Driving
This warning lamp lights up on the
instrument panel with the message
"Parking Assistance Sensor blind:
Clean sensor, see User Manual" if
the sensor is masked.
The parking sensors supplement the information
in the view from above the vehicle.
Different contextual views are available:
Operating limits
If the boot is heavily loaded, the vehicle may tilt,
affecting distance measurements.
In case of a gearbox failure, the system is not
active, when the reverse gear is engaged.
► Automatic zoom view.
► Standard view.
This is a normal behavior, which does not
request the support of a qualified workshop.
In this case, stop the vehicle and verify if the
front and/or rear sensors are covered by dirt,
mud, sand, snow, ice or anything preventing the
sensing.
► Panoramic view.
Malfunction
Depending on the context, the system chooses
the best view to display (standard or automatic
zoom).
The view type can be changed at any time
during the manoeuvre.
In case of display or speakers malfunction
(e.g. frozen image, black screen), the
system may be disturbed or unavailable.
The system is operational again after the
detection field has been cleaned.
The system status is not saved when the ignition
is switched off.
In the event of vehicle malfunction that
requires the vehicle to be stopped, the
system may be deactivated.
Visiopark 1
Operating principle
For more information, refer to the General
recommendations on the use of driving
and manoeuvring aids.
In the event of a temporary
malfunction (e.g. untimely triggering
due to external noise sources or
other interferences), this warning
lamp lights up on the instrument
panel, accompanied by the display
of a message and an audible signal
(short beep).
When reverse gear is engaged, with the engine
running, this system displays views of the
vehicle's close surroundings on the touch screen
using a camera located at the rear of the vehicle.
In the event of a permanent malfunction, this
warning lamp lights up on the instrument panel,
accompanied by the display of a message and
an audible signal (long beep).
Using the camera, the vehicle's close
surroundings are recorded during low speed
manoeuvres.
An image from above the vehicle in its close
surroundings is created in real time (on the side
of the screen), as the vehicle progresses.
This view makes it easier to align the vehicle
when parking and to perceive nearby obstacles.
It is automatically deleted if the vehicle remains
stationary for too long.
In the event of a malfunction,
this indicator lamp flashes
for approximately 10 seconds
when reverse gear is engaged.
The screen is divided into 4 parts with two side
menus, a contextual view and a view from above
the vehicle in its close surroundings.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
140
English 