Driving -> Electric dual-clutch automatic gearbox (e-DCS6) for Your Peugeot 408 4 Door Second Generation (2022-2026)

Driving  
However, in mode N, mode P will be engaged  
after a delay of 5 seconds (time to enable  
freewheeling mode).  
Check that mode P has been engaged and  
that the electric parking brake was applied  
automatically; if not, apply it manually.  
In some cases, the selector indicator lamps may  
no longer come on, but the gearbox state is still  
displayed on the instrument panel.  
Major malfunction  
In some situations (e.g. battery full,  
extreme temperatures), the amount of  
regenerative braking may be temporarily  
limited, resulting in less deceleration.  
The driver must remain alert to traffic  
conditions and must always be ready to use  
the brake pedal.  
8
This warning lamp comes on,  
accompanied by the display of a  
message.  
The corresponding indicator lamps  
on the gear selector and the electric  
parking brake control must be on, as  
well as the indicator lamps on the  
instrument panel.  
You must stop the vehicle.  
Stop as soon as it is safe to do so and  
switch off the ignition.  
Contact a PEUGEOT dealer or a qualified  
workshop.  
Regenerative braking using the brake  
pedal  
Energy recovery can also be produced by  
depressing the brake pedal in order to  
partially recharge the traction battery, without  
affecting the charge level indicator.  
Gearbox malfunction  
This warning lamp comes on,  
accompanied by an audible signal  
and the display of a message.  
Electric dual-clutch  
automatic gearbox (e-  
DCS6)  
6-speed electrified dual-clutch automatic  
gearbox with drive selector for hybrid vehicles.  
It also offers a manual mode with gear changes  
via control paddles located behind the steering  
wheel.  
Starting the vehicle  
Go to a PEUGEOT dealer or a qualified  
workshop.  
Do not drive faster than 62 mph (100 km/h),  
keeping to the speed limit.  
Switching of the gearbox to back-up mode  
Mode D locks in third gear.  
The paddles on the steering wheel do not work  
and mode M is no longer accessible.  
You may feel a significant jolt on engaging  
reverse gear. This will not damage the gearbox.  
Fully depress the brake pedal.  
Start the engine.  
With your foot on the brake pedal, push once  
or twice backwards to select automatic mode  
D, or forwards to shift into reverse gear R.  
Release the brake pedal.  
Accelerate gradually to automatically release  
the electric parking brake.  
It includes an electric motor, which improves the  
performance of the petrol engine, reduces fuel  
consumption and drives in all-electric.  
The vehicle moves off immediately.  
Selector malfunction  
Automatic gearbox  
Never try to start the engine by pushing  
the vehicle.  
Minor malfunction  
This warning lamp comes on,  
accompanied by the display of a  
message and an audible signal.  
Drive carefully.  
Switching the vehicle off  
Regardless of the current gearbox mode, mode  
P is immediately engaged automatically when  
the ignition is switched off.  
Go to a PEUGEOT dealer or a qualified  
workshop.  
101  
Driving  
provides 12 V power supply via the DC/DC  
converter and provides electric assistance to the  
petrol engine.  
Backwards, mode D is selected.  
Drive selector (Electric)  
Release the selector fully after each push; it  
will then return to its initial position.  
Special cases  
The electric motor has the following features:  
To avoid mode N (quick change from D to R and  
back again):  
Provide an additional torque to the gearbox,  
optimising the performance of the petrol  
engine.  
In mode R, push backwards past the point of  
resistance, mode D is selected.  
Recover the kinetic energy of the  
deceleration phases, converting it into  
electrical energy, which can be used for  
traction or for the power supply of electrical  
accessories installed on the vehicle.  
In mode D, push forwards past the point of  
resistance, mode R is selected.  
To return to mode N, push without passing  
the point of resistance.  
P. Auto Park  
Recharge the 48 V traction battery when the  
state of charge is too low.  
Press this button to switch to Parking  
mode.  
Steering-mounted controls  
For parking the vehicle: the front wheels  
are blocked.  
R. Reverse  
Provide all-electric driving only.  
(Depending on equipment)  
In mode M or D, the steering-mounted control  
paddles can be used to change gear manually.  
They cannot be used to select neutral or to  
engage or disengage reverse gear.  
These features are achieved through the  
following functions set of automatic operating  
mode:  
N. Neutral  
To free-wheel and move the vehicle, with  
the ignition off.  
e-Boost.  
For more information on Free-wheeling,  
refer to the corresponding section.  
D. Driving in automatic mode  
The gearbox manages gear changes  
according to the style of driving, the road  
profile and the vehicle load.  
The gearbox also manages braking when  
the accelerator pedal is released.  
M. Driving in manual mode  
Press this button to switch to manual  
mode.  
e-Creeping.  
e-Launch.  
e-Queueing.  
e-Parking.  
A manual operating mode is also available  
to activate/deactivate the restart of the petrol  
engine while driving: the e-Auto mode.  
Pull the "+" or "-" paddle towards you  
and release to shift up or down a gear,  
respectively.  
When mode P or N is selected on the  
automatic gearbox, the noise level in the  
engine compartment may increase due to the  
start of the charging phase of the traction  
battery: this is normal and does not represent  
a malfunction.  
The driver changes gear using the  
steeringmounted controls.  
Electric motor  
In mode N, with your foot on the brake pedal,  
push without passing the point of resistance:  
Special case (for hybrid)  
The electric motor included in the automatic  
gearbox, which is used for the first start,  
Forwards, mode R is selected.  
102  
Driving  
moved forward or backward in electric mode  
without having to depress the accelerator pedal,  
as soon as the mode D or R of the automatic  
gearbox is selected.  
