Get Driving -> Tyre under-inflation detection Guide for Peugeot 308 4 Door Second Genration (2014-2020)

Driving

During a bay parking manoeuvre, the Park

if the speed of the vehicle exceeds the

stated limit,

when the driver interrupts movement of the

steering wheel,

after 4 manoeuvre cycles,

on opening the driver's door,

if one of the front wheels encounters an

obstacle.

In the event of a fault with the

power steering, this warning lamp

comes on in the instrument panel,

accompanied by a message.

Assist system is automatically deactivated

once the rear of the vehicle is within 20

inches (50 cm) of an obstacle.

Contact a PEUGEOT dealer or a qualified

workshop.

If the lateral distance between your vehicle and the

space is too great, the system may not be able to

measure the space.

During parking and exit from parking

manoeuvres, the Reversing Camera

function may come into operation. It

facilitates monitoring of the surroundings

of the vehicle, by displaying additional

information in the instrument panel.

For more information on the Reversing

Camera, refer to the corresponding

section.

This symbol is displayed on the touch

screen and a message appears,

accompanied by an audible signal.

Anything projecting beyond the dimensions of the

vehicle (long or wide load) is not taken into account

by the Park Assist system during a manoeuvre.

The driver should then take back control of the

vehicle's steering.

If the system is deactivated during a

manoeuvre, the driver should reactivate it to

repeat the measurement.

In bad weather or in winter, ensure that

the sensors are not covered by road dirt,

ice or snow.

Deactivation

In the event of a fault, have the system

checked by a PEUGEOT dealer or a

qualified workshop.

The system is switched off automatically:

Deactivation

when towing a trailer,

The system is deactivated by pressing the

control.

The system is deactivated automatically:

if the driver's door is opened,

if the speed of the vehicle is above 43 mph

(70 km/h).

Tyre under-inﬂation

detection

This system automatically monitors the tyre

pressure while driving.

on switching off the ignition,

if the engine stalls,

if no manoeuvre is performed within

5 minutes of selecting the type of

manoeuvre

To switch the system off for a prolonged period,

contact a PEUGEOT dealer or a qualified

workshop.

Operating faults

after a prolonged stop of the vehicle during

a manoeuvre,

if the wheel anti-slip regulation (ASR) is

triggered,

Depending on version:

The system monitors the pressure in all four

tyres, once the vehicle is moving.

This warning lamp comes on in the

instrument panel and a message appears,

accompanied by an audible signal.

166

Driving

The loss of pressure detected does not

always cause visible bulging of the tyre.

Do not satisfy yourself with just a visual

check.

It compares the information given by the

wheel speed sensors with reference values,

which must be reinitialised after every tyre

pressure adjustment or wheel change.

The system triggers an alert as soon as it

detects a drop in the pressure of one or more

tyres.

The tyre pressure specifications for your

vehicle can be found on the tyre pressure

label.

For more information on the

Identification markings, refer to the

corresponding section.

Tyre pressures should be checked when

the tyres are "cold" (vehicle stopped for

1 hour or after a journey of less than

6 miles (10 km) at moderate speeds).

Otherwise (when hot), add 0.3 bar to the

pressures shown on the label.

F In the event of a puncture, use the

temporary puncture repair kit or the spare

wheel (depending on equipment),

F if you have a compressor, such as the one

in the temporary puncture repair kit, check

the pressures of the four tyres when cold,

The tyre under-inflation detection system

does not replace the need for vigilance on

the part of the driver.

This system still requires you to check

the tyre inflation pressures (including

the spare wheel) every month as well as

before a long journey.

Driving with under-inflated tyres impairs

handling, extends braking distances and

causes early tyre wear, particularly in

adverse conditions (heavy loads, high

speeds, long journeys).

F if it is not possible to carry out this check

immediately, drive carefully at reduced

speed.

Snow chains

The system does not have to be

reinitialised after fitting or removing snow

chains.

The alert is kept active until the system is

reinitialised.

Under-inflation alert

Reinitialisation

This warning is indicated by fixed

illumination of this warning lamp, an

audible signal and, depending on

the equipment installed, a message

displayed on the screen.

The system must be reinitialised after any

adjustment to the pressure of one or more

tyres, and after changing one or more wheels.

Driving with under-inflated tyres

increases fuel consumption.

F Reduce speed immediately, avoid excessive

steering movements and sudden braking.

F Stop the vehicle as soon as it is safe to do

so.

167

Driving

by illumination of the Service warning lamp

indicates a fault with the system.

A message appears, accompanied by an

audible signal.

F Press the "5" or "6" button to select the

Driving assistance menu, then the Tyre

pressures menu, then the Reinitialisation

menu, then confirm by pressing the OK

button.

Before reinitialising the system, ensure

that the pressures of the four tyres

are correct for the conditions of use

of the vehicle and conform to the

recommendations on the tyre pressure

label.

In this case, under-inflation monitoring of the

tyres is no longer assured.

Have the system checked by a PEUGEOT

dealer or a qualified workshop.

Reinitialisation is confirmed by an audible

signal.

Touch screen

Reinitialisation of the system is done with the

The under-inflation alert can only be relied

on if the reinitialisation of the system has

been done with the pressures in the four

tyres correctly adjusted.

The under-inflation detection system

does not give a warning if a pressure is

incorrect at the time of reinitialisation.

ignition on and the vehicle stationary.

Before doing anything to the system,

the pressures of the four tyres must be

checked and the system reinitialised.

Select "Under-inflation

initialisation" in the Vehicle/

Driving menu, then the Driving

functions tab of the touch screen.

F Confirm the instruction by pressing "Yes",

an audible signal and a message confirm

the reinitialisation.

Screen C

The new pressure parameters saved are

treated as reference values by the system.

F Press the MENU button for access to the

main menu.

F Press the "7" or "8" button to select the

"Personalisation-configuration" menu,

then confirm by pressing the OK button.

Malfunction

F Press the "5" or "6" button to select the

Define the vehicle parameters menu, then

confirm by pressing the OK button.

The flashing and then fixed illumination of the

under-inflation warning lamp accompanied

168

Download User Manual App

Driving -> Tyre under-inflation detection for Your Peugeot 308 4 Door Second Genration (2014-2020)

Related Topics

Driving

Popular Owner Manuals

Latest Owner Manuals