Get Practical information -> Charging the traction battery (Rechargeable hybrid) Guide for Peugeot 5008 SUV Third Generation (2024-2025)

Practical information

Charging cable, mode 3 (AC)

When the vehicle is connected, the following

information is displayed on the instrument panel:

– Traction battery charge status (%).

Charging cable, mode 4 (DC)

(integrated into the fast public charger)

– Remaining range (miles or km).

– Estimated charging time (calculation may take

a few seconds).

– Charging speed (miles or km gained per hour).

After the instrument panel has been put into

standby mode, this information can be displayed

again by unlocking the vehicle or opening a door.

Identification label K on the charging connec-

tor (vehicle side).

Only use fast public chargers where the cable

length does not exceed 30 metres.

It is also possible to monitor the charging

progress using the MYPEUGEOT APP

application.

For more information on Remotely

operable additional functions, refer to the

corresponding section.

Charging the traction

battery (Rechargeable

hybrid)

Identification labels C on the charging connec-

tor (vehicle side) and on the socket (charger

side).

Lounge mode

Superfast charging, mode 4

Principle

When the vehicle is connected, it is

possible to switch on the ignition and use

certain functions such as the audio and

telematics system and the air conditioning

system for several hours.

Fast public charger

(superfast charging - direct current (DC))

For more information, refer to

the General recommendations on

electrified vehicles and the Specific

recommendations on rechargeable hybrid

or electric vehicles.

Low charging / Driving

Driving when the charge level of the

traction battery is too low can lead to the

vehicle breaking down and can lead to

accidents or serious injuries. ALWAYS make

sure the traction battery has a sufficient

charge level.

For a full charge, follow the charging procedure

without interrupting it, until it stops automatically.

Charging may be performed either immediately

(by default) or deferred.

Deferred charging is set via the

touch screen or the MYPEUGEOT

APP application.

182

Practical information

Precautions

After charging

Low charging / Parking

Check that the charging flap is closed.

Do not leave the cable connected to the

domestic power socket - risk of short-circuit

or electrocution in the event of contact with or

immersion in water!

If the outside temperature is negative, it

is recommended not to park your vehicle

outside for several hours at a low charging

(less than 20%).

Before charging

Depending on the context:

► Have a professional check that the

electrical system to be used complies with

applicable standards and is compatible

with the vehicle.

Vehicle in storage for more than 1

month

Deferred charging

In the event of a long period of non-use

of the vehicle (beyond 4 weeks) without

the possibility of charging when restarting,

the self-discharge may make it impossible

to restart if the traction battery charge level

is a low or very low, especially at negative

ambient temperatures. ALWAYS make sure

that the traction battery has a charge between

20% and 40% if you do not plan to use your

vehicle for several weeks.

► Have a professional electrician install

a dedicated domestic power socket

or accelerated charging unit (Wallbox)

compatible with the vehicle.

By default, the deferred charging start time is set

to be around midnight.

Depending on equipment, this time can be

changed.

Settings

Use the charging cable supplied with the

vehicle.

For more information, contact a PEUGEOT

dealer or a qualified workshop.

► In the Energy touch screen appli-

cation, select the Charging tab.

► Set the charging start time.

Do not connect the charging cable.

Always park the vehicle in a place with

temperatures between -10°C and 30°C

(parking in a place with extreme temperatures

can damage the traction battery).

Refer to the 12 V battery/Accessory

batteries section for the battery

disconnection procedure.

During charging

► Press OK to confirm.

While charging is in progress, unlocking

the vehicle will cause the charging to stop.

If no action is taken on one of the openings

(door or boot) or on the charging nozzle, the

vehicle will lock again after 30 seconds and

charging will resume automatically.

Never work under the bonnet:

The setting is saved in the system.

You can also programme the defer-

red charging function using a smart-

phone, via the MYPEUGEOT APP

application.

For more information on Remotely operable

additional functions, refer to the corresponding

section.

– Some areas remain very hot, even an hour

after charging ends - risk of burns! – The

fan may start at any time - risk of cuts or

strangulation!

Activation

► After programming the deferred charging,

connect the vehicle to the desired charging

equipment.

183

Practical information

► Remove the protective cover from the

charging nozzle.

Disconnection

► Insert the nozzle into the vehicle's charging

connector.

The start of charging is confirmed by the flashing

of the green charging indicator lamp in the flap

and the flashing of the CHARGE indicator lamp

in green on the control unit.

If this is not the case, charging has not started;

restart the procedure, ensuring that all of the

connections are properly established.

Press this button in the charging flap within

one minute to activate the deferred charging

(confirmed by the charging indicator lamp

coming on in blue).

►

Before disconnecting the nozzle from the

charging connector:

► If the vehicle is locked, unlock it.

► If the vehicle is unlocked, lock it and then

Charging procedure

unlock it.

The red indicator lamp in the flap comes on to

indicate that the nozzle is locked.

Connection

If selective unlocking of the doors is

activated, press the unlocking button on

the remote control twice to disconnect the

nozzle.

Accelerated charging (mode 3)

► Before charging, check that the gear selector

is in mode P and the ignition is off, otherwise

charging is impossible.

► Press on the rear of the charging flap to open

it and check that there are no foreign bodies

on the vehicle's charging connector.

The red indicator lamp in the charging flap goes

out to confirm that the nozzle is unlocked.

The charging indicator lamp in the charging flap

comes on white.

► Within 30 seconds, remove the charging

► Follow the accelerated charging unit

(Wallbox) user instructions.

nozzle.

Domestic charging (mode 2)

► Remove the protective cover from the

charging nozzle.

The end of charging is confirmed when the

green CHARGE indicator lamp on the control

unit comes on fixed and the green charging

indicator lamp in the flap comes on fixed.

► Insert the nozzle into the vehicle's charging

connector.

The start of charging is confirmed by the flashing

of the green charging indicator lamp in the flap.

If this is not the case, charging has not

started; restart the procedure ensuring that all

connections are properly established.

► After disconnection, replace the protective

cover over the nozzle and close the charging

flap.

► First, connect the charging cable from the

control unit to the domestic socket.

► Disconnect the control unit's charging cable

from the domestic socket.

When the connection is made, all of the indicator

lamps on the control unit light up, then only the

POWER indicator lamp remains on in green.

The red indicator lamp in the flap comes on to

indicate that the nozzle is locked.

184

Download User Manual App

Practical information -> Charging the traction battery (Rechargeable hybrid) for Your Peugeot 5008 SUV Third Generation (2024-2025)

Related Topics

Practical information

Popular Owner Manuals

Latest Owner Manuals