Driving
Malfunction
Operating principle
Activation/Deactivation
When the system is not available
It is configured in the ADAS touch
(manual deactivation, temporarily
unavailability, sensors blocked,
failure), these symbols are displayed
permanently at the same time at the
left and the right, as long as the
conditions still fulfilled.
screen application.
The system's status is saved when the ignition is
switched off.
Operating limits
In the event of a malfunction when engaging
reverse gear, during reversing or when the driver
attempts to activate the system, a message
appears on the instrument panel, accompanied
by an audible signal.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
This message appears on the instrument panel
"Parking Assistance Sensor blind: Clean
sensor, see User Manual" if the sensor is
masked.
This is a normal behavior, which does not
request the support of a qualified workshop.
In this case, stop the vehicle and verify if
the corner radars, the reversing camera and/or
parking rear sensors are covered by dirt, mud,
sand, snow, ice or anything preventing the
sensing.
The system may not work in the following cases:
► Towing a trailer.
► Using a bicycle carrier on a towing device.
► Extreme temperature changes.
► Damaged rear bumper.
When an approaching obstacle is detected, the
symbol 1 or 2 flashes on the touch screen, in the
Parking sensors view or in the various contextual
views of the Visiopark 1 or Visiopark 3 functions
(depending on version).
► Accumulation or projection of external
elements (e.g. mud, frost, snow), stickers
application.
The symbol is complemented by an audible
signal when the vehicle is reversing.
It is possible that warnings are not given,
are given too late or seem unjustified.
Consequently, always stay in control of your
vehicle and be prepared to react at any time
to avoid an accident.
An obstacle is approaching in the
blind spot on the rear right-hand/
left-hand side or on both sides
of the vehicle.In the event of a
The system is operational again after the
detection field has been cleaned.
malfunction of these visual display
functions, the touch screen, or if
the driver deactivates the views of
these functions on the touch screen,
detection of an approaching obstacle
is still indicated by the audible signal
when the vehicle is reversing.
In the event of repairing or repainting
the rear bumper, consult the PEUGEOT
dealer or a qualified workshop; certain types
of paint could interfere with the operation of
the radars.
Multiple deactivation
It is possible to deactivate several driver
assistance functions simultaneously. This is
done in two steps:
► First of all, the selection of all the functions
that you want to deactivate.
► Secondly, the simultaneous deactivation of all
these functions.
144
English 