Information displayed on  
the instrument panel  
If you open the driver's door while mode  
N is engaged, an audible signal will sound  
and mode P will be engaged. The audible  
signal stops when the driver's door is closed.  
8
When the ignition is switched on, the gearbox  
status is displayed on the instrument panel:  
e-Queueing  
This function makes it possible to follow a  
queue of vehicles with several stops followed  
by restarts of the vehicle, using the e-Creeping,  
e-Launch and electric driving modes.  
e-Parking  
This function allows parking manoeuvres to be  
carried out at reduced speed with the help of  
the electric motor when the mode D or R of the  
automatic gearbox is selected.  
At speeds below 3 mph (5 km/h), opening  
the driver’s door will engage mode P - risk  
of sudden braking!  
P
Parking  
R
Reverse  
N
Neutral  
D
M1...6  
Automatic forward gear  
Manual forward gear  
In the event of battery failure, it is essential  
to place the chock(s) supplied with the tool  
kit against one of the wheels to immobilise  
the vehicle.  
The gear engaged is also displayed in Sport  
mode.However, in all-electric driving, the gear  
engaged is not indicated.  
e-Boost  
The state of the gearbox remains displayed on  
the instrument panel for a few seconds after  
switching off the ignition.  
This function allows simultaneous operation  
of the petrol engine and the electric motor,  
combined with the automatic gearbox.  
By fully depressing the accelerator pedal  
("kickdown" function), when the traction battery  
is fully charged, it is possible to exceed the  
torque of the petrol engine alone, thanks to the  
additional torque provided by the electric motor.  
Special aspects of  
automatic mode  
Operation  
For Hybrid versions  
These functions respond to common driving  
situations where the electric motor is available  
to provide additional power or zero-emission  
driving.  
Only appropriate mode change instructions are  
validated.  
With the engine running, if it is necessary to  
depress the brake pedal to change modes,  
an alert message will be displayed on the  
instrument panel.  
Repeated use of the brake pedal causes  
the restart of petrol engine to provide  
braking assistance.  
These functions are only available if the  
traction battery is sufficiently charged.  
These five functions cannot be deactivated.  
With the engine running and the brakes  
released, if R, D or M is selected, the  
vehicle moves off, even without pressing the  
accelerator pedal.  
Never depress the accelerator and brake  
pedals at the same time - risk of damage to  
the gearbox!  
Special aspects of manual  
mode  
e-Launch  
With the petrol engine off, this function allows  
the vehicle to run in electric mode without  
affecting performance.  
By depressing the accelerator pedal, the vehicle  
starts to drive as soon as the mode D or R of the  
automatic gearbox is selected.  
The gearbox only changes from one gear to  
another if the vehicle speed and engine speed  
conditions permit.  
The petrol engine can also be switched off in  
manual mode when stopped in traffic or when  
the accelerator pedal is released.  
e-Creeping  
With the petrol engine off, by releasing the brake  
pedal, this function allows the vehicle to be  
The all-electric potential of the driving mode  
used (Normal or Eco) is also retained.  
103  
Driving  
However, in mode N, mode P will be engaged  
after a delay of 5 seconds (time to enable  
freewheeling mode).  
Check that mode P has been engaged and  
that the electric parking brake was applied  
automatically; if not, apply it manually.  
Selector malfunction  
For hybrid vehicles, using the steering  
wheel paddles also causes the restarting  
of petrol engine.  
If high traction is required, the driver can  
deactivate the e-Auto mode using the touch  
screen application.  
Minor malfunction  
This warning lamp comes on,  
accompanied by the display of a  
message and an audible signal.  
Drive carefully.  
The corresponding indicator lamps  
on the gear selector and the electric  
parking brake control must be on, as  
well as the indicator lamps on the  
instrument panel.  
Starting the vehicle  
Go to a PEUGEOT dealer or a qualified  
workshop.  
In some cases, the selector indicator lamps may  
no longer come on, but the gearbox state is still  
displayed on the instrument panel.  
Major malfunction  
Fully depress the brake pedal.  
Start the petrol engine by depressing the  
brake pedal until the engine is running at a  
stabilised engine speed.  
Gearbox malfunction  
This warning lamp comes on,  
accompanied by an audible signal  
and the display of a message.  
With your foot on the brake pedal, push once  
or twice backwards to select automatic mode  
D, or forwards to shift into reverse gear R.  
This warning lamp comes on,  
accompanied by the display of a  
message.  
Release the brake pedal.  
Accelerate gradually to automatically release  
the electric parking brake.  
Go to a PEUGEOT dealer or a qualified  
workshop.  
Do not drive faster than 62 mph (100 km/h),  
keeping to the speed limit.  
You must stop the vehicle.  
Stop as soon as it is safe to do so and  
switch off the ignition.  
Contact a PEUGEOT dealer or a qualified  
workshop.  
The petrol engine may stop after the first start if  
operating conditions allow (e.g. state of charge  
of the traction battery, external temperature,  
efficiency of the catalytic converter, torque  
demand, selected driving mode, thermal comfort  
of the passenger compartment).  
Switching of the gearbox to  
back-up mode  
Driving modes  
Depending on the malfunction, the gearbox only  
shifts in odd or even gears, locks in one gear or  
loses some gears.  
Then, the vehicle moves off immediately in  
allelectric (e-Launch function).  
The driving modes available depend on the  
engine and equipment of the vehicle.  
Driving modes are selected using the following  
control:  
For hybrid vehicles, the paddles on the steering  
wheel do not work and mode M is no longer  
accessible.  
You may feel a significant jolt on engaging  
reverse gear. This will not damage the gearbox.  
Automatic gearbox  
Never try to start the engine by pushing  
the vehicle.  
Switching the vehicle off  
Regardless of the current gearbox mode, mode  
P is immediately engaged automatically when  
the ignition is switched off.  
104