Ease of use and comfort -> Rear fittings for Your Peugeot 5008 SUV Second Generation (2017-2023)

Ease of use and comfort  
In "Permanent lighting" mode, the lighting time  
varies according to the circumstances:  
– With the ignition off, approximately 10 minutes.  
– In energy saving mode, approximately 30  
seconds.  
Connect only one device at a time to the  
socket (do not use extension leads or  
multi-socket adapters).  
Connect only devices with class II insulation  
(shown on the device).  
Rear fittings  
230 V/50 Hz socket  
– With the engine running, unlimited.  
Do not use metal-cased devices (e.g. electric  
shaver, etc.).  
When the front courtesy lamp is in the  
"Permanent lighting" position, the rear  
courtesy lamp also comes on, unless it is in  
the "Permanently off" position.  
To switch off the rear courtesy lamp, put it in  
the "Permanently off" position.  
As a safety measure, if power  
consumption is high and power is  
required by the vehicle's electrical system  
(due to severe weather conditions, electrical  
overload, etc.), power to the socket may be  
cut off, in which case the green indicator lamp  
goes off.  
Map reading lamps  
It is located at the back of the centre console  
beneath a protective cover.  
This socket (max. power: 150 W) operates with  
the engine running, and with the Stop & Start  
system in STOP mode.  
► With the ignition on, operate the  
corresponding switch.  
12 V accessory socket  
Take care not to place anything in  
contact with the courtesy lamps.  
► Lift the protective cover.  
► Check that the green indicator lamp is on.  
► Connect your multimedia or other electrical  
device (telephone charger, laptop computer,  
CD-DVD player, bottle warmer, etc.).  
In the event of a malfunction, the  
green indicator lamp flashes.  
Have the socket checked by a PEUGEOT dealer  
or a qualified workshop.  
Interior ambience lighting  
The dimmed passenger compartment lighting  
improves visibility in the vehicle when the light  
is poor.  
At night, the ambience lighting automatically  
comes on / switches off when the sidelamps are  
switched on / off.  
To connect a 12 V accessory (maximum  
power: 120 W), lift the cover and plug in a  
suitable adaptor.  
Activation / deactivation and adjustment  
of the light intensity are set via the  
Driving / Vehicle touch screen menu.  
70  
Ease of use and comfort  
The connection of an electrical device  
not approved by PEUGEOT, such as a  
USB charger, may adversely affect the  
operation of vehicle electrical systems,  
causing faults such as poor radio reception or  
interference with displays in the screens.  
Ski flap  
"Aircraft" type tables  
3
Mechanism for storing and transporting long  
objects.  
Opening  
Rear armrest  
► Lower the rear armrest.  
► Pull the flap handle downwards.  
To use the table, lower it fully until it locks in  
the low position.  
To store it, raise the table to the high position,  
passing the point of resistance.  
On the passenger side, do not forget to  
fold it before placing the backrest in the  
"table" position.  
For more information on the Front seats, and  
in particular placing the backrest in the "table"  
position, refer to the corresponding section.  
► Lower the flap.  
► Load the objects from inside the boot.  
The armrest incorporates two cup holders.  
Do not place hard or heavy objects on  
the table.  
They could become dangerous projectiles in  
the event of emergency braking or impact.  
71  
Ease of use and comfort  
Side blinds  
2. 12 V accessory socket (max. 120 W)  
3. Boot lamp  
4. Rear seat folding controls  
5. Hooks  
6. Stowing rings  
7. Adjustable boot floor (2-position)  
8. Storage well/Tool box under the floor  
9. Open storage compartments  
Depending on version, the storage boxes are  
fitted in the floor, at the foot of the side seats on  
the second row.  
On the left-hand side, it may also contain the  
temporary puncture repair kit.  
To open them, lift the cover by the notch.  
Boot fittings  
Fitted to the second row windows, they protect  
the passenger compartment from the sun's rays.  
► Pull the central tab to unroll the blind.  
► Position the blind's clip on the hook.  
Always guide the blind slowly, using the  
tab, while raising or lowering it.  
1. Load space cover roller  
2. 12 V accessory socket (max. 120 W)  
3. Boot lamp  
Storage boxes  
4. Luggage retaining strap  
5. Storage brackets of the load space cover  
roller  
6. Armrest with cup holder and storage  
compartment  
7. Open storage compartment  
1. Load space cover shelf  
72