬁt, carry out these operations in re-

verse order.

Contact a PEUGEOT dealer to obtain

replacement repeaters.

i

To replace these bulbs you may

also consult a PEUGEOT dealer.

170

PRACTICAL INFORMATION

1

Changing bulbs

These ﬁve bulbs are changed from out-

side the boot:

Rear lights

 on the right-hand side; remove the

access ﬂap,

 on the left-hand side; turn the ﬁxing

bolt a quarter of a turn and remove

the storage box cover,

 unclip the storage box,

 remove the two light ﬁxing nuts,

 extract the light carefully from the

outside,

 disconnect the light connector,

1. Brake/side lights (P21/5 W).

2. Side lights (P21/5 W).

3. Fog lamp, leftꢀhand side

(P21 W).

Reversing light, rightꢀhand side

(P21 W).

4. Direction indicators (P21 W).

 press the four tabs and remove the

bulb holder,

 turn the bulb a quarter of a turn and

change it.

To reﬁt, carry out these operations in re-

verse order.

i

If the vehicle is ﬁtted with the JBL

audio system, on the right-hand

side, ﬁrst remove the three ﬁxing

bolts, then move the box.

171

PRACTICAL INFORMATION

1

Changing third brake light bulbs

(4 bulbs W 5 W)

Changing the number plate light

bulbs (W 5 W)

 Unclip the tailgate upper trim from  Insert a thin screwdriver into one of

left to right. the outer holes of the lens.

 Unscrew the two light ﬁxing nuts A.  Push it outwards to unclip.

 Unclip the light’s central pin.

 Extract the light from the outside.

 Remove the lens.

 Pull the bulb and change it.

 Disconnectthebulbholderconnector

and the wash-wipe pipe.

 Unclip the bulb holder from the light

by pressing on the two tabs B.

 Pull the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

Do not apply force to the light when

tightening the nuts.

172

PRACTICAL INFORMATION

1

Changing bulbs

These ﬁve bulbs are changed from out-

side the boot:

Rear lights

 open the boot,

 unscrew the two light ﬁxing bolts,

 extract the light carefully pulling

it from the bottom and pivoting it

towards the outside,

 unclip the light connector,

 separate the ﬁve tabs and remove

the bulb holder,

 turn the bulb a quarter of a turn and

change it.

1. Brake/side lights (P21/5 W).

2. Side lights (P21/5 W).

3. Fog lamp, leftꢀhand side (P21 W)

Reversing light, rightꢀhand side

(P21 W).

4. Direction indicators (P21 W)

To reﬁt, carry out these operations in re-

verse order.

Take care to engage the light in its guides

keeping it in line with the vehicle.

173

PRACTICAL INFORMATION

1

Changing the number plate light

bulbs (W 5 W)

Changing the third brake light

(SW ꢀ 4 bulbs W 5 W)

Changing the third brake light

(SW ꢀ diodes)

On the versions with opening rear

screen, for the replacement of this type

of diode light, contact a PEUGEOT

dealer.

 Insert a thin screwdriver into one of  Remove the two light ﬁxing nuts A.

the outer holes of the lens.

 Push it outwards to unclip.

 Take out the light from the outside.

 Disconnect the connector and the

 Remove the lens.

 Pull the bulb and change it.

screenwash pipe from the light.

 Turn the bulb holder corresponding

to the faulty bulb a quarter of a turn.

 Pull the bulb and change it.

To reﬁt, carry out these operations in re-

verse order.

Do not force the light when tightening

the nuts.

174

Download User Manual App

PRACTICAL INFORMATION -> CHANGING A BULB for Your Peugeot 308 4 Door First Genration (2007-2013)

Related Topics

PRACTICAL INFORMATION

Popular Owner Manuals

Latest Owner Manuals