Wheels › Wheel bolt cover caps 231
Troubleshooting
Full wheel frame
Tyre pressure display faulty
Removing and installing the trim
flashes for about 1 minute and stays on
Applies to factory built or original accessory trims from ŠKODA.
Stop the car, turn the ignition off and on again.
›
Disconnecting
If the symbol flashes again after turning on ignition, there is
a system fault.
Hang the clamps for removing the wheel trims at the edge of
one of the openings in the trim.
›
Continue driving, exercising appropriate caution, and seek the
help of a specialist garage.
›
Push the wheel wrench through the clamp, support on the tyre
and pull off the wheel trim.
›
Installing
Press the wheel trim onto the wheel rim at the designated
valve opening.
›
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
When using an anti-theft wheel bolt, it must be located at the
location indicated on the bezel.
Press the trim, starting at the valve, into the rim on both sides
›
Push the pull-off clamp onto the
›
until it engages around the entire circumference.
cover cap up to the stop.
NOTICE
Remove the cover cap.
›
Use hand pressure, do not hit the wheel cover.
▶
Installing
Push the cover cap onto the wheel bolt to the stop.
›
English 
