PRACTICAL INFORMATION
ENERGY ECONOMY MODE
System which manages the duration of
use of certain functions to conserve a
sufficient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio
equipment, windscreen wipers, dipped
headlamps, courtesy lights, etc. for a
maximum combined duration of thirty
minutes.
Exiting economy mode
CHANGING A WIPER BLADE
Procedure for replacing a worn wiper
These functions are reactivated auto-
matically next time the vehicle is driven.
In order to resume the use of
these functions immediately, start
the engine and let it run for a few
minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this period
will always be between five and thirty
minutes.
blade with a new one without the use
of tools.
Before removing a front wiper
blade
Within one minute after switching off
the ignition, operate the wipers stalk
to position the wiper blades in the
centre of the windscreen.
Switching to economy mode
Removing a front or rear wiper
blade
Once the thirty minutes are over, a
message appears on the multi-function
display indicating that the vehicle has
switched to economy mode and the ac-
tive functions are put on standby.
!
A flat battery prevents the engine
from starting (refer to the corre-
sponding paragraph).
Raise the corresponding wiper arm.
Unclip the wiper blade and remove
it.
Fitting a front or rear wiper
blade
If the telephone is being used at
this time:
i
At the front, check the size of the
wiper blade as the shorter blade is
fitted on the right-hand side of the
vehicle.
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
-
it will be maintained for
5 minutes with the RD4 audio
equipment hands-free kit,
-
it will still be possible to finish
the call with the RT4 GPS
audio/telephone.
Operate the wipers stalk again to
park the wiper blades.
183
English 